3. The iConverter with the tab brackets should look
like the picture below (Fig. 1).
4. Attach unit to the desired surface using the
appropriate screws.
5. Follow any installation instructions in the iConverter
User Manual.
iConverter® Wall-Mounting Kit
User Instructions
Description and Inventory
The 8249-0 iConverter Wall-Mounting kit was
designed to attach one iConverter 1-Module or 2-
Module chassis to a wall, backboard or other flat
surface. The 8249-0 kit should include the following
hardware:
Wall Mounting Bracket
Fig. 1 1-Module Chassis with
Wall Mounting Kit
(2)
(4)
(4)
“L” shaped brackets
Flat head screws, 4-40, 1/4 inch
Wall mounting screws
Technical Support:
For help with this product,
contact our Tech. Support:
Phone: (949) 250-6510
Warning:
Before installing an iConverter chassis, make sure to
remove it from its power adapter. Make sure to
disconnect the power adapter from the AC line power.
Fax:
(949) 250-6514
Mounting:
1. Align the screw threads of the iConverter chassis
with the holes in the bracket.
Address: Omnitron Systems
2. Attach one “L” bracket on each side of the unit
using the 4-40 flat head screws enclosed with the kit.
040-08249-001C 12/03
|