Kompernass Hot Beverage Maker SWKT 3000 A1 User Manual

KITCHEN TOOLS  
6
Kettle SWKT 3000 A1  
Kettle  
Operating instructions  
KOMPERNASS GMBH  
BURGSTRASSE 21 · D-44867 BOCHUM  
ID-Nr.: SWKT3000A1-07/10-V1  
 
CONTENT  
PAGE  
Intended Use  
2
2
2
2
2
3
3
4
5
5
5
5
Technical Data  
Items supplied  
Operating elements  
Safety Instructions  
Starting Up the Device  
Boiling Water  
Cleaning and Care  
Storage  
Disposal  
Warranty & Service  
Importer  
Read the operating instructions carefully before using the appliance for the first time and preserve this boo-  
klet for later reference. Pass the manual on to whomsoever might acquire the scale at a later date.  
- 1 -  
 
KETTLE  
Safety Instructions  
Intended Use  
ƽ To avoid the risk of fatalities from electric  
shocks:  
This device is intended for heating water for house-  
hold use. It is not intended for use with other liquids  
or for commercial use.  
• Make certain that the base  
with the electrical  
t
connections never comes into contact with  
water! Let the base become completely dry  
t
before using if it has accidentally become wet.  
• Only use the hot water kettle with the supplied  
Technical Data  
base  
.
t
• Make sure that the power cord never becomes  
wet or damp during operation. Lay the cord such  
that it cannot be pinched or otherwise  
Voltage:  
220 - 240 V / 50 Hz  
~
Power consumption: 2500 - 3000 W  
damaged.  
In older electrical installations, the building  
fuse (12A) may be triggered due to the high  
power consumption.  
• Arrange for defective power plugs and/or  
cables to be replaced as soon as possible by a  
qualified technician or by our Customer Service  
Department to avoid the risk of injury.  
• Always pull the plug out of the power socket  
after use. Switching off the device is not sufficient  
because the device receives power as long as  
the power plug is connected to the socket.  
Items supplied  
Water boiler with stand and spout strainer  
Operating Instructions  
Ensure that the appliance, the power cable  
and the power plug are NEVER submersed  
in water or other fluids.  
Operating elements  
Lid  
ƽ To prevent the risk of fire or injury:  
q
Unlocking button  
ON/OFF switch  
Operating light  
Base  
Temperature control  
Kettle  
• Always heat water with a closed lid , otherwi-  
w
e
r
t
y
u
i
o
q
se the automatic cut-out mechanism doesn’t  
work. Boiling water can then spray out over the  
edge.  
• Hot steam clouds may be released. The kettle  
is also very hot during operation. Wear oven  
mits.  
• Make certain that the device rests firmly and ver-  
tically before switching it on. Boiling water can  
cause an unstabile kettle to fall over.  
u
Level indicator  
Spout screen  
• Do not use an external timing switch or a separate  
remote control system to operate the appliance.  
Download from Www.Somanuals.co-m2.-All Manuals Search And Download.  
• Do not allow individuals (including children) to  
use the appliance whose physical, sensorial or  
mental abilities or lack of experience and know-  
ledge hinder their safe usage of it if they have  
not previously been supervised or instructed in its  
correct usage.  
• Lift away the kettle  
for filling!  
u
• Open the lid  
by pressing down on the unlok-  
q
king button  
.
w
• Hold the kettle  
vertically while filling. Only  
u
then will the level indicator  
correctly indicate the water volume.  
on the side  
i
• Tell children about the appliance and its potenti-  
al dangers so that they do not play with it.  
Fill the kettle ...  
– at least to the MIN mark so that the device does  
u
not overheat,  
– no higher than the MAX mark so that no boiling  
water spills out.  
Starting Up the Device  
• First close the lid ...  
q
• Before starting up the device, make certain that...  
– the device, plug and power cable are in good  
working order and...  
• then place the kettle  
straight on the base  
• Set the desired water temperature using the  
on the base  
until it sits  
u
t
.
t
– all packaging materials have been removed  
from the device.  
temperature control  
To bring the water to a boil, you must set the  
.
y
• Fill the device with water up to the MAX mark  
and let it come to a full boil once as described in  
the next section. Pour out this water.  
temperature controller to the MAX position.  
• Now insert the power plug into the power  
y
socket and press the ON/OFF switch  
until it snaps in.  
down  
e
• The operating light  
now heating up.  
indicates that the device is  
r
Boiling Water  
ƽ Danger! Never place the electrical base  
Transition-  
range  
near water – life-threatening danger!  
ƽ Warning: Pull the power plug from the  
socket before lifting the kettle  
from the  
u
MIN  
base . This prevents any water  
t
splashing out from contacting the electrical  
connections in the base , which could  
cause a short circuit.  
t
MAX  
For safety reasons, the lid  
should not  
q
be opened while the water is boiling or is  
very hot. Otherwise there is a risk of  
injury.  
Temperature regulator in the boiling range  
• The devices switches off automatically and the  
You should only heat as much water as you need  
directly. That helps you save electricity, water and  
time:  
operating light  
is at a full boil. The ON/OFF switch  
out.  
goes out as soon as the water  
r
springs  
e
- 3 -  
 
In order to keep the water warm after bringing it to  
Cleaning and Care  
a boil, set the temperature regulator  
warm range.  
in the keep  
y
ƽ Danger!: Do not open any part of the  
housing. There are no operating elements  
inside. An open housing can create the risk  
of a life-threatening electrical shock.  
Press the ON/OFF switch  
down, until it snaps in.  
e
Temperature regulator in the keep warm range  
The left end of the keep warm range indicates the  
lower temperature. The right end of the keep warm  
range indicates the higher temperature.  
(The water does not start boiling in the keep warm  
range!).  
Never submerse any parts of the device in  
water or other liquids! This can create the  
risk of a life-threatening electrical shock if  
residual liquid comes into contact with  
powered components.  
• After reaching the desired temperature, the ap-  
pliance switches off the heating process. The  
Before cleaning the device, ....  
• First pull the power plug out of the power socket  
and let the device cool completely.  
ON/OFF switch  
and the operating lights  
e
r
remain switched on.  
• Clean the exterior surfaces and the power cord  
with a slighly damp cloth. Always dry the device  
well before using it again.  
• Never use any cleansers, abbrasive substances  
or solvents. These can damage the device.  
Because the device is equipped with a heat  
maintenance function, the device automatically  
begins reheating as soon as the water tempe-  
rature falls below the set temperature.  
The appliance heats until the desired tempera-  
ture is reached. Make sure that the appliance  
does not automatically switch on to the keep  
warm function. Therefore, do not leave the  
appliance unsupervised!  
In the event of calcium deposits  
• Purchase a decalcifying agent suitable for use  
with food containers from a household goods  
stores (e.g. coffee machine decalcifier).  
• As soon as the kettle  
is lifted from the base  
• You can use a suitable product from a  
specialised dealer for the stainless steel  
container bottom.  
u
, the ON/OFF switch  
t
jumps out and the  
e
operating lights  
switch off.  
r
• In order to halt the heating process, push the  
ON/OFF switch up again. The operating  
Removing / replacing the spout screen  
e
light  
goes out then as well.  
• Open the lid  
completely.  
r
q
• Press down on the edge of the spout screen  
o
Avoid setting the temperature regulator in  
from above in order to remove it toward the insi-  
de.  
y
the transition range, as the water can start boi-  
ling on account of varying filling levels.  
• Clean the spout screen  
moistened wash cloth.  
with a lightly  
o
• After cleaning, insert the spout screen  
above and press it firmly into place.  
from  
o
Download from Www.Somanuals.co-m4.-All Manuals Search And Download.  
• Should the scale deposits in the pourer sieve  
The warranty covers only claims for material and  
manufacturing defects, but not for transport dama-  
ge, for wearing parts or for damage to fragile com-  
ponents, e.g. buttons or batteries. This product is for  
private use only and is not intended for commercial  
use. The warranty is void in the case of abusive and  
improper handling, use of force and internal tampe-  
ring not carried out by our authorized service  
branch. Your statutory rights are not restricted in  
any way by this warranty.  
The warranty period will not be extended by repairs  
made under warranty. This applies also to replaced  
and repaired parts. Any damage and defects extant  
on purchase must be reported immediately after un-  
packing the appliance, at the latest, two days after  
the purchase date. Repairs made after the expira-  
tion of the warranty period are subject to payment.  
o
be firmly settled, lay it in a water-vinegar solution,  
with a ratio of 6:1, for a few hours. The scale  
deposits will dissolve themselves. Rinse the pourer  
sieve  
with lots of clear water.  
o
Storage  
Let the device cool completely before storing it.  
• Wind the power cord around the holder on the  
bottom of the device.  
• Store the device in a dry place.  
Disposal  
Do not dispose of the appliance in your  
normal domestic waste. This product is  
subject to the European guideline  
2002/96/EC.  
DES UK LTD  
Tel.: 0871 5000 700 (£ 0.10 / minute)  
Dispose of the appliance through an approved dis-  
posal centre or at your community waste facility.  
Observe the currently applicable regulations.  
In case of doubt, please contact your waste disposal  
centre.  
Kompernass Service Ireland  
Tel.: 1850 930 412 (0,082 EUR/Min.)  
Standard call rates apply. Mobile operators may vary.  
Dispose of all packaging materials in an  
environmentally friendly manner.  
Importer  
KOMPERNASS GMBH  
BURGSTRASSE 21  
Warranty & Service  
D-44867 BOCHUM  
The warranty for this appliance is for 3 years from  
the date of purchase. The appliance has been ma-  
nufactured with care and meticulously examined be-  
fore delivery. Please retain your receipt as proof of  
purchase. In the event of a warranty claim, please  
make contact by telephone with our Service Depart-  
ment. Only in this way can a post-free despatch for  
your goods be assured.  
- 5 -  
 

Indesit Oven K1G2 S P User Manual
Indesit Refrigerator TFA1 User Manual
iSimple Car Satellite Radio System ISFD11 User Manual
JVC Security Camera TK C1530E User Manual
Kambrook Blender KIM300 User Manual
Kenmore Refrigerator 240461405 User Manual
Kenwood Car Stereo System KCA S220A User Manual
Kettler Swing Sets 08382 799 User Manual
KitchenAid Convection Oven KEBN100Y User Manual
Kodak Digital Camera M893 IS User Manual