e Do not use this apparatus near water.
1 Important
f Clean only with dry cloth.
g Do not block any ventilation openings.
Install in accordance with the
manufacturer's instructions.
Safety
h Do not install near any heat sources such
as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that
produce heat.
Know these safety symbols
i Only use attachments/accessories
specified by the manufacturer.
j Refer all servicing to qualified service
personnel. Servicing is required when
the apparatus has been damaged in any
way, such as power-supply cord or plug
is damaged, liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or
moisture, does not operate normally, or
has been dropped.
This 'bolt of lightning' indicates uninsulated
material within your unit may cause an electrical
shock. For the safety of everyone in your
household, please do not remove product
covering.
The 'exclamation point' calls attention to
features for which you should read the enclosed
literature closely to prevent operating and
maintenance problems.
WARNING:To reduce the risk of fire or electric
shock, this apparatus should not be exposed to
rain or moisture and objects filled with liquids,
such as vases, should not be placed on this
apparatus.
k Apparatus shall not be exposed to
dripping or splashing.
l Do not place any sources of danger on
the apparatus (e.g. liquid filled objects,
lighted candles).
m Where the plug of the Direct Plug-in
Adapter is used as the disconnect device,
the disconnect device shall remain readily
operable.
CAUTION:To prevent electric shock, match
wide blade of plug to wide slot, fully insert.
Warning
• Never remove the casing of this apparatus.
• Never lubricate any part of this apparatus.
• Never place this apparatus on other electrical
equipment.
Important Safety Instructions
a Read these instructions.
b Keep these instructions.
c Heed all warnings.
d Follow all instructions.
2
EN
Your product contains batteries,which cannot be
disposed of with normal household waste.Please
inform yourself about the local rules on separate
collection of batteries.The correct disposal of batteries
helps prevent potentially negative consequences on
the environment and human health.
additional information on a recycling center in
your area.
Notice
Any changes or modifications made to this
device that are not expressly approved by
Philips Consumer Lifestyle may void the user’s
authority to operate the equipment.
Notice for the USA
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation.This equipment generates,
uses, and can radiate radio frequency energy
and, if not installed and used in accordance
with the instruction manual, may cause harmful
interference to radio communications.
Always bring your product to a professional to
remove the built-in battery.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or
more of the following measures:
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by a
specialized company. Please observe the local
regulations regarding the disposal of packaging
materials, exhausted batteries and old equipment.
•
•
Relocate the receiving antenna.
Increase the separation between
equipment and receiver.
•
•
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced
radio/TV technician for help.
Disposal of your old product
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
Never dispose of your product with other
household waste. Please inform yourself about
the local rules on the separate collection of
electrical and electronic products and batteries.
The correct disposal of these products helps
prevent potentially negative consequences on
the environment and human health.
The making of unauthorized copies of copy-
protected material, including computer programs,
files, broadcasts and sound recordings, may be
an infringement of copyrights and constitute a
criminal offence.This equipment should not be
used for such purposes.
Note
• The type plate is located on the bottom of the apparatus.
EN
3
2 Your Bluetooth
Speaker
Overview of the main unit
a
b
c
Congratulations on your purchase, and
welcome to Philips!To fully benefit from the
support that Philips offers, register your product
f
g
d
e
Introduction
a ON/OFF
•
Turn on/off the unit.
With this speaker, you can enjoy audio from the
compatible Bluetooth device or other audio
devices.
b
c
/
•
Adjust volume.
•
•
Press to play/pause in Bluetooth mode.
Press for 2s to wake up your speaker
from standby mode.
What's in the box
Check and identify the contents of your
package:
•
Press for 8s to erase all connection
information stored on Bluetooth
module.
•
•
•
Main unit
1 x USB cable
Quick start guide
d DC IN 5V-1A
Charge your Bluetooth speaker
through the USB cable.
•
e MP3-LINK
•
Connect an audio device.
f Built-in battery indicator
•
Steadily on when charging.
•
Flashes when the battery level is low.
g Bluetooth indicator
•
Steadily on when the speaker is connected
with Bluetooth compatible device.
Flashes when disconnected Bluetooth
pairing.
•
4
EN
Built-in Battery
3 Get started
The speaker can also operate on built-in
rechargeable battery.
To recharge the built-in battery:
Caution
•
Connect the speaker to the power supply.
• Use of controls, adjustments, or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Note
•
Use only the supplied USB cable to charge the battery.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus.The
model number and serial number are on the
bottom of the apparatus.Write the numbers
here:
Turn on
•
Switch ON/OFF on the speaker to the
Model No. __________________________
Serial No. ___________________________
ONposition.
» The Bluetooth indicator flashes (blue).
Switch to standby mode
Connect power
The speaker switches to standby mode in the
following situations.
Caution
•
•
•
In Bluetooth mode: no audio signal from
your Bluetooth device over 15 minutes.
In MP3 link mode: no audio signal
detected over 15 minutes.
• Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back of the speaker.
Connect the AC power adaptor to:
The battery level is low.
•
the power supply socket on the back of
the speaker.
Note
•
the wall power outlet.
• The Bluetooth connection will be terminated when the
speaker enters standby mode, you can wake up the
speaker by hold
for 2 seconds.
DC IN
5V . 1A
EN
5
Play from a PC
4 Play
You can also listen to audio through Bluetooth
in PC.
Note
Play from a Bluetooth device
• Make sure that you have installed Bluetooth driver in
your PC before pairing.
• The steps below are only for windows 7 operating
system. If you use windows XP , refer to windows XP
help.
You can listen to a Buetooth device through this
speaker.
Note
1 Switch ON/OFF to turn on Bluetooth
function of the speaker.
• The effective operation range between the speaker
and your Bluetooth device is approximately 10 meters
(30 feet).
» The Bluetooth indicator flashes.
2 Activate the Bluetooth function in your PC.
1 Switch ON/OFF to turn on Bluetooth
function of the speaker.
3 Add a Bluetooth device in your PC and
select "PHILIPS SBT75" for pairing.
» The speaker gives out 2 beeps and the
Bluetooth indicator steadily on.
» The Bluetooth indicator flashes.
2 Activate the Bluetooth function in your
Bluetooth device (see the device user manual).
4
Set "PHILIPS SBT75" as default
communication device in your PC.
1). Right click the speaker icon ( ) in the
lower right corner of the Windows home
screen and select "Playback Devices" from
the option menu
3 Select "PHILIPS SBT75" on your device for
pairing.
» The speaker gives out 2 beeps and the
Bluetooth indicator steadily on.
•
For former devices, you need to input
"0000" as pairing password.
2). Right click desired speaker and select
"Set as Default communnication Device".
4 Start music play on your Bluetooth device .
5 Start music play on your PC .
PHILIPS SBT75
PIN
0000
6
EN
5 Product
information
Play from an external device
You can also listen to an external audio device
through this speaker.
Note
Note
• Product information is subject to change without prior
notice.
• Your speaker can play under MP3-LINK audio only
when the Bluetooth paused or stopped.
1 Connect the MP3-LINK cable to:
•
the MP3-LINK socket (3.5mm) on the
back of the speaker.
the headphone socket on an external
device.
Specifications
•
Amplifier
2 Start to play on the device.
Rated Output Power
Signal to Noise Ratio
Aux-in Link
2 x 2 W RMS
>67 dB
600 mV RMS 20
kohm
MP3-LINK
General information
DC power input
Operation Power
Consumption
Input: 5V, 1A;
3W
Standby Power
Consumption
<0.5W
Dimensions - Main Unit
(W x H x D)
Weight- Main Unit
Control play
184 x 62 x 63mm
0.388 kg
During play,
•
press VOL +/- to increase or decrease the
volume level.
•
press
to play or pause.
» Available only in Bluetooth mode.
EN
7
6 Troubleshooting
Warning
• Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site (www.
philips.com/welcome).When you contact
Philips, ensure that the apparatus is nearby
and the model number and serial number are
available.
No power
•
When use build-in battery only, make sure
that the power is sufficient.
•
When use AC power plug, make sure that
the plug is connected properly, and there is
power at the AC outlet.
No sound
•
Adjust the volume.
No response from the speaker
•
Restart the speaker.
8
EN
EN
9
Specifications are subject to change without notice
© 2012 Koninklijke Philips Electronics N.V.
All rights reserved.
SBT75_37_UM_V1.0
|