Philips Laptop Docking Station DS6100 User Manual

Register your product and get support at  
DS6100  
EN User manual  
 
1 Important  
Hearing safety  
Listen at a moderate volume.  
Read these instructions.  
Heed all warnings.  
Follow all instructions.  
Do not use this apparatus near water.  
Do not block any ventilation openings.  
Install in accordance with the  
Using headphones at a high volume can  
impair your hearing.This product can  
produce sounds in decibel ranges that may  
cause hearing loss for a normal person,  
even for exposure less than a minute.The  
higher decibel ranges are offered for those  
that may have already experienced some  
hearing loss.  
manufacturer's instructions.  
Do not install near any heat sources such  
as radiators, heat registers, stoves, or  
other apparatus (including amplifiers) that  
produce heat.  
Protect the power cord from being  
walked on or pinched, particularly at plugs,  
convenience receptacles, and the point  
where they exit from the apparatus.  
Only use attachments/accessories specified  
by the manufacturer.  
Sound can be deceiving. Over time your  
hearing 'comfort level' adapts to higher  
volumes of sound. So after prolonged  
listening, what sounds 'normal' can actually  
be loud and harmful to your hearing.To  
guard against this, set your volume to a safe  
level before your hearing adapts and leave  
it there.  
To establish a safe volume level:  
Unplug this apparatus during lightning  
storms or when unused for long periods  
of time.  
Set your volume control at a low setting.  
Slowly increase the sound until you can  
hear it comfortably and clearly, without  
distortion.  
Refer all servicing to qualified service  
personnel. Servicing is required when  
the apparatus has been damaged in any  
way, such as power-supply cord or plug  
is damaged, liquid has been spilled or  
objects have fallen into the apparatus, the  
apparatus has been exposed to rain or  
moisture, does not operate normally, or  
has been dropped.  
Listen for reasonable periods of time:  
Prolonged exposure to sound, even  
at normally 'safe' levels, can also cause  
hearing loss.  
Be sure to use your equipment reasonably  
and take appropriate breaks.  
Be sure to observe the following guidelines  
when using your headphones.  
Apparatus shall not be exposed to  
dripping or splashing.  
Do not place any sources of danger on the  
apparatus (e.g. liquid filled objects, lighted  
candles).  
Listen at reasonable volumes for  
reasonable periods of time.  
Be careful not to adjust the volume as your  
hearing adapts.  
Do not turn up the volume so high that  
you can't hear what's around you.  
You should use caution or temporarily  
discontinue use in potentially hazardous  
situations.  
Where the plug of the Direct Plug-in  
Adaptor is used as the disconnect device,  
the disconnect device shall remain readily  
operable.  
3
EN  
 
Warning  
2 Your Docking  
Speaker  
Never remove the casing of this apparatus.  
Never lubricate any part of this apparatus.  
Never place this apparatus on other electrical  
equipment.  
Keep this apparatus away from direct sunlight, naked  
flames or heat.  
Congratulations on your purchase, and  
welcome to Philips!To fully benefit from the  
support that Philips offers, register your product  
Ensure that you always have easy access to the power  
cord, plug or adaptor to disconnect the apparatus from  
the power.  
If you contact Philips, you will be asked for the  
model and serial number of this product.The  
model number and serial number are on the  
bottom of the product.Write the numbers  
here:  
Model No. __________________________  
Serial No. ___________________________  
Introduction  
With this docking speaker, you can  
enjoy audio from the iPod/iPhone, other  
external audio devices, and play audio from  
your computer;  
synchronize the iPod/iPhone with your  
computer through USB socket.  
Note  
The speaker supports Dock Studio software.  
What's in the box  
Check and identify the contents of your  
package:  
Main unit  
1 x AC power adaptor  
1 x USB cable  
1 x MP3 link cable  
Quick start guide  
EN  
4
 
3 Get started  
Overview of the speaker  
Always follow the instructions in this chapter in  
sequence.  
abcd  
Connect AC power  
Caution  
Risk of product damage! Make sure that the power  
supply voltage matches the voltage printed on the  
bottom of the unit.  
e
f g  
Risk of electric shock! When you unplug the AC  
adaptor, always pull the plug from the socket. Never  
pull the cord.  
a DC IN  
Connect AC power.  
b
Connect the AC power adaptor to:  
Headphone jack.  
the DC IN power socket at the back of  
the docking speaker.  
c USB  
Sync with a computer through USB  
the wall socket.  
cable.  
Play music from your computer.  
d MP3-LINK  
Connect an external audio device.  
e
Turn the docking speaker on or switch  
to standby mode.  
f DOCK  
Dock for iPod/iPhone.  
g VOLUME + / -  
Adjust volume.  
Turn on  
Press to turn the docking speaker on.  
Switch to standby mode  
When you press again, or the system is idle  
for 15 minutes, the docking speaker switches to  
standby mode.  
5
EN  
 
3
For first-time use, you will be asked to  
install DockStudio app on your iPod/  
iPhone.  
4 Play  
4 Tap [Yes] (yes) to accept the installation  
request.  
Play from iPod/iPhone  
5 Follow the on-screen instructions to  
complete the installation.  
You can enjoy audio from your iPod/iPhone  
through this docking speaker.  
Compatible iPod/iPhone  
The docking speaker supports the following  
iPod,iPhone models:  
Made for.  
iPod touch (1st, 2nd, 3rd, and 4th  
generation)  
iPod classic  
iPod nano (1st, 2nd, 3rd, 4th, 5th, and 6th  
generation)  
iPhone 4S  
iPhone 4  
6 Launch the app after the installation.  
7 Play audio on your iPod/iPhone.  
» Audio comes out through this docking  
speaker.  
iPhone 3GS  
iPhone 3G  
iPhone  
Listen to the iPod/iPhone  
Philips DockStudio app brings a suite of new  
features to your docking speaker.To enjoy more  
features, you are recommended to install the  
free DockStudio app.  
1 Press to turn the docking speaker on.  
» The LED indicators light up.  
2 Insert the iPod/iPhone into the dock.  
Tip  
With the DockStudio app, you can enjoy music, set  
clock and alarm, adjust sound settings, and update  
firmware if necessary.  
EN  
6
 
Charge the iPod/iPhone  
When the docking speaker is connected to  
AC power, the docked iPod/iPhone begins to  
charge.  
Play audio from your PC  
With this docking speaker, you can enjoy audio  
from your PC.  
Sync iPod/iPhone with PC  
1 Connect the speaker with your computer  
Note  
with the supplied USB cable.  
2 Play audio from your PC.  
Make sure that iTunes has been configured properly in  
your PC.  
Due to different materials and product techniques,  
some USB cables may not work with this device.  
Note  
Make sure that the speaker is correctly connected with  
your computer through USB cable.  
Make sure that no iPod/iPhone is docked in the speaker.  
1 Insert the iPod/iPhone in the dock.  
2 Press to switch to standby mode.  
» The LED indicators light off.  
3 Connect your docking speaker and PC  
with a USB cable.  
Play from an external device  
4 Launch iTunes to synchronize your docking  
speaker with PC.  
With this docking speaker, you can also enjoy  
audio from an external device such as an MP3  
player.  
» The docked iPod/iPhone is  
synchronized with PC successfully  
through the iTunes.  
Note  
Make sure that no iPod/iPhone is docked in the speaker.  
7
EN  
 
1 Press to turn the docking speaker on.  
5 Specifications  
2 Connect the MP3 link cable to:  
the MP3-LINK socket at the back of  
the docking speaker.  
the headphone socket on an external  
device.  
Amplifier  
Rated Output Power 2 X 10 W RMS  
» The docking speaker switches to MP3  
link mode automatically.  
3 Play audio on the device.  
General information  
AC power supply  
Model:AS300-120-  
AD250(Philips);  
MP3 Link  
Input: 100-240V ~,  
50/60Hz, 1.1A;  
Output: 12.0V 2 5 A  
Operation Power  
Consumption  
Standby Power  
Consumption  
Max.Load for iPod/  
iPhone  
15 W  
<0.5 W  
5V 1 A  
Dimensions  
- Main Unit  
(W x H x D)  
528 x 78 x 93mm  
Weight  
- Main Unit  
Listen through headphone  
1.1 kg  
1.9 kg  
- With Packing  
Plug a headphone into the socket on the  
speaker.  
Note  
When iPod/iPhone is docked in the speaker, the  
headphone function is not available.  
Adjust volume  
Press +/- on your docking speaker ; or  
Adjust the volume control of your iPod/  
iPhone or external device.  
EN  
8
 
6 Troubleshooting 7 Notice  
Any changes or modifications made to this  
Warning  
device that are not expressly approved by  
Philips Consumer Lifestyle may void the user’s  
authority to operate the equipment.  
Never remove the casing of this apparatus.  
To keep the warranty valid, never try to repair  
the system yourself.  
If you encounter problems when using this  
apparatus, check the following points before  
requesting service. If the problem remains  
unsolved, go to the Philips web site  
(www.philips.com/support).When you contact  
Philips, ensure that the apparatus is nearby  
and the model number and serial number are  
available.  
This product complies with the radio  
interference requirements of the European  
Community.  
Your product is designed and manufactured  
with high quality materials and components,  
which can be recycled and reused.  
No power  
Make sure that the AC power adaptor of  
the device is connected properly.  
Make sure that there is power at the AC  
outlet.  
No sound or poor sound  
Adjust the volume of your docking speaker.  
Adjust the volume of your iPod/iPhone or  
external audio device.  
When this crossed-out wheeled bin symbol is  
attached to a product it means that the product  
is covered by the European Directive 2002/96/  
EC.  
No response from the unit  
Please inform yourself about the local separate  
collection system for electrical and electronic  
products.  
Please act according to your local rules and  
do not dispose of your old products with your  
normal household waste. Correct disposal of  
your old product helps to prevent potential  
negative consequences for the environment and  
human health.  
Disconnect and reconnect the AC power  
plug, and then switch on the device again.  
Cannot sync with PC  
Switch the docking speaker to standby  
mode.  
Try another USB cable.  
Install iTunes in PC properly.  
Environmental information  
All unnecessary packaging has been omitted.  
We have tried to make the packaging easy to  
separate into three materials: cardboard (box),  
polystyrene foam (buffer) and polyethylene  
(bags, protective foam sheet.)  
Your system consists of materials which can  
be recycled and reused if disassembled by a  
9
EN  
 
specialized company. Please observe the local  
regulations regarding the disposal of packaging  
materials, and old equipment.  
“Made for iPod” and “Made for iPhone”  
mean that an electronic accessory has been  
designed to connect specifically to iPod or  
iPhone respectively, and has been certified by  
the developer to meet Apple performance  
standards.Apple is not responsible for the  
operation of this device or its compliance with  
safety and regulatory standards. Please note that  
the use of this accessory with iPod or iPhone  
may affect wireless performance.  
iPod and iPhone are trademarks of Apple Inc.,  
registered in the U.S. and other countries.  
Note  
The type plate is located on the bottom of the  
apparatus.  
EN 10  
 
Specifications are subject to change without notice  
© 2012 Koninklijke Philips Electronics N.V.  
All rights reserved.  
DS6100_10_UM_V1.0  
 

Philips Car Stereo System 32PFL7603S 60 User Manual
Philips Headphones HP900U User Manual
Philips Projection Television 60PP9753 17 User Manual
Philips Universal Remote RC2573GR User Manual
Philips VCR VPA115AT User Manual
Philips VCR VR139 User Manual
Philips Welding System TS2519C User Manual
Poulan Trimmer 2002 12 User Manual
Poulan Trimmer BC3100 User Manual
ProForm Treadmill PFTL814050 User Manual