Lucent Technologies Cordless Telephone MDW 9031DCP User Manual

MDW 9031/9031DCP

Wireless Pocket Phone Quick Reference

503-801-165

Comcode 108406844

February 1999

Issue 2

Contents

Quick Reference

Handset Controls . . . . . . . . . . . . . . . . . . . . . . 1

Handset Display . . . . . . . . . . . . . . . . . . . . . . . 2

Line Status Indicators . . . . . . . . . . . . . . . . . . . . 3

Volume Adjustment . . . . . . . . . . . . . . . . . . . . . 4

Battery Charger LEDs . . . . . . . . . . . . . . . . . . . . 5

Help!. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Making a Call . . . . . . . . . . . . . . . . . . . . . . . . 6

Answering a Call. . . . . . . . . . . . . . . . . . . . . . . 6

Preselecting a Line or Button . . . . . . . . . . . . . . . . 7

Accessing Certain Voice Mail Systems

with a DEFINITY System . . . . . . . . . . . . . . . . . 7

Changing Settings or Performing Tests in Local Mode . . . 8

MDW 9031/9031DCP Wireless Pocket Phone Quick Reference

503-801-165

Issue 2 February 1999 iii

Quick Reference

Handset Controls

Receiver

Headset On/Off

Receives the sound

of your caller's voice,

unless a headset is

connected.

Press to turn the headset on

if the headset is plugged in.

ON appears in handset

display. To turn off, press

again. Turn on to make or

answer a call, and turn off to

“hang up.”

Antenna

Extend fully to

maximize the handset

range and voice

quality.

Lanyard Loop

Attach lanyard for

carrying handset.

Handset Display

Displays status of

lines and range. Also

see “Handset

Volume Control

Press "+" to increase

or "-" to decrease

volume of receiver or

alerter.

Display” on next page.

212 555 1212

MSG

Column

Use, with Select

On/Off

button, to choose a

line or programmable/

intercom/drop button.

Press to turn the

handset on. ON

appears in handset

display. To turn off,

press again. Turn on to

make or answer a call,

Scroll (9031DCP Only)

When the Selection

rectangle is in the top row,

press to toggle between

the first and second line of

the display.

Redial

Mute

On/Off

and turn off to“hang

up.”

ABC

DEF

Feat/P

Conf

Feat/P

(Feature/Program)

GHI

JKL

MNO

Redial

Press to redial

PQRS

TUV

WXYZ

Press to use dial-code

features (PARTNER^®

systems only) or to

enter programming

mode.

Trans

Hold

the last number

manually dialed from

OPER

the handset.

Select

TransTalk

Use to move the

Exit (9031DCP Only)

Selection rectangle,

and, with Column

buttons, to choose a

line or programmable/

intercom/drop button.

Also use to wake-up

the phone.

Press the Feat/P twice

to Exit the Softkey

menu.

Conf (Conference)

Press to conference

in (add) another

Hold

Press to put a call on

hold.

Mute

party to your call.

Press to turn the micro-

phone off for privacy .

Headset Connector

(Transfer)

Trans

Press to transfer

a call to another

extension.

Plug in the headset cord

to use the headset.

MDW 9031/9031DCP Wireless Pocket Phone Quick Reference

503-801-165 Issue 2 February 1999

Quick Reference

Handset Display

1 Information you would see on a wired system phone’s display, (except

time), based on your communications system:

LCL:P, D, M1, or M2 = Local Mode:

communications system

WIRELESS TEST = Handset in Wireless Test Mode

VIBR = Vibrator enabled

PSEL = Line Preselection enabled

PRESELECTION:ON/OFF = Line Preselection Mode:status

CHANGE BUTTN MAP = Communications system setting is

wrong

MAP:P, D, M1, M2 = Button Mapping Mode: setting

NO LINK = Handset is not communicating with radio module

2 MSG indicates that you have a message.

3 RANGE indicates that the handset is out of range or almost out of range.

Handset also beeps.

4 ON indicates that handset was turned on by pressing O.

5 Battery icon flashes to indicate a low battery condition. Handset also

emits 2 beeps.

6 No Ring icon indicates that the alerter is disabled.

7 MUTE indicates that handset microphone was turned off by pressing

MDW 9031/9031DCP Wireless Pocket Phone Quick Reference

Issue 2 February 1999

503-801-165

Quick Reference

8 Line Status Indicators show the status of line or

programmable/intercom/drop buttons. See “Line Status Indicators”

below.

9 Selection rectangle indicates the active row for line or

programmable/intercom/drop button selection.

When the display is blank, the handset is either turned off or in “sleep”

mode. Activate the display by pressing O or ".

Line Status Indicators

Each line status indicator corresponds to a specific outside line or

programmable/intercom/drop button:

PARTNER Systems

A triangle ( ) is the equivalent of a green LED on a wired phone.

A rectangle (

) is the equivalent of a red LED on a wired phone.

All Other Systems

A triangle (

) is the equivalent of a red LED on a wired phone.

) is the equivalent of a green LED on a wired phone.

A rectangle (

MDW 9031/9031DCP Wireless Pocket Phone Quick Reference

503-801-165 Issue 2 February 1999

Quick Reference

Volume Adjustment

To increase or decrease the volume of the handset alerter or the receiver

(earpiece):

•

Alerter: Press the “ ” or the “ ” button while the MDW 9031/9031DCP

is awake but turned off. If the display is dark (the phone is in “sleep”

mode), press " to wake it up, then press the “+” or the “-” button.

Receiver: Press the “ ” or the “ ” button while the MDW

9031/9031DCP is turned on.

MDW 9031/9031DCP Wireless Pocket Phone Quick Reference

Issue 2 February 1999

503-801-165

Quick Reference

Battery Charger LEDs

The color of the battery charger’s LEDs indicates the state of the

corresponding battery pack, as shown in the following table:

Battery

charger LED SPARE LED,

shows...

If it is the

HANDSET

LED, the

battery pack button was

in the

If it is the

REFRESH LED,

the Refresh

the battery

pack in the

Spare battery

pressed, and

the Handset

battery pack...

compartment... Handset...

Steady orange Is charging Is charging

N/A

Steady green

Flashing red

Is fully charged

Is fully charged N/A

Has one of the

following

problems...

Has one of the

following

N/A

See Note

below.

problems...

•

Is not seated

properly in the

charger

•

Is not

seated

properly in

the charger

•

Has dirty

contacts

•

Has dirty

contacts

Is defective

Steady red

Is in the Discharge Is in the

Is in the

portion of the

Refresh cycle.

Discharge

portion of the

Refresh cycle.

Discharge portion

of the Refresh

cycle.

Note: If either the SPARE LED or the HANDSET LED is flashing

red, both battery packs must be removed from the charger to

clear the flashing-red condition. Address the possible

problems for one battery pack at a time to determine whether

one is bad.

MDW 9031/9031DCP Wireless Pocket Phone Quick Reference

503-801-165

Issue 2 February 1999

Quick Reference

Help!

MDW 9031

If you need help when using your MDW 9031 with a PARTNER ,

MERLIN , or MERLIN LEGEND system in the continental U.S.,

call 1 800 628-2888.

MDW 9031DCP

If you need help when using your MDW 9031DCP with a DEFINITY

system in the continental U.S., call 1 800 225-7585, or contact the Lucent

Customer Care Center at 1 800 241-2121.

For all other systems, follow the procedure you normally use to get support

for your communications system. Outside the continental U.S., contact your

Lucent Technologies Representative or local Authorized Dealer.

Making a Call

1 Press O.

2 If desired, press " to move the Selection rectangle; then press '

corresponding to the line you want.

3 Dial the call.

4 To end the call, press O.

Answering a Call

1 Press O.

2 Speak into the handset.

3 To end the call, press O.

MDW 9031/9031DCP Wireless Pocket Phone Quick Reference

Issue 2 February 1999

503-801-165

Quick Reference

Preselecting a Line or Button

After Line Preselection is enabled, proceed as follows:

1 If the display is blank, press ".

2 If necessary, press " to move the Selection rectangle.

3 Press ' corresponding to the line or button you want.

4 Press O to access the line or button.

Accessing Certain Voice Mail Systems

with a DEFINITY System

Note: This section only applies to the MDW 9031 Pocket Phone.

After dialing into some voice mail systems (for example, Octel 200/250,

300/350), the MDW 9031 Pocket Phone may not provide touch tones in

order to access the voice mail system prompts.

If you experience this problem after dialing into your voice mail system,

press the Feat/Pbutton twice. After pressing the Feat/P button twice, your

Pocket Phone will generate touch tones and you will be able to navigate

within your voice mail system. When you end your call to your voice mail

system, or press any non-dialpad button on your Pocket Phone (that is, Conf,

Trans, Hold, Redial, Mute), your MDW 9031 will stop generating touch

tones behind the voice mail system. You will need to re-enter

Feat/Pwhenever you dial into these voice mail systems or after you have

pressed a non-dialpad button.

MDW 9031/9031DCP Wireless Pocket Phone Quick Reference

503-801-165

Issue 2 February 1999

Quick Reference

Changing Settings or Performing Tests in Local Mode

1 Make sure the handset is turned off.

2 Press and hold " for 3 seconds.

3 While still holding ", press O.

4 Press one of the following:

A (2) to enable or disable the alerter.

L (5) to enable or disable backlighting.

P (7) for 3 seconds, then " to enable or disable

Line Preselection.

V (8) to enable or disable the vibrator.

W (9) to enter Wireless Test Mode, then 1 for signal strength 2

for voice quality 3 for matching radio module and slot number 5

for handset power settings # to enter Local Test Mode.

5 Press O to exit.

CAUTION:

The MDW 9031/9031DCP handset is a radio device and, like all radio

devices, should not be placed next to a pacemaker. See “Guidelines

for Safe and Efficient Operation” in the MDW 9031/9031DCP Wireless

Pocket Phone Installation and Use guide for more information.

MDW 9031/9031DCP Wireless Pocket Phone Quick Reference

Issue 2 February 1999

503-801-165

KWC Indoor Furnishings S30A200 User Manual
Learning Resources Games Three Bear Family User Manual
Life Fitness Bicycle LM350000 5 User Manual
LST Smoke Alarm 55000 847 User Manual
Magnadyne Car Stereo System M3200CD User Manual
Makita Power Hammer HM150 User Manual
Marantz Stereo Receiver SR8000 User Manual
M Audio Electronic Keyboard 49I User Manual
M Audio MP3 Player MicroTrack II User Manual
Melissa Styling Iron 635 097 User Manual