Peripheral Electronics Car Satellite Radio System IS77 User Manual

Expand Your Factory Radio  
to your car’s FM stereo  
iPod®  
MP3 Players  
other  
audio sources  
Universal
Owner’s Manual  
For  
Factory  
Radio  
Aftermarket  
Radio  
IS77
OR  
®
Peripheral Electronics ,  
a division of AAMP of America™  
13160 56th Court Clearwater, Florida 33760  
Ph. 800-477-2267 ext. 230  
©2009 AAMP of Florida, Inc.  
Rev. 10-28-08  
 
1. Introduction  
Thank you for choosing the iSimple IS77 as your audio input solution. The IS77 is designed to  
provide the connecting link between your audio source and your FM radio. Using the supplied  
accessories, you can connect virtually any audio source into any FM equipped radio. This  
interface has a universal input that can be configured to accept an audio signal from any source  
with an RCA connection or a standard 3.5mm “Headphone” output.  
The IS77 will route the audio from your device through your factory or aftermarket radio not  
equipped with a built in auxiliary input. If your audio source is an iPod featuring a docking  
connector, this interface will also charge the iPod’s battery, when connected.  
2. IS77 Components  
• One Radio Input Interface  
• One 3.5 mm to 3.5 mm Audio Cable (4ft.)  
• One 3.5mm to RCA adapter  
• One Power Cable with a On/Off Switch  
• One iPod Audio/Video Cable Outputs (5ft.)  
• One “factory look” 3.5mm Dash/Panel Mount Audio Input Cable (6ft.)  
3. Installation Options  
(Choose A or B)  
A. Connecting an iPod  
iPod  
(not included)  
Connect To  
SWITCH  
Connect To  
iPod  
Connects to  
On/Off Switch  
Fuse  
Antenna Out*  
Fuse  
Connects to iPod  
PURI  
MENU  
iPod Audio Cable  
(5 ft.)  
Antenna In *  
iPod Specific installation instructions  
1) Connect the two audio connectors from the iPod cable to the audio inputs on the PURI.  
2) Connect the two-pin power connector on the iPod cable to the connector labeled  
“Connect to iPod” in the PURI wiring harness.  
3) The Yellow connector from the iPod cable is intended for video playback from iPods that  
support this function. Route this Video connection to any video display that is not in view  
of the driver while operating the automobile.  
4) Route the iPod connector to your chosen iPod location in your automobile. Common  
locations are the glove box, center console or in a mounted iPod cradle. You will need to  
access the iPod in order to change music selections, etc..  
1
 
B. Connecting a Source with a Headphone or Line Output  
iPod Conection  
Connect To  
Connects to  
Not USE  
SWITCH  
On/Off Switch  
Antenna Out*  
MP3  
(not included)  
Fuse  
3/8hole  
OR  
PURI  
3.5 mm to 3.5 mm  
Audio Cable (4 ft.)  
“factory look” 3.5 mm  
Dash/Panel Mount  
3.5 mm to RCA  
Adapter  
Antenna In *  
Audio Input Cable (6 ft.)  
audio source  
(not included)  
Installing the 3.5 Dash Panel Mount Audio Input  
3/8”  
“factory look” 3.5 mm Dash Panel Mount Audio input(6 ft.)  
3.5 mm to 3.5 mm Audio Cable (4 ft.)  
1) Choose mounting position of dash mount  
audio input and carefully drill 3/8” mounting  
hole. Install connector.  
2) Connect your audio device to the newly  
installed audio input via the supplied 3.5 mm  
to 3.5 mm connection cable.  
4. Radio Input Interface (PURI)  
Installation  
Radio Tuning Frequency  
Antenna Out  
Use to select best operating  
toFM radio*  
frequency for your area  
Antenna Input  
Factory or Upgraded Radio*  
from vehicle antenna*  
TOP VIEW  
Audio Input  
Left & Right  
Ground Connection  
Connect toa cleanground point  
On/Off Switch  
3/4mountinghole  
Connects to Power Source  
ACC 12VDC  
2A Fuse  
Power whenkey-on  
* Antenna Adapter May be Required  
2
 
PURI Gain Adjustment  
BACK VIEW  
LEVEL  
+
L
H
Gain Adjustment  
Use to match volume of PURI  
to volume of FM radio stations  
1) The PURI is designed to install Inline with the radio antenna connection usually located  
on the back of the radio in the dash. In some cases this connection may be at a remote  
radio tuner location. Consult vehicle manufacturer’s information in these cases.  
2) Some antenna connections require the use of an antenna adapter in order to connect to  
the PURI. These adapters are available from most car audio installation retailers.  
3) Select the FM frequency where you will access your new audio device. On the side of  
PURI where the label indicates “Tuning Frequency” there is a two position switch. Note  
the position of the switch before installing the interface.  
If you have a local radio station that occupies either of these frequencies (87.9 or 88.3)  
please move the switch to the position that does NOT match the local station.  
The position of this switch determines the frequency where you will access your new audio  
input. We recommend choosing one option, and setting one of the radio’s preset buttons  
to represent that station. This easily accesses your auxiliary audio input by pressing the  
preset button.  
Using a Multimeter, identify 12V+ and Ground wires behind the radio.  
a. Connect the PURI Red wire to 12V+ (Ignition)  
b. Connect the PURI Black wire to Ground  
c. Connect the vehicle’s antenna into the PURI antenna input*  
d. Connect the PURI antenna output into the radio*  
*A vehicle specific antenna adaptor may be required to make these connections  
The rocker switch supplied with the PURI will turn the device on and off. When the switch  
is in the on position, the PURI will interrupt the incoming antenna signal to deliver the  
cleanest signal possible from your device through your FM radio. To regain standard FM  
reception, move the switch to the Off position.  
4) Once the PURI is installed correctly, be sure to properly set the audio level. When set  
correctly, the audio level of the PURI will match the volume of typical FM radio stations.  
3
 
5. Troubleshooting  
Symptom Cause  
Remedy  
Move rocker switch to ON position  
No Audio from the  
1) IS77 is turned off  
Aux source  
2) Connection cables are discon-  
nected  
Check all interconnects for proper con-  
nection  
3) The radio is not on the correct  
station  
Verify that the FM radio is tuned to the  
frequency on the side of the interface.  
iPod does not  
charge  
1) The power connection on the  
IS77 is disconnected  
Connect power cable according to Con-  
figuration 1 in Section 3  
2) The fuse may be blown in the  
power plug on the iPod specific  
connection cable  
If fuse is blown, replace with equivalent  
fuse  
Noise / Static  
1) Improper selection of IS77  
frequency  
Tune to the frequency specified on the  
side of the IS77 interface.  
2) local radio station is interfering  
with the Auxiliary input device  
Change the frequency setting on the  
side of the IS77 to the other position,  
and use the new frequency to access  
the audio source  
Low audio  
1) the volume is down on the audio Turn up the volume on the source to en-  
source  
sure best sound quality through the IS77  
The IS77 Gain is set too low  
Adjust the gain setting on the back side  
of the IS77  
For Best Performance Have It  
Professionally Installed.  
iPod is a trademark of Apple Inc., registered in the U.S. and other countries.  
iPhone is a trademark of Apple Inc.  
4
 
6. Warranty Information  
One Year Limited Warranty  
The quality controls used in the manufacture of this product will ensure your satisfaction.  
This warranty applies only to the original purchaser of this product from an authorized  
Peripheral Electronics dealer. This warranty covers any supplied or manufactured parts of  
this product that, upon inspection by Peripheral Electronics authorized personnel, is found to  
have failed in normal use due to defects in material or workmanship. This warranty does not  
apply to installation expenses. Attempting to service or modify this unit, operating this unit  
under conditions other than the recommended voltage will render this  
WARRANTY VOID.  
Unless otherwise prescribed by law, Peripheral Electronics shall not be liable for any per-  
sonal injury, property damage and or any incidental or consequential damages of any kind  
(including water damage) resulting from malfunctions, defects, misuse, improper installation  
or alteration of this product. All parts of this Peripheral Electronics product are guaranteed  
for a period of 1 year as follows:  
Within the first 12 months from date of purchase, subject to the conditions above, Peripheral  
Electronics will repair or replace the product at their discretion, if it is defective in material  
or workmanship providing it is returned to an Authorized Peripheral Electronics’ dealer, with  
PROOF OF PURCHASE from an authorized Peripheral Electronics dealer.  
Warning:  
This equipment may be reset by unintentional electrostatic discharge during operation.  
Exposure to direct sunlight or extreme heat may cause damage or malfunction.  
FCC Class B Radio Frequency Interference Statement  
This equipment has been tested and found to comply with the limits for a Class B digital  
device, pursuant to Part 15 of FCC rules. These limits are designed to provide reasonable  
protection against harmful interference in a residential installation. This equipment gener-  
ates, uses, and can radiate radio frequency energy and, if not installed and used in accor-  
dance with the instructions, may cause harmful interference to radio communications.  
However, there is no guarantee that interference will not occur in a particular installation. If  
this equipment does cause harmful interference to radio or television reception, which can  
be determined by turning the equipment off and on, the user is encouraged to try to correct  
the interference by one or more of the following measures:  
1. Re-orientate or relocate the receiving antenna.  
2. Increase the separation between the equipment and receiver.  
3. Connect the equipment into an outlet on a circuit different from that of which the receiver  
is connected.  
4. Consult the dealer or an experienced radio / television technical for help.  
Notice : The changes or modifications not expressly approved by the party responsible com-  
pliance could void the user authority to operate the equipment.  
5
 
®
Peripheral Electronics ,  
a division of AAMP of America™  
13160 56th Court Clearwater, Florida 33760  
Ph. 800-477-2267 ext. 230  
©2009 AAMP of Florida, Inc.  
 

Peavey Music Mixer XR 600F User Manual
Philips Indoor Furnishings 30185 16 User Manual
Pioneer Bluetooth Headset BDP LX70A User Manual
Pioneer CD Player DEH P4600MP User Manual
Pioneer DVD Player DV PT100 User Manual
Planet Technology Network Router WRT 415 User Manual
Plinius Audio Car Amplifier Anniversary Integrated Amplifier User Manual
Powermate Portable Generator PM400911 User Manual
Printronix Printer T5000e Series User Manual
PVI Industries Water Heater 20 N 125A MXS User Manual