FULL TWO YEAR WARRANTY
3. Never operate this Trimmer/Charging Base if it has a
damaged cord or plug, if it is not working properly, if it
has been dropped, damaged, or dropped into water.
Return the Trimmer to an Authorized Norelco Service
Location for examination and repair.
4. Keep the Trimmer/Charging Base and Cord away from
heated surfaces.
Philips Electronics North America Corporation warrants each new Norelco
product, Model T-6000 or T-7000 (except cutters), against defects in materi-
als or workmanship for a period of two years from the date of purchase, and
agrees to repair or replace any defective product without charge.
IMPORTANT: This warranty does not cover damage resulting from accident,
misuse or abuse, lack of reasonable care, the affixing of any attachment not
provided with the product or loss of parts or subjecting the product to any but
the specific voltage.* Use of unauthorized replacement parts will void this
warranty.
PHILIPS ELECTRONICS NORTH AMERICA CORPORATION WILL NOT PAY
FOR WARRANTY SERVICE PERFORMED BY A NON-AUTHORIZED REPAIR
SERVICE AND WILL NOT REIMBURSE THE CONSUMER FOR DAMAGE
RESULTING FROM WARRANTY SERVICE PERFORMED BY A NON-AUTHO-
RIZED REPAIR SERVICE.
NO RESPONSIBILITY IS ASSUMED FOR ANY SPECIAL, INCIDENTAL OR
CONSEQUENTIAL DAMAGES.
In order to obtain warranty service, simply take or ship the product postage
prepaid to the nearest Authorized Norelco Service Location. It is suggested
that for your protection you return shipments of product by insured mail,
insurance prepaid. Damage occurring during shipment is not covered by this
warranty. NOTE: No other warranty, written or oral, is authorized by Philips
Electronics North America Corporation. This warranty gives you specific legal
rights, and you may also have other rights which vary from state to state.
Some states do not allow the exclusion or limitation of incidental or conse-
quential damages, so the above exclusion and limitations may not apply to
you.
IMPORTANT
SAFETY
INSTRUCTIONS
T-7000 and T-6000
Rechargeable Cordless Beard
and Moustache Trimmers
When using an electrical appliance, basic safety precautions
should always be followed, including the following:
Read all instructions before using this appliance.
5. Never drop or insert any object into any opening.
6. Do not operate, charge Trimmer, or plug in Charging Base
outdoors or where aerosol (spray) products are being used
or where oxygen is being administered.
7. Do not use this Trimmer with a damaged or broken cutter,
as facial injury may occur.
8. Place Trimmer in Charging Base first, then plug Charging
Base into outlet. To disconnect, turn ON/OFF switch to
“OFF” position (switch is down), then remove Charging
Base plug from outlet.
9. To prevent possible damage to the cord, do not wrap cord
around the Trimmer or Charging Base.
Instructions For Use
DANGER
To reduce the risk of electric shock:
1. Do not reach for a Trimmer that has fallen into water.
Unplug Base immediately.
2. Do not use while bathing or in a shower.
3. Do not place or store Trimmer where it can fall or be
pulled into a tub or sink. Do not place in or drop into
water or other liquid.
10. Never put Trimmer in direct sunlight or store at a temper-
ature above 140˚F.
4. Always unplug this Trimmer/Charging Base from the elec-
trical outlet immediately after using, except when
Trimmer is (re)charging.
*Read enclosed instructions carefully.
Manufactured for: Norelco Consumer Products Company
A Division of Philips Electronics North America Corporation
1010 Washington Blvd., Stamford, CT 06912-0015
5. Unplug Trimmer Base before cleaning.
SAVE THESE
6. When discarding Trimmer, unplug Base and remove
rechargeable batteries. See enclosed sheet for instructions.
MADE IN AUSTRIA.
INSTRUCTIONS
Norelco is a Registered Trademark of
Philips Electronics North America Corporation.
PHILIPS and Philips Shield are Registered Trademarks of
Philips Electronics N.V.
© 1998 Philips Electronics North America Corporation.
All Rights Reserved.
IMPORTANT: YOUR TRIMMER CONTAINS NICKEL-
CADMIUM RECHARGEABLE BATTERIES. See enclosed sheet
for instruction.
WARNING
To reduce the risk of burns, fire or injury to persons:
If you need help, answers or
service, please call us at
1-800-243-3050
1. Close supervision is necessary when this appliance is used
by, on, or near children or the disabled.
2. Use this Trimmer for its intended household use as
described in this manual. Do not use attachments not rec-
ommended by Philips Electronics North America
Corporation.
This symbol on the product’s nameplate means it is listed by
Underwriters’ Laboratories, Inc.
®
INGENIOUS MEN’S GROOMING SOLUTIONS
To Charge/Recharge
Hair Length Selector
Trimmer Guard Attachment
To Remove
back onto Trimmer until it
the desired amount of hair.
•
Use only the Charging Base may range to 240V AC. Your
NOTE:
•
•
•
Trimmer Guard
•
Start at a longer setting
(#7, 8 or 9) to prevent
accidentally trimming
hairs too short (Fig. 3).
“clicks” into position.
provided.
new Trimmer Charging Base
may be used with voltage
ranging from 110-130V AC
only.
Attachment must be in
place on the Trimmer in
order to use the Zoom
Ring.
Remove Trimmer Guard
Attachment if you are:
To Trim Outer Edge of Beard
& Add Definition
1. The Charging Base can
also be used to store the
Trimmer.
NOTE: The Trimmer Guard
Attachment can be placed
on Trimmer only one way.
If it does not fit properly,
reverse it.
•
(Re)charge at tempera-
tures between 40˚F and
95˚F. Charging at lower or
higher temperatures
adversely affects lifetime
of battery.
•
•
•
Defining hair lines
1. Remove Trimmer Guard
Attachment.
• Trim against the direction
of hair growth (Fig. 4)
2. In order to ensure the
longest possible working
life of the battery:
Trimming nape of neck
1. Be certain Trimmer is OFF
(Fig. 1).
Zoom Ring with Trimmer
Guard Attachment ensures
precise trimming and has
9 adjustable settings (see
chart below).
2. Hold Trimmer diagonally
with front of Trimmer facing
away from you (Fig. 7).
Removing single, unwanted
hairs
•
As you become familiar
with the settings, adjust
Zoom Ring to desired
trimming length.
To Trim Beard
2. Charge the Trimmer in the
Charging Base.
•
Do not charge for more
than 24 hours.
1. Be certain Trimmer is in the
OFF position.
1. Comb hairs outward so that
they are at their maximum
height and in the same
direction.
•
•
Charging requires a full
10 hours.
3. Turn Trimmer ON.
3. Plug the cord of Charging
Base into the electrical
outlet.
4. Start at chin and work back
toward ear.
•
Do not keep the Charging
Base permanently plugged
in.
Zoom Ring will “click” into
position at each setting.
2. Hold Trimmer Base with
one hand, grasp sides of
Trimmer Guard Attachment
and gently slide Attachment
off Trimmer (Fig. 5).
Recharging longer than
the required period of time
will not harm Trimmer.
However, continuously
charging Trimmer will
reduce life of battery.
5. Follow line of jawbone to
cut away longer hairs on
outer edge of beard.
2. With Trimmer Guard
Attachment in place,
set Zoom Ring to desired
setting.
4. Green Charging Indicator
Light will light to indicate
Trimmer is (re)charging
(Fig. 2).
#1
#2
#3
#4
#5
#6
#7
#8
#9
Stubble Length or Closely Cropped .06 in./1.5 mm
Short
•
•
Plug in the Charging Base
only when you hear the
sound indicating the
rechargeable battery will
be empty soon.
.1 in./2.5 mm
.16 in./4 mm
.22 in./5.5 mm
.3 in./7.5 mm
.38 in./9.5 mm
.48 in./12 mm
.6 in./15 mm
.72 in./18 mm
NOTE: Zoom Ring can be
on any setting when remov-
ing or replacing Trimmer
Guard Attachment.
6. Turn Trimmer OFF.
3. Slide ON/OFF switch to the
ON position and begin trim-
ming (Fig. 6).
NOTE: Practice is best for
optimum results.
VOLTAGE
Medium
In North America, Central
America, and South America,
the most common voltage is
between 110 and 130V AC.
When traveling to other
Discharge the battery
completely once a year
by letting the motor run
until it stops.
To Define Beard Line
To Replace
4. Turn Trimmer OFF.
1. Hold Trimmer vertically
with front of Trimmer fac-
ing you.
2. Start with trimmed edge of
beard and with downward
1. Be certain Trimmer is in the
OFF position.
IMPORTANT: If using Trimmer
without Trimmer Guard
Attachment, use a slow, very
light “skimming” technique to
prevent trimming off more than
Long
3. If the battery is empty and
you want to trim your
beard, charge Trimmer for
at least 1.5 hours and you
will have enough power
for one use.
countries, common voltage
2. Hold Trimmer in one hand
and replace Attachment
2
4
7
3
1
5
6
9
7
8
6
4. If the Trimmer hasn’t
been used for a long
period of time, Trimmer
must be recharged for a
full 10 hours.
9
8
7
6
5
4
3
2
1
Trimmer Guard Attachment (continued)
Maintenance
IMPORTANT
motions trim area directly
ent trimming positions (i.e.
upwards, downwards or
across). Practice is best for
optimum results.
To Trim Moustache without
Trimmer Guard Attachment
1. Remove Trimmer Guard
Attachment.
2. Place a finger on upper lip
to lift hair up, away from
skin.
hair than desired.
5. Turn Trimmer OFF.
To Trim Sideburns
1. Comb sideburns following
the direction of your hair
growth.
2. Be certain Trimmer Guard
Attachment is ON.
3. Hold Trimmer vertically
with front of Trimmer fac-
ing you.
Attachment is ON and
Zoom Ring is on the lowest
setting (#1).
2. Hold Trimmer horizontally
with front of Trimmer facing
downwards or upwards.
3. Trim hairs using a down-
ward or upward motion,
whichever is more comfort-
able, following the direction
of your hair growth.
pull Trimmer Guard
Attachment off Trimmer
(Fig. 11) and remove hairs
by shaking and/or blowing
(Fig. 12).
Replace cutters immediately.
under the beard line.
To Thin and Taper Beard
•
•
Always switch Trimmer
OFF before cleaning.
1. Remove the old cutters by
pulling cutting unit back-
wards (Fig. 13) and then
pull it upwards off
1. Use a small comb to hold
hairs in place while trim-
ming.
2. Hold Trimmer with front of
Trimmer facing away from
you.
3. Trim hair ends using an
upward motion.
4. Turn Trimmer OFF.
15
16
17
Never clean, remove or
replace Trimmer Guard
Attachment with motor on.
Once A Week
Trimmer.
1. Be certain Trimmer is in
OFF position.
2. Install new Trimmer by
placing the two notches of
the new cutting unit into
the guide slots (Fig. 16).
•
•
Do NOT apply pressure to
cutters.
2. Remove Trimmer Guard
Attachment (Fig. 11).
Do NOT touch cutters
with hard objects as this
may damage them.
4. Turn Trimmer OFF.
3. Push the cutting unit
backuntil it “clicks” into
place (Fig. 17).
3. Trim hairs using an upward
motion.
3. Hold Trimmer as shown
and gently pull cutter
backwards (Fig. 13).
4. Trim sideburns using a
downward motion.
5. Turn Trimmer OFF.
To Trim Moustache with
Trimmer Guard Attachment
•
•
DO NOT use while
4. After achieving desired
length, use a downward
bathing, showering or
immerse the unit in water
or other liquids as damage
to Trimmer may occur.
4. Lightly brush out cutters,
hair chamber and
Trimmer Guard Attach-
ment (Fig. 14 &15) with
cleaning brush provided.
•
Be certain Trimmer Guard
Attachment is on to prevent
trimming off too many
hairs.
1. Comb hairs outward so
they are at their maximum
height and in the same
direction.
motion to blend moustache To Achieve The
13
hairs (Fig. 8).
“Stubble” Look
•
To Trim Moustache with Pop-
Up Trimmer: Model
T-7000 only
1. Slide Pop-Up Trimmer
switch up (Fig. 9).
The Trimmer Guard
NEVER use harsh or cor-
rosive cleaners such as
benzene or bleach.
Attachment is unique
because it has a small slot
between the two rows of
teeth enabling you to trim
hairs to only .06 in./1.5mm
in length.
To Replace Cutters
During Use
If your cutters become dam-
aged or worn, do not contin-
ue using the Trimmer.
2. Hold Trimmer perpendicu-
lar as shown and move cut-
ters sideways to achieve
desired line above lip (Fig.
10).
3. Trim any stray hairs.
4. Slide Pop-Up Trimmer
down when finished.
2. Set Zoom Ring to desired
setting.
•
If cut hairs have accumu-
lated in the comb area,
1. Be certain Trimmer Guard
•
Hold Trimmer vertically
with front of Trimmer fac-
ing you.
12
14
11
8
10
2
•
Trim hairs using a down-
ward motion following the
direction of your hair growth
or you may trim against
your hair growth—
1
2
ATTENTION: Main cutter is
still operating while Pop-Up
Trimmer is in use.
CLICK
whichever is preferred.
NOTE: Since all hairs do not
grow in the same direction,
you may want to try differ-
NOTE: Use a slow and gen-
tle pressure. Too much
pressure may trim more
1
9
|