PHL Audio Portable Speaker E17 User Manual

E17  
1060  
1070  
8  
PROFESSIONAL SERIES  
16 Ω  
6.5” Midrange Extended Drivers  
High Efficiency  
High Sounding Quality  
APPLICATIONS  
The main purpose of these models is sound reinforcement direct  
radiation multi-way systems when the low freq. extension required  
does not allow types SP1040/1050 to operate in good conditions.  
Designed with higher Xmax capability types SP1060/1070 can be  
X-overed from as low as 400 Hz when single or 300 Hz when used in  
pairs, and will then exhibit all their sound quality potential.  
FEATURES  
DESIGN CONCEPT  
Power handling capacity 130 W AES  
PROGRESSIVE WAVE DIAPHRAGM optimized for low-midrange  
Reference efficiency(1W @ 1m) 97 dB SPL  
extended frequency domain.  
SPL max (continuous)  
Usable frequency range 300-6000 Hz  
Environmental withstanding Outdoor  
114 dB SPL  
The M17/E17 Series design is based on the PROGRESSIVE WAVE  
DIAPHRAGM mechanical behavior of the radiating area.  
In this principle, the membrane is considered as a mechanical  
transmission line which should receive a constant given velocity  
together with critical damping properties to work properly.  
ARCHITECTURAL SPECIFICATIONS  
This leading edge technology offers substantial sonic advantages.  
Among them : very low mechanical energy storage in the cone  
(so avoiding standing waves) which ensures coherent sound, fast  
transients, stable sound imaging, high sensitivity, wide frequency  
range and very-low directivity pattern.  
NOMINAL DIAMETER :166 mm.  
FRAME : High tensile alloy pressure  
die-cast basket with patented  
INTERCOOLER SYSTEM.  
COMPACT MAGNET SYSTEM. Its design has been specially  
optimized to obtain maximum transducing efficiency while  
avoiding unlinear behavior such as coil inductance variation with  
position, flux modulation, harmonic distortion, rest position offset,  
air compression, and off-axis voice-coil pushing.  
MAGNET SYSTEM : 1.5”highly energized,  
heat extracting design with flux  
stabilizing ring.  
VOICE COIL : High-temperature  
stabilized copper-clad aluminum  
ribbon wound on vented,  
Its design incorporates a T-shaped pole piece, and a flux  
stabilization ring. It also takes into consideration demagnetization  
at cold temperatures.  
high-strength glass polyimide.  
INTERCOOLER SYSTEM (patented). Entirely integrated into the  
loudspeaker itself, the INTERCOOLER SYSTEM extracts the heat  
produced by Joule effect in the voice-coil by the means of an air  
flow directed through the heatsink rims of the basket by the  
motion of the dust-cap and the spider.  
CONE ASSEMBLY : High-strength cellulose  
fiber cone impregnated and  
front-coated with damped resins, fitted  
with fabric dome and high-speed flat  
damped surround.  
The gain brought about by this technology is over 20 % of extra  
power, so for example, a 3”coil according to this design has  
the same power handling capacity as a classical 4”one.  
SPEAKER MASS : 2.15 Kg.  
 

Peavey Guitar Patriot Plus User Manual
Pentax Film Camera 645N2 User Manual
Philips Hearing Aid ZA312B6A User Manual
Philips Laptop PET941D User Manual
Philips Printer Accessories MCB146 User Manual
Pioneer Car Stereo System DEH 6400BT User Manual
Planar Battery Charger BAT24SI User Manual
Planar Computer Monitor LC1502R User Manual
PQI Computer Drive U339S User Manual
PYLE Audio Microphone PDWM2300 User Manual