JVC Security Camera VN V686U User Manual

IT Settings  
Frame Size  
Connect to the Camera  
Top Page  
1
3
Choose the desired frame size.  
JPEG Settings  
VN-V686WPU  
Choose the compression rate from VFS1 – VFS7, or select AFS  
and specify the Jpeg average file size in KByte.  
Approximate file size for each compression rates are as follows.  
Click [Go]  
VN-V686U  
Enter the Password  
2
Click on [Network], followed by [Basic] on the next  
submenu.  
MPEG-4 Settings  
Specify the desired MPEG-4 bitrate.  
Change the IP address  
4
Change CBR/VBR, FPS, I Frame Interval and Priority when  
necessary.  
Click on the menu [Network] – [Basic] to show setting page.  
Launching Viewer  
6
[Note for MPEG-4 Viewing]  
User name: admin  
Download the “ffdshow” from the Internet and install before  
viewing MPEG-4 image with the built-in MPEG-4 viewer.  
Password: vn-v686 (by default)  
The “ffdshow” is a open source CODEC and found at various  
Internet sites like  
(as of may.2008)  
Basic Trouble Shooting  
After selecting [DHCP Disable], enter the  
specified value in each fields.  
When some ERROR happens…  
QUICK  
SETUP  
GUIDE  
Solution 1 If DHCP server exists on the network, IP address  
other than 192.168.0.2 may be assigned to the camera. Ask  
currently assigned IP address for the network administrator or  
try to connect again in peer-to-peer environment.  
Press OK and wait for 1 minute while rebooting.  
Change also IP address of the PC to re-connect the camera.  
Solution 2 With no DHCP Server, the IP address of the camera  
should be 192.168.0.2 by default. Change also the PC IP  
address so that the camera and PC are on the logically same  
subnet.  
Encoding settings  
5
Click on the menu [Image] – [Encoding] to show setting page.  
Solution 3 Change the IE settings not to use the proxy server  
for the camera IP address. Also set http://192.168.0.2/ as an IE  
trusted site and change the IE setting to allow Active  
Scripting.  
Frame Size  
Finish  
7
Solution 4 If you have already setup another camera which  
was originally the same IP address with the camera this time,  
PC may still recognize that the corresponding MAC address to  
this IP is the previous one. Launch the command prompt and  
type “arp –a” to confirm all IP and corresponding MAC  
address entries. To delete all entry, type “arp –d”.  
JPEG Settings  
MPEG-4 Settings  
According to your system operation policy, set the necessary  
settings like  
Preset Position  
Alarm  
Privacy Mask  
Note Ping command could be a good solution in any  
 
and so on.  
situation.  

Intel Computer Hardware 80C186EA User Manual
Intel Laptop WalkAbout Computer User Manual
Inter Tel PDAs Smartphones 8601 User Manual
ION Conference Phone Call Center User Manual
JVC Answering Machine KD LX111R User Manual
Kenwood Home Theater System HM 331 User Manual
KitchenAid Refrigerator NL240V User Manual
KitchenAid Toaster KMT222 User Manual
KitchenAid Washer Dryer 8578194 User Manual
Korg Musical Instrument Ax3000g User Manual