JaguarTurboTwister
BaglessVacuum Cleaner
KBV50T
Issue 1/07
KBV50T.indd
1
2/8/07 9:34:36 AM
vacuum up acids, asbestos or asbestos
dust.
KamBrooK SafeTy
feaTureS of your KamBrooK Jaguar
TurBo TwISTer BagleSS Vacuum cleaner
read all InSTrucTIonS
Before operaTIng
and SaVe for fuTure
reference
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they are given supervision or instruction
concerning use of the appliance by a
person responsible for their safety.
3
2
1
Welcome to Kambrook and your new
Jaguar Turbo Twister Bagless Vacuum
Cleaner.
At Kambrook we believe that the safe
performance of our products is the first
priority in any consumer product so that
you, our valued customer, can confidently
use and trust our products.
Do not leave the vacuum cleaner
unattended when in use. Children should
be supervised to ensure that they do not
play with the vacuum cleaner.
Close supervision is required at all times
when operating the vacuum cleaner near
children.
We ask that any electrical appliance that
you use be operated in a sensible fashion
with due care and attention placed on the
following important operating instructions:
This vacuum cleaner is suitable for
domestic use only. Do not use this
vacuum cleaner for anything other than its
intended use.
Read all instructions thoroughly before
activating the appliance and retain them
for future reference.
4
Do not use or store outdoors.
Ensure that the power source to be used
is the same as the voltage requirements of
the product.
7
5
Fully extend the cord (to the red tape
mark) whenever the vacuum cleaner is in
use.
Always switch vacuum cleaner to off, then
switch off at the power outlet, then unplug
the vacuum cleaner when not in use and
prior to cleaning the dust container or
filters.
The installation of a residual current
device (safety switch) is recommended to
provide additional safety protection when
using electrical appliances. It is advisable
that a safety switch with a rated residual
operating current not exceeding 30mA be
installed in the electrical circuit supplying
the appliance. See your electrician for
professional advice.
8
6
Never use the vacuum cleaner without a
dust container and motor protection filter
in place.
1. Bagless canister for easy removal
of dirt and dust with no need for
replacement bags
5. Quality multi-terrain floor tool ideal for
carpet and hard floors
Never use the vacuum cleaner to vacuum
hot ashes, broken glass, sharp objects or
liquids.
6. Crevice and brush tools ideal for
picking up dust from hard to
reach places
2. Horizontal parking for easy and
convenient storage
Regularly inspect the supply cord, plug
and actual appliance for any damage. If
found damaged in any way, immediately
cease use of the appliance and return the
entire appliance to the nearest authorised
Kambrook service centre for examination,
and/or repair.
3. Powerful 1800 watt motor for superior 7. Multi-bristled turbo brush designed
Never use in the presence of explosive
liquids or vapours.
suction and fast and effective cleaning
to rotate at high speed to dislodge dust
and dirt particles trapped deep within
the carpet pile
4. 6 stage HEPA filtration system filters
dust particles including mites, pollen,
fungus, spores and most air suspended
particles at 98% efficiency. Ideal for
allergy sufferers
Never vacuum up inflammable or
poisonous liquids such as petrol, copier
toner or other volatile substances. Never
8. Telescopic chrome steel wand is easily
extendable or retractable for varying
height requirements
ꢀ
ꢁ
KBV50T.indd 2-3
2/8/07 9:34:39 AM
Fit the Turbo Brush onto the telescopic
wand and follow the regular starting
procedure and commence vacuuming.
The suction of the cleaner starts a curved
row of bristles in the brush rotating at
high speed. These rotating bristles actively
work to dislodge deep pile debris to
provide a more effective surface clean.
alwayS enSure THaT THe
duST conTaIner and THe
moTor proTecTIon fIlTer
are correcTly fITTed. neVer
operaTe wITHouT THe duST
conTaIner and fIlTerS In
uSIng your KamBrooK
Jaguar Vacuum cleaner
duST conTaIner IndIcaTor
and dISpenSIng THe duST
conTaIner
When unpacking the vacuum cleaner unit
check to see you have received all the
required components, such as the hose
and other accessories before discarding
the packaging.
place.
VarIaBle power conTrol
Ensure that the dust container and filters
are correctly fitted.
The Turbo Brush has been specifically
designed for removing dirt and debris
from carpeted surfaces. Do not use it for
any purposes, other than those stated. For
optimal performance of your Turbo Brush
ensure that the bristles are kept clean
after use.
The power booster dial on the unit is to
be used for variable power control. Turn
the control clockwise for maximum power
for vacuuming hard floor and carpet
surfaces. Turn the control anti-clockwise
for minimum power when using the
crevice and brush tools.
The dust container should be emptied
when the dust and dirt reaches the MAX
level.
Locate the crush proof hose and push
the connection point into the hose inlet
connection on the front side of the unit,
until a “click” sound is heard.
Always switch the appliance off, then
switch off at the power outlet and unplug
the appliance prior to replacing filters or
emptying the dust container.
Connect the wide end of the metal wand
to the hose end, and push together firmly.
creVIce and BruSH Tool
acceSSorIeS
Fit the floor tool to the narrow end of the
wand and push together firmly.
To remove the dust container, ensure the
unit is down on its wheels; Remove the
dust container by pressing down on the
“Press and Lift” button on the dust
container. Once released slowly pull the
container upwards.
Fully extend the power cord by pulling
the power plug (situated at the rear of the
unit) out from the unit, until the yellow
tape on the cord is shown.
ENSURE THAT YOU DO NOT OVER
EXTEND THE POWER CORD - DO
NOT EXTEND PAST THE RED
TurBo TwISTer BruSH
WARNING TAPE ON THE CORD
The crevice tool is ideal for vacuuming
hard to reach places such as the edges
along skirting boards.
Plug into a 230/240v power point and
switch the power on.
To empty the dust container simply place
it above the rubbish bin; press the “push
to empty” button. The bottom of the
container will release and the dust and
compiled dirt will be dispensed.
To commence vacuuming push down on
the on/off button at the top of the unit.
The brush tools can be used to vacuum
delicate surfaces and areas such as shelves
and venetian blinds.
When vacuuming is complete, push down
on the ‘on/off’ button to switch off. Turn
the power off at the outlet and then
remove the power cord from the power
outlet. When removing plug from the
power outlet grasp the plug not the cord.
Set the variable speed control between
minimum and medium power when using
the tool accessories.
The Turbo Twister Brush is a floor tool
which has been specifically designed to
work in conjunction with your KBV50
Jaguar Bagless Vacuum Cleaner. While
regular floor tools do a good job at
cleaning surfaces the Turbo Brush is the
ideal way to clean away those hard to see
dust and dirt particles that are trapped
deep within carpet pile.
Turn off the vacuum cleaner when
changing any attachments.
To retract the cord push down on the
‘cord rewind’
to retract the cord.
IMPORTANT: HOLD THE PLUG END
WHEN RETRACTING THE CORD TO
PREVENT IT FROM STRIKING YOU OR
THE VACUUM.
IMPORTANT: DO NOT USE THE UNIT
WITHOUT A DUST CONTAINER IN
PLACE
ꢂ
ꢃ
KBV50T.indd 4-5
2/8/07 9:34:42 AM
notes
cleanIng and replacIng
fIlTerS
moTor proTecTIon fIlTer
The motor protection filter must always
be in place when operating the vacuum
Filters must be cleaned from time to time
to remove the fine dust particles that have otherwise damage to the motor may
been collected.
occur.
1.Remove the dust container from the
To replace the motor protection filter
unit by pressing down on the “Press and - remove the dust container. The motor
Lift” button
protection filter is located at the bottom
of the inner chamber. Pull the filter
upward to remove then simply replace the
new filter.
2.Then press the “Push to Empty” button.
The bottom of the container will
release. Take off the filter bracket by
holding onto the shaft and turning the
filter in an anti-clockwise direction and
the filter and its bracket will be released.
exHauST fIlTer
The exhaust filter should be cleaned every
six months. Simply unclip the grill at the
back of the vacuum cleaner and shake
and tap the filter to remove any dust
accumulated. Then relocate the filter and
reattach the grill.
3.To remove the metal filter bracket,
simply lift it vertically. The filter bracket
can be rinsed in luke warm water.
Ensure you let the filter bracket
completely dry naturally before next use.
care and maInTenance
4.Shake and tap the HEPA filter until
all the fine dust particles are removed.
However, after approximately 6 months
the HEPA filter should be replaced.
Always switch appliance off, then switch
off at the power outlet and unplug the
appliance prior to cleaning or replacing
either filter.
5.To place the filter back in the dust
container simply place the metal filter
bracket directly over the HEPA filter,
ensure that the metal filter holder is
completely dry before use. Ensure that
the grooves on the HEPA filter holder
and metal filter bracket fit into place.
To clean the outside of the unit, wipe the
exterior with a soft, damp cloth. Never
use an abrasive cleaner.
cHecK and replace BoTH
THe moTor proTecTIon
and Hepa fIlTerS
approxImaTely TwIce
a year or wHen VISIBly
clogged.
6.Simply place the filter unit in the dust
container lid and turn the filter unit in
a clockwise direction until it is clicked in
place. Close the bottom of the container.
7. Place the dust container back in the
vacuum cleaner for next use.
ꢄ
ꢅ
KBV50T.indd 6-7
2/8/07 9:34:42 AM
|