®
®
READ AND SAVE THESE
INSTALLATION INSTRUCTIONS!
READ AND SAVE THESE
INSTALLATION INSTRUCTIONS!
Accessory Switch
Accessory Switch
MODEL: HS-93
MODEL: HS-93
INSTALLATION
INSTALLATION
Used with Heat–Vent–Light
Combination.
Used with Heat–Vent–Light
Combination.
1. Install a double–gang box.
2. Refer to Figure 1. Run power wiring
from fuse box or circuit breaker and
wiring from heat–vent–light wires to
outlet box.
3. Secure all wires to outlet box with an
approved box connector.
4. Dress all leads, leaving
approximately 1/2" of bare wire for
making connections.
1. Install a double–gang box.
2. Refer to Figure 1. Run power wiring
from fuse box or circuit breaker and
wiring from heat–vent–light wires to
outlet box.
3. Secure all wires to outlet box with an
approved box connector.
4. Dress all leads, leaving
approximately 1/2" of bare wire for
making connections.
LIGHT
LIGHT
VENT
HEAT
VENT
HEAT
5. Refer to Figure 1. Make wire
connections. Observe cover plate
5. Refer to Figure 1. Make wire
connections. Observe cover plate
TO 120vAC, 60Hz
HOUSE POWER
TO 120vAC, 60Hz
HOUSE POWER
markings (Heat–Vent–Light) when
making connections. Make sure that
the switch and the unit it controls are
properly grounded.
markings (Heat–Vent–Light) when
making connections. Make sure that
the switch and the unit it controls are
properly grounded.
FIGURE 1
FIGURE 1
6. Refer to Figure 2. Using two supplied screws, secure switch bracket
assembly to outlet box adapter plate.
7. Position wall plate over switch assembly and secure with supplied screws.
6. Refer to Figure 2. Using two supplied screws, secure switch bracket
assembly to outlet box adapter plate.
7. Position wall plate over switch assembly and secure with supplied screws.
USE A SINGLE-GANG BOX
TO UNIT
USE A SINGLE-GANG BOX
TO UNIT
ADAPTER PLATE TO COVER
DOUBLE GANG BOX.
ADAPTER PLATE TO COVER
DOUBLE GANG BOX.
2 GANG
BOX
2 GANG
BOX
ADAPTER PLATE NOT
ADAPTER PLATE NOT
SUPPLIED WITH SWITCH.
SUPPLIED WITH SWITCH.
ADAPTER
PLATE
ADAPTER
PLATE
TO 120vAC,
60Hz HOUSE POWER
TO 120vAC,
60Hz HOUSE POWER
FIGURE 2
FIGURE 2
|