NETGEAR Network Router JR6150 User Manual

Step 1.  
Unplug the power  
to turn off your modem.  
Step 2.  
Step 3.  
Plug in, then turn on your modem.  
Installation Guide  
Connect one end of the blue  
Ethernet cable to your modem,  
and the other end to the Internet  
port on your router.  
AC750 Wireless Dual Band Gigabit Router JR6150  
Package Contents  
Wait approximately 2 minutes  
until your modem turns on.  
If your modem has a battery backup,  
first remove and reinsert the battery  
before connecting your modem to power.  
DSL  
or Cable  
Internet  
AC750 Wireless Dual  
Band Gigabit Router  
Power  
On/Off  
AC750 Wireless Dual Band Gigabit Router  
Modem  
(not included)  
Step 4.  
Step 5.  
Connect the router  
to your computer.  
Step 6.  
Open a browser.  
Power adapter  
Ethernet cable  
Connect the power adapter to the  
router, then plug it into an outlet.  
Wait until the Wireless LED turns  
solid green.  
If the web page does not display,  
close and reopen the browser and  
in the address bar, or check the  
“Troubleshooting” chapter of the  
user manual.  
Use another Ethernet cable to establish  
a wired connection as shown in this diagram.  
If none of the LEDs light, make sure that the  
Power On/Off button is in the on position  
(pushed in).  
(Optionally) Connect wirelessly by using the  
preset wireless security settings located  
on the bottom label.  
 

MTD Spreader 439 305 User Manual
NAD Stereo Receiver 3240PE User Manual
NEC Projector PowerLite 30c User Manual
Netcom Network Router NB9 User Manual
Nikon Camera Lens 2190 User Manual
Old Town Canoe Co Boat Canoe User Manual
OWI Speaker IWT62 User Manual
Panasonic Car Stereo System CQ C7105U User Manual
Parasound TV Converter Box D AC 800 User Manual
Parkside Sander PBS 900 A1 User Manual