Kambrook 4 Kingston Town Close Oakleigh,Victoria 3166,Australia
Customer Service Line (free call) 1800 800 634 Customer Service Fax 1800 621 337
Kambrook New Zealand, Private Bag 94411, Greenmount, Auckland, New Zealand
Customer Service Line/Spare Parts 09 2713980 Customer Service Fax 0800 288 513
Jaguar Dart
Vacuum Cleaner
Due to continual improvement in design or otherwise, the product you purchase may differ slightly from the one illustrated in this book. Issue 1/03
KVC5
Issue 1/03
NOTE:The bag compartment lid may not close if
the bag is not correctly fitted.
To retract the cord push down on the
‘cord rewind’ pedal.
Always switch appliance off, then switch
off at the power outlet and unplug the
appliance prior to replacing dust bags or
filters.
UsingYour Kambrook Jaguar
Vacuum Cleaner
IMPORTANT: DO NOT USE
THE UNIT WITHOUT A DUST
BAG IN PLACE
IMPORTANT: HOLDTHE PLUG
END WHEN RETRACTINGTHE
CORDTO PREVENT IT FROM
STRIKINGYOU ORTHEVACUUM.
Remove all packaging from the unit, hose
and other accessories; ensure that you
have removed all of the accessories before
discarding the packaging.
To remove the dust bag, ensure the unit is
down on its wheels, remove the crush
proof hose and push the ‘Dust bag
compartment lid release lever’ Once the
lid has released, pull the top cover back.
Replacing filters
ALWAYS ENSURETHATTHE
DUST BAG ANDTHE MOTOR
PROTECTION FILTER ARE
CORRECTLY FITTED. NEVER
OPERATE WITHOUTTHE DUST
BAG OR FILTERS IN PLACE.
Ensure that the dust bag and filters are
correctly fitted.
Filters must be cleaned from time to time
to remove the fine dust particles that have
been collected.This can be done by
shaking them, however after
approximately 8 dustbag changes the
filters should be replaced.
Locate the crush proof hose and push the
connection point into the hose inlet
connection on the top of the unit, until a
“click” sound is heard.
To remove the bag, grasp the plastic insert
attached to the dust bag and pull upwards
as per arrow indicator.
Crevice and brush tool accessories
To empty the bag, remove the plastic bar
attachment at the bottom of the bag by
sliding across. Once the bag has been
emptied, replace the sliding bar and your
bag is ready to re-use.
Motor protection filter
Connect the wide end of the metal wand
to the hose end, and push together firmly.
The crevice tool is ideal for vacuuming
hard to reach places such as the edges
along skirting boards, crevices, corners
and in between cushions.
The motor protection filter must always
be in place when operating the vacuum
otherwise damage to the motor may
occur
Fit the floor tool to the narrow end of
the wand/s and push together firmly.
Fully extend the power cord by pulling
the power plug (situated at the rear of the
unit) out from the unit, until the
The brush tool can be used to vacuum
delicate surfaces and areas such as shelves
venetian blinds, furniture & lampshades.
To replace the motor protection filter –
Remove the dustbag or pull the bag
forward.The motor protection filter is
located at the rear, right hand side of this
inner chamber. Pull the plastic filter holder
upward to remove.
Filter holder
red/yellow tape on the cord is shown.
Separate crevice and brush tools are
located inside the on-board tool storage
compartment.The opening for this
compartment is located directly below the
hose connection inlet.To open place a
finger inside the thumb groove and pull
the compartment lid upwards.
ENSURETHATYOU DO NOT
OVER EXTENDTHE POWER
CORD – DO NOT EXTEND PAST
THE RED/YELLOW WARNING
TAPE ONTHE CORD
Dust bag holder
Filter holder
When vacuuming fine dust particles, the
fine dust particles can clog the pores of
the dust bag and the dust bag indicator
will indicate full. If this happens the bag
could appear relatively empty, however
the bag will still need to be emptied to
avoid strain on the motor.
Plug into a 230/240v power point and
switch the power on.
Removable filter
Turn off the vacuum cleaner when
changing any attachments.
To commence vacuuming push down on
the on/off foot pedal, at the top, rear of
the unit.
Dust bag indicator and changing the
dust bag
When vacuuming is complete, push down
on the ‘on/off’ pedal to switch off.Turn
the power off at the outlet and then
remove the power cord from the power
outlet (when removing plug from the
power outlet grasp the plug not the cord).
The dust bag should be emptied when full.
The dust bag indicator window will
gradually turn red as the bag fills up and
when the dust bag indicator displays ‘red’
it is time to change the dust bag.
4
5
Care and Maintenance
KAMBROOK
12 MONTH
WARRANTY
Always switch appliance off, then switch
off at the power outlet and then unplug
the appliance prior cleaning or replacing
either filter.
KAMBROOK warrants the purchaser
against defects in workmanship and
material, for a period of 12 months
from the date of purchase (3 months
commercial use).
If the product includes one or a number
of accessories only the defective accessory
or product will be replaced.
To clean the outside of the unit, wipe the
exterior with a soft, damp cloth. Never
use an abrasive cleaner.
In Australia, this KAMBROOK Guarantee
is additional to the conditions and
guarantees which are mandatory as
implied by the Trade Practices Act 1974
and State Territory legislation.
Guarantee and purchase receipt for this
product are to be retained as proof of
purchase and must be presented if making
a claim under the terms of the
Check and replace both the motor
protection and micro dust filters on a
regular basis.
For service, spare parts or product
information in Australia, please call
KAMBROOK on the Customer Service
Line (free call) 1800 800 634.
From time to time hair, cotton and other
items may get caught in the brushes of the
Turbo Head and prevent it from spinning
around.To remove such items, take a pair
of scissors and cut the across the cotton,
hair etc. to loosen, then gently pull to
remove.
KAMBROOK guarantee.
KAMBROOK reserves the right to
replace or repair the appliance within
the warranty period.
For service, spare parts or product
information in New Zealand, please
call KAMBROOK New Zealand,
Greenmount, Auckland Phone 09 2713980
Fax 0800 288 513. For spare parts phone
09 2713980.
Warranty does not apply to any defect,
deterioration, loss or injury or damage
occasioned by, or as a result of the misuse
or abuse, negligent handling or if the product
has not been used in accordance with the
instructions.The guarantee excludes
breakages and consumable.
NOTE: Do not continue to pull if the item/s does
not easily come out as this may permanently
damage theTurbo Head.
If claiming under this guarantee the product
must be returned freight prepaid.
This warranty is void if there is evidence
of the product being tampered with by
unauthorised persons.
YOUR PURCHASE RECORD (Please complete)
Attach a copy of purchase
receipt here.
DATE OF PURCHASE___________________________
MODEL NUMBER _____________________________
SERIAL NUMBER (If applicable) ___________________
Please don’t return purchase record
unless you are making a claim
PURCHASED FROM ___________________________
6
7
|