Quick Setup Guide
NS-NAV02R GPS
Features
Actual product may vary from image shown.
Top panel
Congratulations on your purchase of a high-quality
Insignia product. Your GPS is designed for reliable and
trouble-free performance. Use this guide for initial setup.
See your User Guide for more information.
Side panel
Power button
Bracket Adjuster
Locking level
Package contents
• 4.3" GPS
LCD Screen
Front panel
Charge Indicator
3
• DC power adapter
• Mounting bracket
• Mounting cradle
• SD memory card (pre-installed)
• User Guide
Micro
SD Card
Slot
(cover removed)
USB
port
• Quick Setup Guide
Mounting your GPS in a car
WARNING: The assembly must not be mounted so that it impairs the driver’s view of the
road. Make sure that your car’s airbags are not obstructed by the GPS.
Use the supplied mounting bracket and cradle to mount your GPS in a vehicle.
1 Slide the mount cradle onto the end of the mounting bracket to attach it.
2 Set the bottom edge of your GPS onto the mount cradle, then push the GPS
into the tab (1) at the top of the mount cradle.
To remove the GPS, lift the tab (1) at the top of the mount cradle and pull
the GPS forward.
3 Lift the suction cup lever (3) and then press the suction cup to the
windshield.
Setting up your GPS
Charging the battery
Reset
hole
Your portable GPS comes with a built-in rechargeable
battery. Fully charge the battery before using the GPS for the
ꢀrst time. Charging time is normally about three hours. A
fully charged battery delivers about two hours of use.
See “Connecting power and charging the battery” below.
Back panel
4 Press the suction cup lever toward the windshield to attach the bracket to
the windshield.
5 Rotate the knob to adjust the assembly to the proper position.
CaliforniaVehicle Code Section 26708 prohibits suction mounts on
car windshields, side, or rear windows, as they can obstruct the
driver’s clear view.
Speaker
Connecting power and charging the battery
Connecting DC power
CAUTION: Disconnect the GPS from the DC power adapter when starting the vehicle.
1 Plug the power adapter into the receiver’s USB port.
USB Port
Cigarette lighter
socket
2 Plug the other end of the power adapter into the vehicle’s
12V power socket.
Car Adaptor
|