99-7337B
TABLE OF CONTENTS
Dash Disassembly
- KIA Soul 2010-11 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Kit Assembly
- ISO Head Unit Provision. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
*Note:
Refer also to the instructions included with the aftermarket radio.
K
NOWLEDGE IS
POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP certified
technicians.
99-7337B DASH DISASSEMBLY
KIA SOUL 2010-11
A
B
C
1
2
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
Unclip and remove the radio/climate
control trim panel. (Figure A)
Remove (4) Phillips screws securing
the climate control. (Figure B)
3
4
Remove (4) Phillips screws securing
the radio. (Figure C)
Continue to kit assembly.
1
99-7337B KIT ASSEMBLY
ISO HEAD UNIT PROVISION
*Note: Refer also to the instructions included with the aftermarket radio.
A
Attach the ISO brackets to the radio
housing. (Figure A)
1
2
Slide the head unit into the bracket /
radio housing assembly and secure
using the ISO screws supplied with
the radio. (Figure B)
3
4
Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from
Metra or AXXESS. Re-connect the
negative battery terminal and test
the unit for proper operation.
B
Reassemble dash in reverse order of
disassembly.
Continue to final assembly.
2
99-7337B FINAL ASSEMBLY
FINAL ASSEMBLY
A
B
(A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
C
D
Locate the factory wiring harness in the dash. Metra recommends using the
proper mating adapter and making connections as shown. (Isolate and individ-
ually tape off the ends of any unused wires to prevent electrical short circuit.)
1
2
3
Re-connect the negative battery terminal and test the unit for proper operation.
Reassemble radio and dash assemblies in reverse order of disassembly.
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and
individually tape off ends of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc. . . . . . . . . . Red
Right Front (+) . . . . . . . . . . . . Gray
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer . . . . . . . . . . . . . . . . . Orange / White
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
3
99-7337B
NOTES
4
99-7337B
NOTES
5
99-7337B INSTRUCTIONS
1-800-221-0932
REV. 09/01/10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST99-7337B
|