C1956M-A (10/03)
RMA14S
Rack Mount Kit
®
3500 Pelco Way
Clovis, CA 93612-5699
USA
WARNINGS
Observe the following warnings before installing and using this product.
In North America & Canada:
Tel (800) 289-9100
1. Installation and servicing should be done by qualified service and installation personnel only.
FAX (800) 289-9150
2. Installation should be done according to all local and national electrical and mechanical
codes, using only approved materials.
International Customers:
Tel (1-559) 292-1981
FAX (1-559) 348-1120
3. Use only installation methods and materials capable of supporting four times the maximum
weight of the monitor and rack mount.
Please thoroughly familiarize yourself with the information in this manual prior to installation.
DESCRIPTION
The RMA14S Rack Mount Kit holds a single Sony SSM14N1U Monitor. The rack mount will fit
any standard 19-inch (48.26 cm) wide console or rack configuration and will securely hold the
monitor in place in a console to a maximum of a 30-degree slant.
INSTALLATION
To install the rack mount kit and monitor:
NOTE: Installation of the rack
mount, with monitor installed, into
the rack or console may require
two people.
1. Assemble the rack mount kit’s sides and bottom as shown in Figure 1 using the supplied
screws. While assembling, install the screws loosely until these components are attached
and then finish by tightening all the screws.
2. Install the top cross brace on the top of the rack mount with six of the screws provided. Just
start the screws but do not tighten.
3. While pushing up firmly on the bottom of the top cross brace, tighten the screws. (If you do
not push upward to take out the slack, the monitor will not fit.)
SHOWN FOR CLARITY ONLY
6
2
5
1
4
3
6
6
Figure 1. RMA14S Rack Mount Kit Assembly
|