Register your product and get support at
D150
Short user manual
nload from Www.Somanuals.com. All Manuals Search And Down
Overview
1
In call
Standby
Access the main menu.
Display icons
It displays the connection between the handset
Display icons
Earpiece
Phonebook
and the base.The more bars are shown, the
better the signal strength is.
Adjust the volume.
Phonebook
Call log
End calls.
It remains steadily on when browsing incoming
calls in the call log.
/
Mute/unmute the microphone.
Enter a pause.
Make and receive calls.
Make intercom call.
/
It indicates an outgoing call in the redial list.
Recall (network dependent).
Lock/unlock the keypad.
It flashes when there is a new missed call or
when browsing new missed calls. It remains
steadily on when browsing the missed calls in
call log that are already read.
In menu
In text input
Microphone
Confirm / Enter the option menu. / Select
Delete text
Cancel
It flashes when receiving incoming call. It remains
Enter a space.
steadily on during a call.
Up / down
The ringer is off.
Find handset
Exit menu.
Voice messages indicator: flashes for new
messages, is steady for reviewed messages.
*This is network dependent.
It displays when you scroll up/down a list or
increase and decrease the volume.
There are more digits on the right. Press
read.
to
Connect
2
1
2
3
Multi-handset version
only.
nload from Www.Somanuals.com. All Manuals Search And Down
Get started
3
Insert batteries
Charge your phone
Configure your phone
1 When using your phone for the first time, you see a
welcome message (country dependent).
2 Set the country and language if prompted.
3 Set the date and time.
Charge 8 hours
> 70%
10% - 40%
< 10%
• If the time is in 12-hour format, press
/
to
select [AM] or [PM] (country dependent).
40% - 70%
Flashing: low battery
Scrolling: charging in progress
Enjoy
4
Save record
1 Press
2 Follow on-screen instructions.
Phonebook
Register additional handsets
>
> [SAVE NUMBER].
Add record
You can register additional handsets to the base
station.
1 Press
.
Delete record
1 Press and hold on the base station for 5 seconds.
2 Select [PHONEBOOK] > [ADD NEW].
3 Follow on-screen instructions.
2 Press
.
1 Press
>
> [DELETE].
3 Select [SERVICES] > [REGISTER], then press
to confirm.
4 Enter the system PIN/passcode (0000).
2 Follow on-screen instructions.
Call from the phonebook
1 Press
.
Redial list
2 Select a record and press
.
5 Press
to confirm the PIN/passcode.
Call from the redial list
»
Registration is complete in less than 2 minutes.
Direct access memory
1 Press
.
You have 2 direct access memories (Keys 1 and 2).
To dial the saved phone number automatically, press
and hold on the keys in standby mode.
Depending on your country, keys 1 and 2 are preset
to [1_VOICEMAIL] (voice mail number) and
[2_INFO SVC] (information service number)
of your network operator respectively (network
dependent).
2 Select a record and press
.
Restore default settings
Save record
You can reset your phone settings to the original
factory settings.
1 Press
>
> [SAVE NUMBER].
2 Follow on-screen instructions.
1 Press
.
.
2 Select [SERVICES] > [RESET], then press
to confirm.
3 Follow on-screen instructions.
Delete record
1 Press
>
> [DELETE].
2 Follow on-screen instructions.
Call log
Note
Call from the call log
• You may recall the original PIN/passcode by
following this procedure.
1 Press
.
2 Select a record and press
.
Technical data
Battery
• Philips: 2 x AAA NiMH 1.2V Rechargeable
550 mAh batteries
Use only the supplied batteries.
Adapter
Base and charger:
Philips:
Input:
S003IB0600040
100-240V~
SSW-1920UK-2
100-240V~
50/60 Hz 0.15 A
Output: 6V 400 mA
50/60 Hz 0.2 A
6V 500 mA
Phonebook with 50 entries
Call log with 20 entries
Talk time: 16 hours
Standby time: 250 hours
Note
• You can install a DSL (digital subscriber line) filter to
prevent noise and caller ID problems caused by the
DSL interference.
• You can find the Declaration of Conformity on
nload from Www.Somanuals.com. All Manuals Search And Down
Frequently asked questions
No signal bar is displayed on the screen.
My handset is in searching status, what do I do?
Bad audio (crackles, echo, etc.)
• The handset is out of range. Move it closer to the
base station.
• If the handset displays [UNREGISTERED],
register your handset. (See the section on “Register
additional handsets”).
• Make sure that the base station has power supply.
• Register the handset to the base station.
• Move the handset closer to the base station.
• The handset is nearly out of range. Move it closer
to the base station.
• The phone receives interference from the nearby
electrical appliances. Move the base station away
from them.
• The phone is at a location with thick walls. Move
the base away from them.
I cannot change the settings of my voice mail, what
do I do?
The voice mail service is managed by your service
provider but not the phone itself. Contact your
service provider to change the settings.
If I fail to pair (register) the additional handsets to
the base station, what do I do?
The handset does not ring.
Your base memory is full.Access
>
[SERVICES] > [UNREGISTER] to unregister
the unused handsets and try again.
Make sure the handset ringtone is turned on.
The caller ID does not display.
• The service is not activated. Check with your
service provider.
No display
• Make sure the batteries are charged.
• Make sure there are power and phone connections.
I have chosen a wrong language which I cannot
read, what do I do?
The handset on the charger does not charge.
1 Press
2 Press
to go back to the standby screen.
to access the main menu screen.
• The caller’s information is withheld or unavailable.
• Make sure the batteries are inserted correctly.
• Make sure the handset is placed properly on the
charger.The battery icon animates when charging.
• Make sure the docking tone setting is turned on.
When the handset is placed correctly on the
charger, you can hear a docking tone.
• The charging contacts are dirty. Disconnect the power
supply first and clean the contacts with a damp cloth.
• Batteries are defective. Purchase new ones with
the same specifications.
3 The following options will appear on the screen:
[PHONE SETUP] > [LANGUAGE]
[CONFIG.TÉL] > [LANGUE]
[TEL.-SETUP] > [SPRACHE]
[CONF.TELEF.] > [LINGUA]
4 Select it to access the language options.
5 Select your own language.
For information, refer to the extended user
documentation online.
nload from Www.Somanuals.com. All Manuals Search And Down
0168
When this crossed-out wheeled bin symbol is
attached to a product it means that the product
is covered by the European Directive 2002/96/EC.
2014 © WOOX Innovations Limited.
All rights reserved.
Philips and the Philips’ Shield Emblem are
registered trademarks of Koninklijke Philips N.V.
and are used by WOOX Innovations Limited
under license from Koninklijke Philips N.V.
UMS_D150
05_EN_V2.0
WK13501
nload from Www.Somanuals.com. All Manuals Search And Down
|