PVI Industries Water Heater PV 6112b User Manual

SPECIFICATION FOR DOMESTIC WATER HEATERS  
Power Combustion, Oil-Fired Water Heaters with Nickel-Plated Storage Tanks  
Furnish and install TURBOPOWER® oil water heater(s) as manufactured by PVI INDUSTRIES, INC  
of Fort Worth, Texas. Supply quantities and model numbers as indicated on the plumbing schedule.  
Efficiency  
The water heater will operate at a minimum of 83% thermal efficiency. The water heater will comply with paragraph  
7.2.4.4, the thermal efficiency, the standby loss, and all other requirements of ASHRAE 90.1-1999.  
Pressure Vessel and Heating Surfaces  
The water heater will be constructed and stamped in accordance with Section IV, Part HLW of the ASME code.  
The storage section of the water heater will be National Board Registered for a working pressure of ____ 125 psi  
(standard) or ____ 150 psi and will be pressure tested at 1-1/2 times working pressure. The heating section of the water  
heater will be National Board Registered for a working pressure of 150 psi and will be pressure tested at 1-1/2 times  
working pressure.  
The heat exchanger will be a firetube design with the combustion chamber and all heating surfaces completely  
water-backed. The fireside of the combustion chamber will be of boiler-grade steel. The waterside of the combustion  
chamber will be non-ferrous. The fire tubes will be solid copper. The heating surfaces will be removable by unbolting  
from the pressure vessel, allowing 100% access to waterside surfaces. The tank will be accessible in the field through a  
manway sized opening, allowing access to 100% of interior surfaces. All tank connection fittings will be nonferrous and  
removable from the tank.  
Tank Lining  
The tank will be a plated with electroless nickel (EN). Plating will occur after the pressure vessel is completely  
fabricated and all welding is completed. The EN plating will be a high-phosphorus (10%) and nonporous composition  
suitable for submersion service (ASTM B733 standard may be used as a guideline). For additional protection against  
galvanic corrosion, which may occur within the potable water system, the electroless nickel plating may have a high-  
dielectric-strength polymer overcoat.  
The lined tank will not require sacrificial anode rods and none will be used. Water heaters that use anode rods in a  
vessel that contains non-ferrous heating surfaces will not be acceptable.  
Burner and Venting  
Combustion will be provided by a forced-draft power burner with an oil train meeting the following agency  
requirement for the input specified:  
___ UL (standard)  
___ FM  
___ IRI  
___ Other ______________________  
Burner will be configured to accept ____ room air _____ direct inlet combustion air.  
(continued)  
PV 6112b 6/03  
1
 

Pentax Digital Camera MZ 60 User Manual
Pentax Home Safety Product AF540FGZ User Manual
Philips Humidifier SC580 User Manual
Philips Indoor Furnishings SILHOUETTE Series User Manual
Philips Network Card 0910L2S User Manual
Philips Surge Protector SPP1188WA User Manual
Philips Work Light PLUS T8 User Manual
Polycom Telephone 1725 11240 001 User Manual
Poulan Lawn Mower 173282 User Manual
Powermate Portable Generator PM0401854 User Manual