JVC Portable CD Player RC BX75VSL User Manual

FIRST THINGS  
USING THE RADIO  
BEFORE USING THE CD/VCD PLAYER  
This portable system operates on battery or AC power.  
The display and the remote control unit are effective only for the CD/VCD player. The detailed operations  
for the normal CDs (audio CDs and MP3 CDs) and the video CDs are separately explained in USING  
THE CD PLAYERand USING THE VCD PLAYER.  
TUNING IN RADIO STATIONS  
CD PORTABLE SYSTEM  
Move the FUNCTION switch to RADIO to turn the radio on.  
Set BAND to FM, SW or MW.  
Tune in desired station by turning the TUNING dial.  
In SW reception, you can finely tune in desired station by turning the FINE TUNE knob on the right side  
of the unit.  
SETTING THE VOLTAGE SELECTOR  
RC-BX75VSL/RC-BX75VWT  
To avoid damaging the unit, select the voltage range before plugging the power cord into the unit. Open  
the battery compartment cover on the back of the unit by pressing down the two tabs and pulling out the  
cover. Select the voltage range for your area with the VOLTAGE SELECTOR inside the battery compart-  
ment by using a screwdriver or similar.  
UNITS BUTTONS  
RANDOM DISPLAY  
To turn off the radio, move FUNCTION switch to  
TAPE.  
CD OPEN 0  
REPEAT  
AC power jack  
HANDLING ANTENNAS FOR BETTER RECEPTION  
Antenna  
110V-127V  
The MW antenna is built in, so adjusting the position of the unit may help MW reception. The FM/SW rod  
antenna on the back of the unit can be extended and rotated for better FM/SW reception.  
220V-230V  
VOLTAGE SELECTOR  
PLAY/PAUSE 6  
USING THE TAPE DECK  
PROG.  
SKIP/SEARCH  
RM-SRCBX75VWT REMOTE CONTROL  
STOP 7  
4, ¢  
| Forward direction  
NTSC  
PAL  
REMOTE CONTROLS BUTTONS  
For Customer Use :  
NTSC/PAL SWITCH  
R20/D (13F)  
Enter below the Model No. and Serial No.  
which are located either on the rear, bottom  
or side of the player. Retain this information  
for future reference.  
Battery Compartment  
RETURN  
PBC  
PBC  
RETURN  
VIEW  
VIEW  
Model No.  
Serial No.  
SETTING THE TV SYSTEM SELECTOR  
RANDOM  
OSD  
OSD  
RANDOM  
RESUME  
RESUME  
INSTRUCTIONS  
L/R  
SLOW  
Open the battery compartment cover and set the TV system selector to PAL or NTSC according to the TV  
system you use.  
SLOW  
L /R  
2
GOTO  
REC Press to record from the radio or CD/VCD player.  
PLAY 2 Press to play the cassette tape.  
REW ¡ From stop or play mode, press to rewind the tape toward the beginning.  
FF 1 From stop or play mode, press to advance the tape toward the end.  
STOP/EJECT 7 0 Press to stop the cassette tape, or to open the cassette compartment door when no  
buttons are pressed down.  
GO TO  
LVT0933-001B [U]  
88-00075-00  
1
4
7
0
3
6
9
5
NUMBER BUTTONS (0-9, +10)  
INSERTING BATTERIES (NOT SUPPLIED)  
8
Insert 6 batteries R20/D (13F) and you can take your system just about anywhere. Open the battery  
compartment cover and insert batteries as shown.  
+10  
A
-
B
PROG  
REPEAT  
PLAY  
REPEAT  
PAUSE 8 Press to interrupt playback or recording. Pressing it again will resume playback or recording.  
PROG.  
REPEAT  
A-B REPEAT  
PLAY 6  
ALBUM + ∑  
ALBUM  
-
ALBUM  
TITLE  
+
Note: The battery power will be switched off when you plugged the power cord into the AC  
power jack on the unit.  
ALBUM w  
STOP 7  
PLAYING A CASSETTE TAPE  
TITLE  
-
STOP  
+
CAUTION!  
TITLE 4  
TITLE + ¢  
THIS PRODUCT UTILIZES A LASER.  
USE OF CONTROLS OR ADJUST-  
MENTS OR PERFORMANCE OF PRO-  
CEDURES OTHER THAN THOSE  
SPECIFIED HEREIN MAY RESULT IN  
1. Move the FUNCTION switch to  
TAPE.  
Inserting Batteries into the Remote Control Unit:  
Match the polarity (+ and ) of the batteries.  
CLASS  
1
2. Press STOP/EJECT 7 0 to open the cassette compartment door.  
3. Insert a cassette tape into the compartment with the open edge facing up. Tape travels from the right  
to the left.  
LASER PRODUCT  
R03 (UM-4)/AAA (24F)  
4. Close the door securely.  
HAZARDOUS  
SURE.  
RADIATION  
EXPO-  
5. Press REW ¡ or FF 1 to move the tape to the desired starting point, if necessary.  
6. Press PLAY 2 to start playing the tape. The cassette tape plays until it reaches the end of the side,  
then it automatically stops.  
RM-SRCBX75VWT REMOTE CONTROL  
1. CLASS 1 LASER PRODUCT  
2. DANGER: Invisible laser radiation when  
open and interlock failed or defeated.  
Avoid direct exposure to beam.  
3. CAUTION: Do not open the top cover.  
There are no user serviceable parts in-  
side the Unit; leave all servicing to quali-  
fied service personnel.  
RECORDING ON A CASSETTE TAPE  
You can record from the radio or the CD/VCD player. For best recording, use the type I tape (normal bias  
tape).  
THINGS TO KNOW BEFORE PLAYING CDs  
It may be unlawful to record or play back copyrighted material without the consent of the copyright  
Playable CDs:  
owner.  
Only CDs bearing these marks can be used with this system.  
ERASE PROTECTION  
CAUTION:  
To avoid battery leakage or explosion, handle batteries properly.  
If youre not going to use your system for a month or more, remove the batteries from the battery  
compartment.  
Dispose of batteries in the proper manner, according to federal, state, and local regulations.  
Do not mix with different battery types or with new and old ones, or do not attempt to charge a  
battery not intended to be recharged.  
When you record on new material, the cassette deck records over whatever is on a tape.To protect a tape  
from accidental erasure, break off one or both plastic tabs (one for each tape side) on the top of the  
cassette tape. If you decide later to record on the tape, seal the hole with a piece of cellophane tape.  
WARNING LABEL,  
PLACED INSIDE  
THE UNIT  
Recordable  
ReWritable  
On MP3 CD Format:  
Discard leaky batteries immediately. Leaking batteries can cause skin burns or other personal  
injury.  
Disc format should be set to ISO 9660.  
Multisession recording is not supported.  
The disc must be finalized.  
PRECAUTIONS  
Never open the cabinet under any circumstances. Never operate this product with the cabinet re-  
moved. Any repairs of internal adjustments should be made only by a trained service technician.  
Do not touch the system with wet hands. If any liquid enters the cabinet, take the system to a trained  
service technician for inspection.  
Hole  
Tape  
Files other than MP3 (.MP3) are ignored.  
Tabs  
SUPPLYING AC POWER  
Button Expression:  
Plug the power cord into the AC power jack on the back of the unit, and into an AC power outlet.  
Note: To switch off the system completely, unplug the power cord.  
Description of the units buttons is omitted since it is the same as that of the remote control units buttons  
except the following buttons:  
Track selection:  
Remote control w/∑  
Search Play:  
Remote control 4/¢  
CAUTION:  
A little bit of slack in your tapes can cause scratches on the tape, or worse yet, the  
tape could break. If you notice some slack in the tape use a pencil to tighten it up  
before you insert in.  
Unit SKIP/SEARCH 4/¢  
WARNING:  
Unit Pressing & holding SKIP/SEARCH 4/¢  
TO REDUCE THE RISK OF FIRE OR ELECTRIC  
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO  
RAIN OR MOISTURE.  
When any unacceptable button operation is made, Err (Error)will appear on the display.  
RECORDING FROM THE RADIO  
Using the Number Buttons:  
To specify the track number, press the number buttons as follows:  
For track number 5, press 5.  
For track number 10, press +10 and then 0.  
For track number 25, press +10 twice and then 5.  
1. Insert a blank cassette tape.  
2. Move the FUNCTION switch to RADIO and tune in desired station.  
3. Press REC to start recording. REC and PLAY 2 lock down.  
4. Press STOP/EJECT 7 0 to end recording.  
CONNECTING TO TV  
Connect the system to your TV or VCRs video/audio inputs to enjoy video images recorded on a VCD.  
5. To turn off the radio, slide the FUNCTION switch to  
TAPE.  
Yellow  
LOADING A CD  
SUPPLIED ACCESSORIES  
Audio/Video cord  
SYNCHRO RECORDING FROM CDs  
1. Move the FUNCTION switch to CD/VCD. NO DISCappears if no CD is loaded.  
2. Press CD OPEN 0 to open the CD door.  
3. Place a CD into the tray with the label facing up.  
4. Close the CD door. READINGappears for a few seconds.  
For audio CD/VCD: The total number of tracks and the playing time of the disc appear. For video CD,  
VCDand VCD version (2.0) indicators will light on the display.  
Remote control unit ..... 1 pc.  
Power cord* ................ 1 pc.  
Audio/Video cord* ....... 1 pc.  
* Accommodated in the battery compartment.  
1. Move the FUNCTION switch to CD/VCD.  
2. Insert a blank cassette tape.  
3. Insert the CD you want to record. If you need, program the CD tracks.  
• When you record from video CD with PBC, press PBC on the remote control unit to turn off “PBC”  
indicator on the display (PBC OFF). Then, press STOP 7 to stop the video CD.  
4. Press REC .  
to TV  
Red  
Thank you for purchasing this JVC product. Please read the instructions carefully before starting operation  
to be sure to obtain optimum performance and a longer service life from the system.  
White  
The CD is automatically played and recorded onto the tape.  
5. To stop at any position during recording, press STOP/EJECT 7 0.  
CONNECTING HEADPHONES (NOT SUPPLIED)  
Connect headphones to the 3.5mm stereo headphone socket at the left side of the unit.  
To Record from the Desired Track:  
In step 4 above, skip the CD track with the SKIP/SEARCH 4, ¢ on the unit, or the  
w, or the number buttons on the remote control unit, and then immediately press REC .  
PHONES  
Note: About 5 seconds after the TRACK selection, the display returns to the TOC display.  
For MP3 CD:  
The total album number and the total track number of the disc briefly appears,  
and then changes to the first album and track numbers. Also, the MP3indicator  
appears on the display.  
TIPS:  
5. To remove the CD, press CD OPEN 0, grasp the CD by its edges, and carefully take it off.  
To temporarily pause the recording, press PAUSE 8 on the cassette deck. Press PAUSE 8 again  
to resume recording. Note that using STOP/EJECT 7 0 instead of PAUSE 8 for this purpose is  
not recommended as the recorded sound may be distorted.  
GENERAL CONTROLS  
Note: When operating an MP3 CD, it may take time until the CD responds to the button com-  
mand.  
FUNCTION Switch Move the switch to select the system function - RADIO, TAPE or CD/VCD.  
VOLUME Turn the volume knob to increase or decrease the volume level.  
S-BASS Turn on S-BASS by pressing button down for enhanced bass effect. Turn off S-BASS (up  
position) for normal bass sound.  
When the unit is connected to the TV, the disc information on MP3 appears on the TV.  
POWER OFF (standby) Move the FUNCTION switch to  
TAPE position. Be sure no cassette buttons  
are pressed down.  
 

Indesit Range KD3G User Manual
Intel Personal Computer PC 8153 User Manual
Jettech Metal Products Dishwasher F18 User Manual
JVC DVR SR DVM700U User Manual
JVC Flat Panel Television 5030057088 User Manual
Jwin DVD Player JD VD768 User Manual
Kenwood GPS Receiver DNX9210BT User Manual
Kenwood Stereo Receiver KRF V4530D User Manual
King Canada Drill KC 40HS User Manual
Kodak Printer DryView 8900 User Manual