INSTRUCTION MANUAL
IN DASH COLOR TT-LCDMONITOR
PLVS420
4 INCH SUNVISOR TFT-LCD MONITOR
OPERATION
1.Connect the monitor power input plug to a DC power source
(Red plug +12 VDC, Black plug(-) to ground).
2.Connect the external video source output signal (from VCD,
DVD, TV etc.) To the VIDEO in jack.
3.Press power button to turn the monitor on and off. The backlight
for the button will turn brighter.
4.Press the menu button to activate the picture display characteristics
adjustment.
5.Press the + button to increase the selected adjustment level or
press the - button to decrease the level.
6.Press V1/V2 button to switch between two video signals.
INSTALLATION
Installation will vary from vehicle to vehicle, as headrests in
vehicles are not standard.
PRECAUTION
To prevent short-circuiting of the electrical system and cause
serious damage to the unit or the vehicle, you are advised to
follow the instructions carefully.
Should there be requirement to replace blown fuse, do
remember to disconnect all power supply and switch
the unit before replacing it with a new one. Use only correct
rating fuse to avoid damaging the unit.
During operation, if there is symptom of over-heating or
system mal-function,do switch off the unit and consult your
dealer immediately. Please do not attempt to open up the
unit since there is no serviceable parts inside.
Do not drop the LCD display panel or subject it to direct
impact.
If the LCD panel is broken, do avoid all human contact
to the broken glasses or fluid leaked out from the enclosure.
If come into contact ,do flush and clean affected areas with
plenty of water. Seek medical attention immediately.
The battery life of the remote control unit is about six months
long. To ensure effective control, please replace the batteries
regularly.
Do not use any chemical solvent, cleaning agent or corrosive
detergent to clean away dirt on the surface of the screen.
By doing so, you may cause irreversible damage to the surface
of the TFT screen. To clean off dirt or finger prints, use a soft
damp lens cleaning cloth.
When operating the display unit, avoid touching or pressing
the LCD glass panel Excessive force may cause irreparable
damage to the LCD screen.
Ensure no metal or foreign materials are dropped in between
the display screen and enclosure. Obstacles may impeach
smooth running of the tray and may cause electrical shocks.
FRONT PANEL
1.power indicator
2.power On/Off
3.menu
1
2
3
4
5
6
7
4.positive adjustment
5.negative adjustment
6.menu select up
7.menu select down
8.IR
8
9
9.video input
REMOTE CONTROL
1.menu
2.power on/off
3.game -
4.game +
MENU
ON/OFF
GAME
1
3
2
5.volume -
6.volume +
7.sleep
4
VOLUME
GAME
5
6
MUTE
SLEEP
DISPLY
8.game
7
9
9.mute switch
10.display mode
PICTURE
RECALL
10
12
11.image up/down/left/right reverse
12.factory default setting
REMOTE CONTROL
Technical Specification
Screen size:
System:
4 inch(Diagonal length)
PAL & NTSC
Display Method:
Resolution:
Power supply:
TFT active matrix system
390x282 dots
DC 12V
Power consumption: 8W
Dimension: 210 X129 X 30mm
WIRING
Black:power input
Yellow:video 1 input
|