Essential & LF Sport Bikes Upright and Recumbent
Console Assembly Service Kit Replacement
Special Service Tools Required: NONE
Replacement of the Console Assembly is basically the same
for both Essential & LF Sport Bikes (Upright/Recumbent). The
only difference is that on the Upright Bike, the Console
Support Plate is welded to the Console Post, while on the
Recumbent Bike, the Accessory Tray Bracket and the Console
Plate are secured together on the Console Post by two ½”
screws. These two screws along with the Console screws (4)
must be replaced. Regardless, the Console Assembly Service
Kit includes the Console Assembly along with six new,
specially designed screws, which have little tabs on the back
of the screw head to enhance grounding capabilities. All six of
these screws will be used for the Recumbent Bike only. While
only four of these screws will be used for the Upright Bike.
Console
Asse m bly
Sc re ws(4)
1. Remove four 1” screws from the back of the Console
Assembly (Upright or Recumbent), and discard.
2. Lift the Console Assembly off just enough to disconnect
the Main Wiring Cable, and then remove the Console
Assembly. Return old Console back to Life Fitness Co.
Upright
3. In the case of the Recumbent Bike, remove
the two ½” screws securing the Accessory
Tray Bracket and Console Support Plate to
the Console Post, and discard. Then install
with the two new, ½” screws in the kit.
Acc essory Tra y
Bra c ke t Sc re ws(2)
Console
Asse mbly
Sc re ws(4)
Note: To avoid alignment problems and handling
of loose components, remove and replace one
screw at a time in the Console Support Plate.
4. Install the new Console Assembly in reverse
order using the four new, 1” screws in the kit.
Note: The new screws MUST replace the old
screws.
Re c um be nt
1
|