Nortel Networks Switch 8006 User Manual

Part No. 208290-B  
April 2000  
4401 Great America Parkway  
Santa Clara, CA 95054  
Installing the  
Passport 8006  
Chassis Fan Tray  
 
About This Guide  
This guide provides instructions for replacing a fan tray in the Passport8006 Chassis. For more  
information about the chassis, refer to Installing the Passport 8006 Chassis (part number 207313-B).  
You can replace a fan tray without turning off power to the chassis. To maintain proper cooling of the  
chassis, be sure to install the replacement fan immediately.  
Replacing a Fan Tray  
Required tool: Phillips screwdriver  
9590FA  
1. Loosen the retaining screws and pull the fan tray out of the chassis until the power connector  
disconnects from the backplane.  
Wait 10 seconds for the fans to stop turning, and then pull the tray out of the chassis.  
Caution: Grasp the fan tray at the middle of the front panel, and be careful to keep your  
fingers out of the fan blades.  
1
 
9591FA  
9592FA  
3. When the chassis power is on, verify that the  
green status LED is lit.  
2. Slide the new fan tray into the chassis and  
tighten the retaining screws.  
2
 

Miele Coffeemaker CM 5000 User Manual
Mr Heater Water Heater MH9B User Manual
Oki Printer 59296702 User Manual
Omega Vehicle Security Thermometer HH501AJ User Manual
Onkyo Stereo System TX SR700 User Manual
Optoma Technology Projector W304M User Manual
Oregon Scientific Heart Rate Monitor SE188 User Manual
Panasonic Blood Pressure Monitor EW280 User Manual
Panasonic Garage Door Opener CZ RD515U User Manual
Panasonic Network Card 2SB1218G User Manual