Optical Smoke Detector
• Addressable conventional technology
• Individual detector addressing by
means of optional address module
• Optional connection of remote
indicator
• Extremely flat design
• Sealed electronics
Description
The Optical Smoke Detector OP-12001 uses the scatte- the measurement system, this is indicated by a yellow
red light principle and was developed for the detection flashing of the multicoloured status LED.
of smoke particles in a wide range of fire detection ap-
plications. The modern design of the sensing chamber Addressable conventional technology is used for alarm
allows to reliably evaluate the characteristics of fire.
transmission to the fire detection control panel. By
means of the optional Address Module NG60-1, each
Intelligent evaluation algorithms compensate for the detector can be addressed individually, thus allowing to
contamination of the optical measurement system, display the detector address, as well as an assigned
thus keeping the response sensitivity of the detector element text, on a suitable fire detection control panel.
constant for a long time. In this way, false alarms can
be avoided to a great extent. If the contamination can The detector can be attached to various bases and it
not be compensated any further, or if a fault occurs in can be protected against theft.
Specifications
Operating voltage
Current consumption
Ambient temperature
Relative humidity
Dimensions ø × H
Colour
Supply through the detector line voltage
typ. 65µA (quiescent)
-40°C to +70°C (no condensation or icing)
0 – 98% (no condensation)
100 × 31 (mm)
white
Weight
75g
Approval
VdS G204039
Order number
Order name
241060
Optical Smoke Detector/Conv./ORBIS/Apo OP-12001
Building Safety. Building Security.
A
© LABOR STRAUSS SICHERUNGSANLAGENBAU GMBH • A-1231 WIEN • WIEGELESTRASSE 36 • TEL +43 1 52114-0 • FAX +43 1 52114-27
OP-12001_DBL_LST_EN_0804.PDF • PAGE 1
[email protected] • WWW.LST.AT • ALL RIGHTS RESERVED
|