HEAVY DUTY
MECHANICAL
TIME SWITCH
15306 24 HOUR TIME SWITCH
•
SWITCH:
CONTACT RATINGS:
SPST
40 AMP 120-277VAC
1000VA (120-277) PILOT DUTY
40 AMP TUNGSTEN 120VAC 120-277VAC SINGLE PHASE
20 AMP INDUCTIVE
2HP 120VAC; 5HP 240VAC
TIMING MOTOR:
120VAC 60Hz
M
POWER CONSUMPTION: 3 WATTS MAX
2
L
1
X
For seperate motor terminals, remove
bridge from terminals L & 1
H
N
LOAD
Removable
Bridge
FOR 120 VAC
120VAC/60Hz
We recommend that installation be made by a licensed electrician.
Disconnect power at main panel prior to installing or servicing this
time switch or the equipment connected to it.
Connect in accordance with national and local electrical codes.
Supply Connections: Use gauge specified (AWG #8-14 ) suitable for 75ºC
(167ºF).
Replace insulator before turning on electricity to unit.
INSTALLATION AND OPERATING INSTRUCTIONS TO SET ON AND
OFF TIMES: Light trippers turn ON.
Dial Calibrations
Dark trippers turn OFF. Place tripper on
dial edge as shown in figure and set
Knurled Screw
point of each tripper to desired oper-
OFF TIME
(Dark Tripper)
ON TIME
(Light Tripper)
ating time. Note if selected time is AM
or PM. Hold tripper against dial edge
and firmly tighten knurled screw.
MANUAL
OFF
LEVER
MANUAL
ON
LEVER
O
F
F
O
N
INSTALLATION AND OPERATING INSTRUCTIONS
TO SET DIAL TO TIME:
Turn dial counter-clockwise until correct time is indicated by
arrow on nameplate.
FOR TEMPORARY MANUAL OVERRIDE:
Press down lever on right of nameplate to turn ON. Press down
lever on left of nameplate to turn OFF. CAUTION: Do not rotate
dial for manual override.
TO REMOVE MECHANISM FROM CASE:
Press lever near case latch to release mainplate and swing the
movement out. To replace, insert mainplate projections in slots
opposite latch and swing movement in until it latches.
469D
15306
MANUAL VERSION 1
12/15/09
WWW.JASCOPRODUCTS.COM
GE5360-41K2
|