Philips Clock Radio AJ3112 12 User Manual

AJ3112_IFU_12_Eng 3/29/10 15:54 Page 1  
AJ3112  
Clock Radio  
Register your product and get support at  
User manual  
 
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 3  
English  
Congratulations on your purchase and welcome to Philips!  
To fully benefit from the support that Philips offers, register your  
CONTROLS (see fig. 1 )  
1 DISPLAY - shows the clock/ alarm time and status of the set  
2 ALARM indicator - lights up when alarm is activated  
3 Frequency indicator - shows the radio frequency of your selected waveband  
4 REPEAT ALARM / SLEEP OFF  
- switches off the active alarm for a 8-9 minute period  
- switches off the sleep function  
5 CLOCK - sets the clock time  
6 SLEEP  
- activates the radio for sleep function  
- adjusts the sleep period  
7 ALARM RESET  
- stops the active alarm for 24 hours  
8 ALARM - sets the alarm function  
9 RADIO / ALARM  
RADIO ON: switches on the radio  
RADIO OFF: switches off the radio/alarm  
ALARM - RADIO: activates the radio for alarm  
ALARM - BUZ: activates the buzzer for alarm  
0 SET TIME HR / MIN  
- adjusts the hours / minutes for clock / alarm / sleep time  
! Power cord - connects to wall outlet  
@ Pigtail - improve FM reception  
# VOLUME - adjusts the sound level  
$ Battery door - opens to store a 9 volts 6F22 battery (not included) for clock  
memory backup.  
% FM/MW - selects FM/MW waveband  
^ TUNING - tunes to radio stations  
 
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 4  
INSTALLATION  
POWER SUPPLY  
1
Check if the power supply, as shown on the type plate located on the bot-  
tom of the set, corresponds to your local power supply. If it does not, consult  
your dealer or service center.  
2
3
Connect the plug to the wall outlet.  
To disconnect the set from the power supply completely, remove the  
plug from the wall outlet.  
CLOCK MEMORY BACKUP  
The clock memory backup allows your alarm and clock time settings to be stored  
for up to a day when there is a power interruption e.g. power failure. The com-  
plete clock radio and display illumination will be switched off. As soon as the  
power supply returns, the display will indicate the correct time.  
1
2
Remove the battery door to insert a 9 volts 6F22 type battery (not included)  
for backup.  
Replace the battery door.  
NOTE: If no backup battery is installed or the power interruption is prolonged,  
you will need to set the clock and alarm times again.  
Batteries contain chemical substances so they should be disposed of  
properly.  
 
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 5  
RADIO  
You can use this set solely as a radio!  
1
2
3
4
5
Adjust RADIO / ALARM to RADIO ON to switch on the radio.  
Select your waveband by adjusting the FM/MW switch  
Adjust TUNING to tune to your desired station  
Turn the VOLUME control to adjust the volume level  
Adjust RADIO / ALARM to OFF to switch off the radio.  
.
.
.
To improve reception:  
FM:  
MW:  
Extend and position the pigtail fully to obtain optimal reception.  
uses a built-in antenna inside the set. Direct the antenna by adjust-  
ing the position of your set  
.
SETTING THE CLOCK / ALARM TIME  
The time is displayed using the 24-hour clock.  
1
2
Hold down CLOCK or ALARM.  
Press HR or MIN repeatedly, or hold down HR or MIN to adjust minute  
and/or hour.  
3
Release CLOCK or ALARM and HR or MIN when you reach the correct set-  
ting.  
The set clock time will show on the display and start to run.  
 
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 6  
SELECTING THE ALARM MODE  
To use the alarm, you must set the alarm time first. You can choose from two  
different alarm modes to wake you up: by radio or buzzer.  
1
Select your choice of alarm mode by adjusting RADIO / ALARM to RADIO or  
BUZ  
The alarm indicator (AL) will light up.  
.
Helpful Hint:  
If you have selected the radio mode, make sure you have adjusted the vol-  
ume loud enough to wake you.  
The buzzer is set at a fixed volume and cannot be adjusted.  
SWITCHING OFF THE ALARM  
There are three ways of switching off the alarm. Unless you cancel the alarm  
completely, the 24 hour alarm reset option will be automatically selected after  
1 hour and 59 minutes, from the time your alarm time first goes off.  
24 HOUR ALARM RESET  
If you want the alarm mode to be stopped immediately but also wish to retain  
the same alarm setting for the following day:  
Press ALARM RESET during the alarm call.  
The alarm indicator (AL) will remain on.  
CANCELING THE ALARM COMPLETELY  
To cancel the set alarm time before it goes off, or during the alarm call:  
Adjust RADIO / ALARM to OFF position.  
The alarm indicator (AL) will light off.  
 
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 7  
REPEAT ALARM  
This repeats your alarm call at 9-minute intervals.  
1
During the alarm call, press REPEAT ALARM SLEEP OFF.  
The alarm indicator (AL) will remain on.  
/
SLEEP  
This set has a built-in timer which enables the set to be automatically switched  
off during radio playback after a set period of time. This allows you to lie back,  
listen and fall asleep. The maximum sleep time is 1 hour and 59 minutes.  
Setting SLEEP  
1
2
Set RADIO / ALARM to OFF position.  
Set the sleep time to activate sleep function by selecting on the following  
ways:  
Simply press SLEEP to set your sleep time to 59 minutes.  
Hold down SLEEP, and press MIN repeatedly to adjust sleep time from 59  
minutes downward.  
Hold down SLEEP and press HR to get one more hour sleep time (1:59)  
To cancel sleep, press REPEAT ALARM SLEEP OFF.  
/
Notes for battery disposal  
Your product contains batteries covered by the European  
Directive 2006/66/EC, which cannot be disposed with normal  
household waste. Please inform yourself about the local rules on  
separate collection of batteries because correct disposal helps to  
prevent negative consequences for the environmental and human  
health.  
 
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 8  
SAFETY INFORMATION  
Install the unit near the AC outlet and where the AC plug can be easily  
reached.  
Where the MAINS plug is used as the disconnect device, the disconnet device  
shall remain readily operable.  
Place the set on a hard and flat surface so that the system does not tilt.  
If you do not intend to use the set for a long time, withdraw the power plug  
from the wall outlet. In addition to this, it is advisable to remove the battery  
from the clock radio. This will prevent any danger of leakage and the clock  
radio will not be damaged.  
Do not expose the set, batteries to humidity, rain, sand or excessive heat  
caused by heating equipment or direct sunlight.  
The apparatus shall not be exposed to dripping or splashing.  
Adequate ventilation with a minimum gap of 15cm between the ventilation  
holes and surrounding surfaces is necessary to prevent heat build-up.  
The ventilation should not be impeded by covering the ventilation openings  
with items, such as newspapers, table-cloths, curtains, etc..  
No objects filled with liquids, such as vases, shall be placed on the appartus.  
No naked flame sources, such as lighted candles, should be placed on the  
apparatus.  
To clean the set, use a soft, slightly dampened chamois leather. Do not use  
any cleaning agents containing alcohol, ammonia, benzene or abrasives as  
these may harm the housing.  
Battery shall not be exposed to excessive heat such as sunshine, fire or the like.  
CAUTION  
Use of controls or adjustments or performance of procedures other than  
herein may result in unsafe operation.  
This set complies with the radio interference requirements of the  
European Union.  
 
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 9  
TROUBLESHOOTING  
If a fault occurs, first check the points listed below before taking the set for repair.  
If you are unable to remedy a problem by following these hints, consult your dealer or  
service center.  
WARNING: Under no circumstances should you try to repair the set yourself, as this  
will invalidate the warranty. Do not open the set as there is a risk of  
electric shock.  
Problem  
Possible Cause  
Remedy  
No sound/power  
Volume not adjusted  
Adjust the volume  
Occasional crackling sound during FM broadcast  
Weak signal  
Adjust the position of the Pigtail  
Continuous crackling/hiss disturbance during MW broadcast  
Electrical interference from TV, computer, fluorescent lamp, etc.  
Move set away from other electrical equipment  
The alarm does not function  
Alarm time not set and or alarm mode not selected  
Set the alarm time and / select alarm mode  
Volume too low for RADIO  
Adjust the volume  
Radio alarm not adjusted to radio station  
Tune to a radio station  
 
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 10  
ENVIRONMENTAL INFORMATION  
We have reduced packaging to the minimum for easy separation into two  
materials: paper and cardboard.  
Your set consists of materials which can be recycled if disassembled by a special-  
ized company. Please observe local regulations on the disposal of packing materi-  
als and old equipment.  
Disposal of your old product  
Your product is designed and manufactured with high quality materials and com-  
ponents, which can be recycled and reused.  
When this crossed-out wheeled bin symbol is attached to a prod-  
uct it means the product is covered by the European Directive  
2002/96/EC.  
Please inform yourself about the local separate collection system for electrical  
and electronic products.  
Please act according to your local rules and do not dispose of your old products  
with your normal household waste. The correct disposal of your old product will  
help prevent potential negative consequences for the environment and human  
health.  
 
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 11  
Specifications  
AC Power.............................................220 – 230 V / 50 Hz  
Power Consumption  
Active.........................................................................3.1W  
Standby......................................................................<2W  
Dimensions (w x d x h)...............130.4 x 130 x 46.8 (mm)  
Weight.....................................................................0.395 kg  
Caractéristiques technique  
Alimentation CA................................220 – 230 V / 50 Hz  
Consommation électrique  
Activité......................................................................3,1 W  
Veille..........................................................................<2 W  
Dimensions (l x Px H).............130,4 x 130 x 46,8 mm  
Poids.....................................................................0,395 kg  
 
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 12  
Meet Philips at the Internet  
W
Printed in China  
AJ3112  
AJ3112_UM_12_V4.0  
 

Pelco Security Camera C3463M B User Manual
Philips Flat Panel Television MCM2250 User Manual
Philips Stereo System FW D1 User Manual
Philips TV Antenna 653 103 User Manual
Philips VCR VR217 User Manual
Philips Video Gaming Accessories NP2900 User Manual
Pioneer Car Stereo System SC 9540 User Manual
Pioneer Speaker HTP SB300 User Manual
ProForm Treadmill 495 LS User Manual
PYLE Audio Printer PP 7200L User Manual