®
Stealthbox
I N S T A L L A T I O N G U I D E
START
HERE
for the
SB-D-TRKEXT/10W1
(Dodge Ram
STEP 1: Slide the front seats all the way for-
ward and fold-up the rear bench seat.
➔
‘94-’01 1500 Club Cab,
‘98-’01 1500 Quad Cab,
‘94-’02 2500 Club Cab,
‘98-’02 2500 Quad Cab,
‘95-’02 3500 Club Cab,
‘98-’02 3500 Quad Cab)
➔
STEP 2: Under the rear bench seat, there are
a pair of metal brackets which hold the tire
changing tools. Bend these up and back so
they are out of the way of then enclosure.
This Stealthbox is a product which
requires professional installation skills and
tools.
Please read this installation guide thor-
oughly before beginning the project. It
will guide you step by step through the
installation. Several of the steps in this
process may require two people to
accomplish.
➔
➔
It is absolutely vital that the enclosure
be properly mounted to the vehicle
according to these instructions. Failure
to mount the enclosure properly pres-
ents two problems: 1)The sub-bass
performance will suffer due to the
movement of the enclosure caused by
the force exerted by the woofer(s) and
2) A loose enclosure presents a serious
safety hazard in the event of a collision
or sudden deceleration.
STEP 4: Place the other supplied wax square
to this location. (remove paper, sticky side
down).
STEP 3: Place one of the two supplied wax
squares to this location(remove paper, sticky
side down).
The rear edge needs to be 5-1/2” from the
back of the cab.The inside of the wax square
needs to be 5-1/2” from the outside edge of
the carpet.
The outside edge of the wax square needs to
be flush with the jack storage compartment.
The rear edge needs to be 5-1/2” from the
ledge at the back of the cab floor.
Please enjoy your JL Audio Stealthbox
responsibly.
Continued on Next Page ➔
SB-D-TRKEXT/10W1, JL AUDIO, Inc 2004
Page 1
Sheet SKU#011105 Revision6/28/2004
Cont.
From
Previous
Page
THREADED INSERT
STEALTHBOX WALL
STEP 10: Place the enclosure back into the
mounting location Line up and guide the two socket
cup set screws through the drilled holes from
STEP 8.
CONGRATULATIONS!
INSTALL COMPLETE.
➔
➔
➔
➔
VEHICLE SHEET METAL
SOCKET CUP SET SCREW
FENDER WASHER
FLAT WASHER
LOCK WASHER
HEX NUT
Included Hardware:
(2) 3/8”-16 X 2-1/4” Socket Set Screw
(2) 3/8” Fender Washers
(2) 3/8” Flat Washer
(2) 3/8” Lock Washer
(2) 3/8’-16 Hex Nut
STEP 9: Double check the woofers for proper
functioning.
STEP 11: With the supplied hardware, place as in
order of direction.
Run speaker wire to the enclosures mounting loca-
tion and secure it to the wire terminal on the enclo-
sure.
Place the fender washer, flat washer, lock washer and
then hex nut onto the protruding socket cup set
screws.
Adjust the socket cup set screws for more or less
threads that are needed. Hand tighten the nuts, till
both mounting assemblies are on.
Tighten securely.
Difficulty Of Installation:
Mid/High Frequency Driver Information:
Specifications:
Enclosure Type: Acoustic Suspension (Sealed)
Driver Type: (2)10W1-8
Nominal Impedance: 4Ω
Cont. Power Handling: 250Watts
Front Location Driver Size:
6”x9”
Applicable JL Audio Products:
N/A
JLAudio recommends using a high quality amplifier such as the JLAudio 250/1. The diagram below shows the recommended
crossover, infrasonic filter and equalizer settings for the 250/1 when being used to power your Stealthbox®.
Rear Location Driver Size:
5.25”
+12VDC
Ground Remote
Preamp Output Section
Output Mode
Bass Control
Infrasonic Filter
Amp LP Filter
Mode/Slope
Amplifier Input Section
XR525-CXi
Input Voltage
Input Sens. Signal Sensing
Applicable JL Audio Products:
TR,VR,XR525-CXi
Full-Range/Low-Pass/High-Pass
Off/30Hz
+7
Off/12dB/24dB
Low/High
Off/On
+3
+1
+10
+13
JL AUDIO 250/1
monoblock subwoofer amplifier
Left Ch.
Right Ch.
LF Boost (dB) Filter Freq. (Hz)
Left Ch.
Right Ch.
The JL Audio 250/1 is a very versatile audio component. Please consult the owner’s manual for detailed information
about installing and tuning this amplifier.
10369 N. Commerce Pkwy, Miramar, Florida 33025-392
Phone: 954.443.1100
Fax: 954.443.1111
SB-D-TRKEXT/10W1, JL AUDIO, Inc 2004
Page 3
Sheet SKU#011105 Revision6/28/2004
|