SPECIFICATION
DISPLAY ABBREVIATIONS
Temperature Stability:
Flow Control: No Flow Control
50 ppm/°C
ALR1 Alarm 1 Status
Screw terminals for RS-485/422
interface
OPERATION MANUAL
OFF
Alarm 1 set Off
ON
Alarm 1 set On
Alarm 1 High
Display:
6-digit, 7-segment LED, 101.6mm (4.00”)
with red, green and amber programmable
colors.
A1Md Alarm 1 Mode
NETWORK INTERFACE
10Base-T port (RJ45 connector)
Socket Port number: 1000
HTTP Port number: 80
A1LO Alarm 1 Low
A1HI
A1LH Alarm 1 Low/High
Alarm:
Alarm 1 & 2 programmable,
Latch/Unlatch, High, Low, High/Low
LO-1
Alarm 1 Low
-999.. Alarm 1 Low Value
..9999
-999.. Alarm 1 High Value
..9999
Power Supply:
100-240 Vac 10%, 50/60 Hz, 22.5 W
Standards Compliance:
IEEE 802.3 10Base-T
HI-1
Alarm 1 High
Operating Temperature: 0 to 40°C
Storage Temperature: -20 to 60°C
Relative Humidity: 0 to 85%
Supported Protocols:
TCP/IP, ARP, HTTPGET
A1CR Display color when Alarm 1 triggered
GRN
Green Color
REd
Red Color
SERIAL INTERFACE
AMbR Amber Color
Protection: NEMA-4x (IP65)
ALR2 Alarm 2 Status
Communication Standard:
RS485, RS422
Dimensions:
596.9 Lx 210.8 W x 95.4 D mm
(23.50" x 8.31" x 3.76")
OFF
Alarm 2 set Off
ON
Alarm 2 set On
Alarm 2 High
Transfer speed (Baud rate):
300, 600, 1200, 2400, 4800, 9600,
19200 bps
A2Md Alarm 2 Mode
Panel Cutout:
414.3 L x 179.4 W mm
(16.31” L x 7.06” W)
A2LO Alarm 2 Low
A2HI
A2LH Alarm 2 Low/High
Data Format:
7O1-7 bit, Odd, 1 stop bit, 7E1- 7 bit,
even, 1 stop bit
Weight:
3,175 g (7.0 lbs)
LO-2
Alarm 2 Low
-999.. Alarm 2 Low Value
..9999
-999.. Alarm 2 High Value
..9999
8N1 – 8 bit, No parity, 1 stop bit
Approvals:
CE per EN50081-1, EN50082-2,
EN61010-1
HI-2
Alarm 2 High
Multi-point Address (RS485):
0 to 199
A2CR Display color when Alarm 2 triggered
GRN Green Color REd Red Color
AMbR Amber Color
WARNING: These products are not designed for use in, and should not be used for, patient-
connected applications.
iLD46-EI
OUt
Alarm Latched/Unlatched selection
LAtC
Latched UNLA Unlatched
Big Display with
This device is marked with the international caution symbol. It is important to read the
Setup Guide before installing or commissioning this device, as the guide contains important
information relating to safety and EMC.
NO.CR Display Color in Normal condition
Embedded Ethernet
GRN
Green Color
REd
Red Color
It is the policy of OMEGA to comply with all worldwide safety and EMC/EMI regulations that apply.
OEMGA is constantly pursuing certification of its products to the European New Approach Directives.
OMEGA will add the CE mark to every appropriate device upon certification.
The information contained in this document is believed to be correct, but OMEGA Engineering, Inc.
accepts no liability for any errors it contains, and reserves the right to alter specifications without notice.
AMbR Amber Color
MOdE Data Flow Mode
HOSt
Host Mode
SLAV Slave Mode
300..
..19200
®
bAUd Baud Rate
Baud Rate Value
TRADEMARK NOTICE:
®
®
®
®
,
omega.com
,
, and
are Trademarks of
™
FORM Data Format
OMEGA ENGINEERING, INC.
7O1
7 Bit, Odd,
1 Stop Bit
8 Bit, No parity,
1 Stop Bit
7E1
7 Bit, Even,
1 Stop Bit
OMEGAnet® On-Line Service
Internet e-mail
8N1
WARRANTY/DISCLAIMER
OMEGA ENGINEERING, INC. warrants this unit to be free of defects in materials and workmanship for a period of
one (1) year from the date of purchase. In addition to OMEGA’s standard warranty period, OMEGA Engineering will
extend the warranty period for four (4) additional years if the warranty card enclosed with each instrument is
returned to OMEGA.
COMM Communication Standard
Servicing North America:
232
RS-232 Standard 485
RS-485 Standard
USA:
ISO 9001 Certified
One Omega Drive, P.O. Box 4047
Stamford CT 06907-0047
TEL: (203) 359-1660
AddR Device Address
0000.. Address Value
..0099
If the unit malfunctions, it must be returned to the factory for evaluation. OMEGA’s Customer Service Department will
issue an Authorized Return (AR) number immediately upon phone or written request. Upon examination by OMEGA,
if the unit is found to be defective, it will be repaired or replaced at no charge. OMEGA’s WARRANTY does not apply
to defects resulting from any action of the purchaser, including but not limited to mishandling, improper interfacing,
operation outside of design limits, improper repair, or unauthorized modification. This WARRANTY is VOID if the unit
shows evidence of having been tampered with or shows evidence of having been damaged as a result of excessive
corrosion; or current, heat, moisture or vibration; improper specification; misapplication; misuse or other operating
conditions outside of OMEGA’s control. Components which wear are not warranted, including but not limited to
contact points, fuses, and triacs.
FAX: (203) 359-7700
FAX: (514) 856-6886
INtF
Interface Device
DRN with
e-mail: [email protected]
Canada:
976 Bergar
dRNt
dRNP DRN with
Laval (Quebec) H7L 5A1
TEL: (514) 856-6928
e-mail: [email protected]
Temperature Input
Process Input
OMEGA is pleased to offer suggestions on the use of its various products. However, OMEGA neither
assumes responsibility for any omissions or errors nor assumes liability for any damages that result from
the use of its products in accordance with information provided by OMEGA, either verbal or written. OMEGA
warrants only that the parts manufactured by it will be as specified and free of defects. OMEGA MAKES NO
OTHER WARRANTIES OR REPRESENTATIONS OF ANY KIND WHATSOEVER, EXPRESS OR IMPLIED,
EXCEPT THAT OF TITLE, AND ALL IMPLIED WARRANTIES INCLUDING ANY WARRANTY OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE HEREBY DISCLAIMED. LIMITATION
OF LIABILITY: The remedies of purchaser set forth herein are exclusive, and the total liability of OMEGA with
respect to this order, whether based on contract, warranty, negligence, indemnification, strict liability or
otherwise, shall not exceed the purchase price of the component upon which liability is based. In no event
shall OMEGA be liable for consequential, incidental or special damages.
Miscellaneous:
PEAk Peak Value
PROC Process Value
OVLd Input Overload
VALL Valley Value
For immediate technical or application assistance:
RUN
Run Mode
USA and Canada:
Sales Service: 1-800-826-6342 / 1-800-TC-OMEGA®
Customer Service: 1-800-622-2378 / 1-800-622-BEST®
Engineering Service: 1-800-872-9436 / 1-800-USA-WHEN®
StOR Stored Message
1. In Slave Mode the Big Display will wait for
CONDITIONS: Equipment sold by OMEGA is not intended to be used, nor shall it be used: (1) as
a
“Basic
Mexico and
Latin American:
TEL: (001)800-TC-OMEGA®
En Español: (001) 203-359-7803
e-mail: [email protected]
FAX: (001) 203-359-7807
Component” under 10 CFR 21 (NRC), used in or with any nuclear installation or activity; or (2) in medical applications
or used on humans. Should any Product(s) be used in or with any nuclear installation or activity, medical application,
used on humans, or misused in any way, OMEGA assumes no responsibility as set forth in our basic
WARRANTY/DISCLAIMER language, and, additionally, purchaser will indemnify OMEGA and hold OMEGA harmless
from any liability or damage whatsoever arising out of the use of the Product(s) in such a manner.
commands and data from the Serial Bus.
2. In Host Mode the Big Display will send data
automatically and continuously into the Serial Bus.
3. When used in RS-485 Mode, the device must be
accessed with an appropriate Address Value.
4. Latched Mode: Alarm remains latched until reset.
To reset already latched alarm select any menu
items and then press “up” or “down” button.
Servicing Europe:
RETURN REQUESTS/INQUIRIES
Benelux:
Postbus 8034, 1180 LA Amstelveen, The Netherlands
TEL: +31 20 3472121
Toll Free in Benelux: 0800 0993344
e-mail: [email protected]
Direct all warranty and repair requests/inquiries to the OMEGA Customer Service Department. BEFORE
RETURNING ANY PRODUCT(S) TO OMEGA, PURCHASER MUST OBTAIN AN AUTHORIZED RETURN (AR)
NUMBER FROM OMEGA’S CUSTOMER SERVICE DEPARTMENT (IN ORDER TO AVOID PROCESSING
DELAYS). The assigned AR number should then be marked on the outside of the return package and on any
correspondence.
FAX: +31 20 6434643
The purchaser is responsible for shipping charges, freight, insurance and proper packaging to prevent breakage in
transit.
Czech Republic:
France:
Frystatska 184, 733 01 Karviná
TEL: +420 59 6311899
e-mail: [email protected]
FAX: +420 59 6311114
FOR WARRANTY RETURNS, please have the
following information available BEFORE
contacting OMEGA:
FOR NON-WARRANTY REPAIRS, consult OMEGA for
current repair charges. Have the following information
available BEFORE contacting OMEGA:
11, rue Jacques Cartier, 78280 Guyancourt
TEL: +33 1 61 37 29 00 FAX: +33 1 30 57 54 27
Toll Free in France: 0800 466 342
1. Purchase Order number under which the product
was PURCHASED,
1. Purchase Order number to cover the COST of the
repair,
2. Model and serial number of the product under
warranty, and
3. Repair instructions and/or specific problems
relative to the product.
2. Model and serial number of product, and
3. Repair instructions and/or specific problems
relative to the product.
e-mail: [email protected]
Germany/Austria:
Daimlerstrasse 26, D-75392 Deckenpfronn, Germany
TEL: +49 7056 9398-0
Toll Free in Germany: 0800 639 7678
e-mail: [email protected]
FAX: +49 7056 9398-29
OMEGA’s policy is to make running changes, not model changes, whenever an improvement is possible. This affords
our customers the latest in technology and engineering.
© Copyright 2002 OMEGA ENGINEERING, INC. All rights reserved. This document may not be copied, photocopied,
reproduced, translated, or reduced to any electronic medium or machine-readable form, in whole or in part, without
the prior written consent of OMEGA ENGINEERING, INC.
United Kingdom:
ISO 9002 Certified
One Omega Drive
River Bend Technology Centre
Northbank, Irlam Manchester M44 5BD United Kingdom
TEL: +44 161 777 6611 FAX: +44 161 777 6622
Toll Free in England: 0800 488 488
e-mail: [email protected]
PATENT AND TRADEMARK NOTICE: This product is covered by one or more of the following patents: U.S. Pat.
No. Des. 336,895; 5,274,577; 6,243,021/ CANADA 2052599; 2052600/ ITALY 1249456; 1250938/ GERMANY DE 41
34398 C2/ SPAIN 2039150; 2048066/ UK Patent No. GB2 249 837; GB2 248 954/ FRANCE BREVET NO. 91 12756.
Other U.S. and International Patents pending or applied for.
M3839/0403
|