Register your product and get support at
Indoor wireless headphones
SHC5100
EN User manual
1 What’s in the box
1) Headphone
2)Transmitter
3) AC/DC adaptor
4) Antenna tube
5) 2 x AAA rechargeable shortened sleeve NiMH batteries (SBC HB550L)
3
EN
2 Get started
Note
• Before using the headphones for the first time, charge the supplied batteries for at
least 10 hours.
• Only use Philips rechargeable shortened sleeve NiMH batteries with your
headphones. Other types of rechargeable or alkaline batteries cannot be charged
with this system.
• AAA alkaline batteries can be used to operate the headphones.
• If the volume of the audio source is insufficient, the transmitter automatically turns off.
1 Install/Replace supplied batteries (Fig. B).
2 Install the antenna tube into the transmitter (Fig. C).
3 Power on the transmitter (Fig. D).
» Red LED is on when audio source is connected.
» Red LED blinks if no audio source is connected for two
minutes.
» Red LED is off if no audio source is connected for four
minutes.
4 To charge the headphones, connect the charging cable with the
headphones (Fig. E).
» Headphones: red LED is off during charge.
» Transmitter: green LED is on during charge and is off when
headphones are fully charged.
5 Power on the headphones and red LED is on (Fig. F).
6 Connect the audio device with the transmitter (Fig. G).
» Red LED is on when audio source is connected.
Tip
• If there is interference, tune the transmitter and the headphones to the same channel
(Fig. H).
4
EN
3 Product version table
Version / Region
Adaptor type number Input voltage / frequency
Output voltage
Carrier / Reception
frequency
Channel 1
863.5MHz
863.5MHz
Channel 2
864.5MHz
864.5MHz
/10 Europe
/05 UK
SVV-005-080-020-A2 100-240V / 50/60Hz
SBH-005-080-020-A2 100-240V / 50/60Hz
8V 200mA
8V 200mA
For further product support, please visit www.philips.com/welcome
5
EN
© 2011 Koninklijke Philips Electronics N.V.
All rights reserved.
SHC5100_10_UM_V1.3
|