INSTALLATION INSTRUCTIONS
VR910M/VR914M VANDAL RESISTANT TRIM
FOR USE WITH MORTISE DEVICES
PREPARE PUSH SIDE OF DOOR FOR EXIT
DEVICE. SEE EXIT DEVICE INSTRUCTIONS
FOR PREPARATION.
INSTALL MORTISE LOCK. SEE MORTISE LOCK
INSTRUCTIONS.
1
2
3
4
INSTALL EXIT DEVICE AND TRIM.
PREPARE PULL SIDE OF DOOR FOR TRIM.
VR910M/VR914M
TRIM
A
TRANSFER VERTICAL AND HORIZONTAL
DEVICE CENTER LINES FROM PUSH SIDE
OF DOOR TO PULL SIDE.
B
LOCATE AND PREPARE ALL HOLES AS
INDICATED BELOW.
OUTSIDE FACE RHR SHOWN
OF LOCK STILE LHR OPPOSITE
SCREWS (4):
10-24 X 1”
PPHMS SCREWS
(1-3/4” DOORS)
RHR
10-24 X 1-1/2”
PPHMS SCREWS
(2-1/4” DOORS)
SHOWN
1-3/8”
LHR
11/16”
OPPOSITE
1-5/8” DIAMETER
HOLE (TRIM SIDE
OF DOOR) FOR
INSTALL CYLINDER, IF USING.
5
3-1/2”
CYLINDERS ONLY
SET SCREW: REMOVE FROM CYLINDER
SIDE UNTIL CYLINDER IS SCREWED INTO
PLACE, THEN REINSTALL SCREW
2-1/4”
DEVICE & TRIM
HORIZONTAL
7”
C
L
CYLINDER COLLAR
USE WAVE WASHERS
INSIDE CYLINDER
COLLAR AS NEEDED
FOR PROPER FIT
3-1/2”
KEYHOLE
POSITION
WHEN INSTALLED
13/32” DIAMETER HOLES,
4 PLACES (TRIM SIDE)
1/4” DIAMETER HOLES,
4 PLACES (OPPOSITE SIDE)
829560_00(2) Copyright © 2003 Ingersoll-Rand. All rights reserved.
|