PYLE Audio Music Pedal PPDLEQB1 User Manual

PPDLEQB1  
BASS GUITAR  
EQUALIZER  
CONTROLS  
1. The 7-band EQ Faders allow boosting/cutting single  
frequency ranges from 50 Hz to 10 kHz at+/-15 dB.  
2. The LEVEL fader adjusts the output level. It can be used  
to achieve effective volume boost or cut .  
3. The ON/BATT LED illuminates when the effect is  
activated. It also serves as a battery level indicator.  
4. Use the Footswitch to activate/deactivate the effect.  
5. Use this 1/4 TS IN connector to plug in the instrument  
cable.  
6. The 1/4 TS OUT connector sends the signal to your amp.  
Use the DC IN connection to plug in a 9v power supply (not included). The Battery Compartment is  
located underneath the pedal cover. To install or replace the 9v battery, press the hinges with a pen  
and remove the pedal cover.  
This effects pedal has no on/off switch. As soon as you insert the jack into the Input connector, the  
pedal will turn on. When not in use, remove the jack from the input connector to save the batteries.  
SPECIFICATIONS  
Input Connector: 1/4 TS Impedance 500k  
Output Connector: 1/4 TS Impedance 1k  
Power Supply: 9V, 100mA DC regulated  
Power Connector: 2mm DC Jack, Negative Center  
Battery: 9v Type 6LR61  
Power Consumption: 30mA  
Dimensions: 4.9”D x 2.76”W x 2.12”H  
Weight approx. 0.33kg (0.73lbs)  
SAFETY INSTRUCTIONS  
Do not use near water, or install near heat sources. Use only authorized attachments / accessories.  
Do not service product yourself. Contact our service department with any questions or to schedule  
repair service.  
 

Philips Clock Radio AJ3540 05 User Manual
Philips DVD Recorder DVDR77 17 User Manual
Philips Switch 31602 16 User Manual
Philips Toaster HD2528 User Manual
Philips TV Cables SWV7543W User Manual
Pitney Bowes Postal Equipment SV62214 User Manual
Planet Technology Network Card BT 200U User Manual
Poulan Tiller 411045 User Manual
Poulan Trimmer TWIST N EDGEt User Manual
Proxima ASA Projector 4100 4200 User Manual