GiGabit
EthErnEt
DEsktop
switch
usEr
manual
Models 524117
& 524124
INT-524117/524124-UM-0408-02
Thank you for purchasing the INTELLINET NETWORK SOLUTIONS™
Gigabit Ethernet Desktop Switch, Model 524117 (5-port) or Model
524124 (8-port).
Providing your network with the high level of performance it needs to
handle quick transfer speeds to support disk mirroring, data backup,
graphics image file transfers and other bandwidth-intensive applications,
this handy device also utilizes broadcast storm control and the store and
forward switching method to ensure that your connections remain active
even under extremely busy conditions.
Easy-to-follow instructions in this user manual help make installation
of the switch quick and simple, so you’ll also soon be enjoying the
benefits of these additional features:
• 10/100/1000 Mbps auto-sensing Auto MDI-X ports automatically detect
optimal network speeds
• High performance, half and full duplex, with zero packet loss
• Full flow control support provides optimum performance
• Auto-learning of network configuration
• Supports up to 4,096 MAC address entries (Model 524124)
• Supports jumbo frames up to 4.6 kBytes (Model 524124)
• Non-blocking wire-speed forwarding and filtering
• Lifetime Warranty
FCC Warning
This device has been tested and found to comply with limits for a Class B
digital device, pursuant to Part 2 and 15 of FCC Rules. These limits are
designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates and radiates radio frequency energy and, if not
installed and used in accordance with the user’s manual, may cause
interference, in which case the user will be required to correct the
interference at his own expense.
CE Warning
This is a Class B product. In a domestic environment, this product may
cause radio interference, in which case the user may be required to take
adequate measures.
3
front panEl
The front-panel LED indicators — POWER, Link/Act and 100/1000Mbps
— allow for more convenient monitoring and troubleshooting of the
switch. The table below shows each LED function.
LED
Status
Steady green Power on
Off Check AC connection; turn the
power on
Operation
POWER
LINK/ACT
Steady green Valid port connection
Blinking green Valid port connection; data being
transmitted/received
Off
No link established
Low-speed transmission
Higher-speed transmission
100/1000Mbps Off
On
rEar panEl
All ports on the Gigabit Ethernet Desktop Switch support Auto-MDI/
MDI-X functionality, so crossover cables and uplink ports aren’t needed
for connections to PCs, routers, hubs, additional switches or other
devices.
4
installation
Cat5/5e UTP/STP cables provide optimal performance; just make your
connections between the Gigabit Ethernet Desktop Switch and your
network devices. If a front-panel LED corresponding to any of the five
or eight ports in use doesn’t indicate a link or activity, check the connected
device for proper setup and operation.
Plug the female end of the power adapter firmly into the receptacle on
the rear panel and the other end into an electrical outlet. Confirm that
the power LED is lit for a normal power status. NOTE: To ensure proper
operation, use only the power adapter included with the switch.
Prior to use, it is recommended that the device be placed/positioned:
• on a level surface that can support the weight of the switch (and any
other items that need to be considered);
• away from sources of electrical noise, such as transmitters, radios and
broadband amplifiers;
• with a minimum of 25 mm of
clearance on the top and
sides for ventilation; and
• where it cannot be affected
by excessive moisture.
Broadband Router
Gigabit Ethernet
Desktop Switch
Sample configuration
5
spEcifications
Standards
• IEEE 802.3 (10Base-T Ethernet)
• IEEE 802.3u (100Base-TX Fast Ethernet)
• IEEE 802.3ab (Gigabit Ethernet)
• IEEE 802.3x (Flow Control and Backpressure)
General
• ANSI/IEEE 802.3 NWay auto-negotiation
• Non-blocking, store and forward switching architecture
• Backpressure flow control for half duplex mode on 10/100 Mbps ports
• Connectors:
- Model 524117: 5 10/100/1000 Mbps RJ45 ports
- Model 524124: 8 10/100/1000 Mbps RJ45 ports
• Switch architecture: store and forward switch technology
• Network cables:
- 10Base-T: Cat3, 4, 5 UTP/STP
- 100Base-TX: Cat5 UTP/STP
- 1000Base-T: Cat5e UTP/STP
• Certifications: FCC Class B, CE
Performance
• Filter/forward rate
- 10BaseT: 14,880 pps (packets per second)
- 100Base-TX: 148,800 pps (packets per second)
- 1000Base-T: 1,480,000 pps (packets per second)
• MAC address table:
- Model 524117: 1,024 entries
- Model 524124: 4,096 entries
• Jumbo frame support: 9.7 kB
LEDs
• Power
• LINK/ACT
• 100/1000 Mbps
6
Power
• DC input: 5 V, 2 A
Environmental
• Plastic housing, desktop size
• Dimensions: 109 (W) x 160 (L) x 33 (H) mm (5.5 x 6.3 x 1.3 in.)
• Weight: 0.64 kg (1.4 lbs.)
• Operating temperature: 0 – 40°C (32 – 104°F)
• Operating humidity: 10 – 90% RH, non-condensing
Package Contents
• Gigabit Ethernet Desktop Switch
• External power adapter
• User manual
7
INTellINeT NeTWoRK solUTIoNs™ offers a complete line
of active and passive networking products.
Ask your local computer dealer for more information or visit
www.intellinet-network.com.
Copyright © INTELLINET NETWORK SOLUTIONS
All products mentioned are trademarks or registered trademarks of their respective owners.
|