®
Pro Line™ Gas Cooktop
PRODUCT MODEL NUMBERS
OVERALL DIMENSIONS
KGCP462KSS
KGCP463KSS
KGCP467JSS
KGCP467JTL
KGCP482KSS
KGCP483KSS
KGCP484KSS
KGCP487JSS
backguard (shown)
or island trim
36" (91.4 cm) cooktop with
all sealed burners shown
36" (91.4 cm) long
3-prong ground-type
power supply cord
Gas supply: Cooktop is equipped for use with
NATURAL gas. Cooktop can be converted to L.P.
gas. Gas supply line of 3/4" rigid pipe to cooktop
location. If local codes permit, a new AGA or CSA
design-certified, 4-5 foot (1.2-1.5 m) long, 1/2" or
3/4" I.D., flexible metal appliance connector is
recommended for connecting cooktop to gas
supply line. Pressure regulator has 3/8" female
pipe threads. The supply line shall be equipped
with an approved shutoff valve.
Electrical: Electrical: 120-volt, 60-Hz, AC-only,
15-amp. electrical supply. Use copper wire only. A
time-delay fuse or circuit breaker and separate
circuit is recommended.
9" (22.9 cm)
KGCP487JSS
6" (15.2 cm)
7-1/2" (19.1 cm)
26-1/4" (66.7 cm)
36" (91.4 cm) cooktop: 35-7/8" (91.1 cm)
48" (121.9 cm) cooktop: 47-7/8" (121.6 cm)
26-1/4" (66.7 cm)
gas inlet is located 1-7/8"
(4.8 cm) from back of burner
box and
9"
3/8"
(22.9 cm)
4-7/8" (12.4 cm) in from L.H.
side of burner box
It is recommended that an overhead vent hood be
used with this cooktop. For island installations, a
48" (122 cm) hood is recommended.
(9.5 mm)
side view
of cooktop
7-1/8"
(18.1 cm)
Cooktop location should be away from strong draft
areas, such as windows, doors and strong heating
vents or fans.
7/8"
(22.2 mm)
2-3/16"
(55.6 mm)
1-3/16"
(30.2 mm)
22" (55.9 cm)
CABINET OPENING DIMENSIONS
A
B (min.)
backguard
C
D
E
backguard cabinet and
opening countertop
3-prong ground-type outlet
should be located on left hand
side of cutout 8" (20.3 cm)
max. from enclosure sidewall.
size
model
island trim backguard island trim
countertop only
36" (91.4 cm) KGCP462K
KGCP463K
5"
1-3/4"
(4.4 cm)
48" (121.9 cm)
36"
35-1/4"
36" (91.4 cm) or
35-7/8" (91.1 cm)
for zero clearance fit
(12.7 cm)
(91.4 cm) (89.5 cm)
KGCP467J
49" (124.5 cm)
non-combustible surface
Note: Solid side
and bottom of
cutout enclosure
not shown.
48" (121.9 cm) KGCP482K
KGCP483K
6"
1-3/4"
(4.4 cm) (121.9 cm)
48"
49"
(124.5 cm)
48"
47-1/4"
48" (121.9 cm) or
(15.2 cm)
(121.9 cm) (120.0 cm) 47-7/8" (121.6 cm)
for zero clearance fit
14"
(35.6 cm)
10" (25.4 cm)
5"
48"
(121.9 cm)
(12.7 cm)
KGCP484K 6" (15.2 cm)
KGCP487J
5"
5"
48" (121.9 cm)
(12.7 cm)
(12.7 cm)
non-combustible surface
Note: Dimension "B" can be reduced by 6" (15.2 cm) when bottom of wood or metal cabinet is protected by not less than 0.25" (6.4 mm)
flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel,0.024" (0.6 mm)
aluminum or 0.020" (0.5 mm) copper.
C
Gas supply line should be
located in this area on rear or
side walls, or the supply line can
come up through the floor.
13" (33 cm) max.
Gas and Electric
Connection Locations
upper cabinet depth
18" (45.7 cm) min.
clearance upper
cabinet to countertop
C
B min.
A
notch to be equal
both sides.
3/4" (1.9 cm)
D
see corner
notch detail
22-1/4"
(56.5 cm)
6-7/8" (16.1 cm)
7-1/4"
(18.4 cm)
4-3/4"
(12.1 cm)
12-5/16" (31.3 cm)
min. clearance to
side wall -
E
2"
(5.1 cm)
24"
both sides
(61 cm)
D
CORNER NOTCH
DETAIL
base cabinet
E
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. 8284979
02-28-02
|