Philips Microphone AEA3000 User Manual

Always there to help you  
Register your product and get support at  
AEA3000  
Question?  
Contact  
Philips  
User manual  
 
Contents  
1 Important  
2
Safety  
Notice  
2
2
2 YourWireless Microphone and  
Receiver  
4
4
4
4
Introduction  
What's in the box  
Overview of the unit  
3 Get started  
5
5
Install/replace microphone batteries  
4 Play  
6
6
7
Sing along through the wireless  
microphone  
Optional: Enjoy music from an existing  
Hi-Fi system  
5 Product information  
8
8
Specifications  
6 Troubleshooting  
9
EN  
1
 
Remove batteries when the unit is not  
used for a long time.  
1 Important  
Perchlorate Material-special handling  
hazardouswaste/perchlorate.  
l Apparatus shall not be exposed to  
dripping or splashing, keep it away from  
direct sunlight,naked flames or heat.  
Safety  
Important Safety Instructions  
Information about the use of batteries:  
a Read these instructions.  
b Keep these instructions.  
c Heed all warnings.  
Caution  
Risk of leakage: Only use the specified type of batteries.  
Do not mix new and used batteries. Do not mix  
different brands of batteries. Observe correct polarity.  
Remove batteries from products that are not in use for  
a longer period of time. Store batteries in a dry place.  
d Follow all instructions.  
e Do not use this apparatus near water.  
f Clean only with dry cloth.  
Risk of injury:Wear gloves when handling leaking  
batteries. Keep batteries out of reach of children and  
pets.  
Risk of explosion: Do not short circuit batteries. Do  
not expose batteries to excessive heat. Do not throw  
batteries into the fire. Do not damage or disassemble  
batteries. Do not recharge non-rechargeable batteries.  
g Do not block any ventilation openings.  
Install in accordance with the  
manufacturer's instructions.  
h Do not install near any heat sources such  
as radiators, heat registers, stoves, or  
other apparatus (including amplifiers) that  
produce heat.  
Notice  
i Only use attachments/accessories  
Any changes or modifications made to this  
device that are not expressly approved by  
Philips Consumer Lifestyle may void the user’s  
authority to operate the equipment.  
specified by the manufacturer.  
j Refer all servicing to qualified service  
personnel. Servicing is required when  
the apparatus has been damaged in any  
way, such as liquid has been spilled or  
objects have fallen into the apparatus, the  
apparatus has been exposed to rain or  
moisture, does not operate normally, or  
has been dropped.  
This product complies with the radio  
interference requirements of the European  
Community.  
k Battery usage CAUTION To prevent  
battery leakage which may result in bodily  
injury, property damage, or damage to  
the unit:  
This product is in compliance with the essential  
requirements and other relevant provisions of  
Directive 1999/5/EC.  
A copy of the EC Declaration of Conformity  
(DoC) is available in the packaging.  
Install all batteries correctly, + and - as  
marked on the unit.  
2
EN  
 
Your product is designed and manufactured  
with high quality materials and components,  
which can be recycled and reused.  
“Made for iPad” means that an electronic  
accessory has been designed to connect  
specifically to iPad, and has been certified by  
the developer to meet Apple performance  
standards.Apple is not responsible for the  
operation of this device or its compliance with  
safety and regulatory standards. Please note that  
the use of this accessory with iPad may affect  
wireless performance.  
When this crossed-out wheeled bin symbol is  
attached to a product it means that the product  
is covered by the European Directive 2002/96/  
EC.  
iPad is a trademark of Apple Inc., registered in  
the U.S. and other countries.  
The Bluetooth® word mark and logos are  
registered trademarks owned by Bluetooth  
SIG, Inc. and any use of such marks by Philips is  
under license.  
Please inform yourself about the local separate  
collection system for electrical and electronic  
products.  
Please act according to your local rules and  
do not dispose of your old products with your  
normal household waste. Correct disposal of  
your old product helps to prevent potential  
negative consequences for the environment and  
human health.  
Note  
The type plate is located on the back of the unit.  
Your product contains batteries covered by  
the European Directive 2006/66/EC, which  
cannot be disposed with normal household  
waste.Please inform yourself about the local  
rules on separate collection of batteries  
because correct disposal helps to prevent  
negative consequences for the environmental  
and human health.  
Environmental information  
All unnecessary packaging has been omitted.  
We have tried to make the packaging easy to  
separate into three materials: cardboard (box),  
polystyrene foam (buffer) and polyethylene  
(bags, protective foam sheet.)  
Your system consists of materials which can  
be recycled and reused if disassembled by  
a specialized company. Please observe the  
local regulations regarding the disposal of  
packaging materials, exhausted batteries and old  
equipment.  
EN  
3
 
b
2 YourWireless  
Microphone and  
Receiver  
d
c
Congratulations on your purchase, and  
welcome to Philips!To fully benefit from the  
support that Philips offers, register your product  
If you contact Philips, you will be asked for the  
model and serial number of this apparatus.The  
model number and serial number are on the  
back of the apparatus.Write the numbers here:  
a
a Line out socket  
(To use the microphone separately)  
Model No. __________________________  
Serial No. ___________________________  
connect to the MIC input socket of an  
existing Hi-Fi system.  
b Battery compartment  
Introduction  
With the Philips wireless microphone and  
receiver, you can:  
c OFF/ON  
Switch the microphone on or off.  
connect the receiver to your iPad (or  
both your iPad and an existing Hi-Fi  
system), and sing along with music  
from the app (TheVoice: On Stage)  
through the wireless microphone.  
d Power indicator  
Light up red when the wireless  
microphone is switched on.  
Flash red when the battery level is low.  
Receiver  
b
What's in the box  
Check and identify the contents of your  
package:  
a
c
Wireless microphone  
Receiver  
3 x AAA batteries  
Quick start guide  
Safety sheet  
a iPad connector  
b Bluetooth® indicator  
Indicate the Bluetooth® status.  
c LINE-OUT  
Overview of the unit  
Wireless microphone  
Connect the receiver to an existing  
Hi-Fi system.  
4
EN  
 
3 Get started  
Always follow the instructions in this chapter in  
sequence.  
Install/replace microphone  
batteries  
Caution  
3
Push back the battery cartridge, then close  
the battery compartment.  
Risk of explosion! Keep batteries away from heat,  
sunshine, or fire. Never discard batteries in fire.  
Danger of explosion if batteries are incorrectly  
replaced. Replace only with the same or equivalent  
type.  
Note  
Batteries contain chemical substances, so they should  
be disposed of properly.  
If you are not going to use the microphone for a long  
time, remove the batteries.  
New batteries installed in the microphone support up  
to 30 hours of continuous use.  
When the power indicator flashes red, it indicates that  
the power level is low and you need to replace the  
batteries.  
1
Open the battery compartment and take  
out the battery cartridge.  
2
Insert 3 x AAA batteries (supplied) into  
the cartridge with correct polarity (+/-) as  
indicated.  
EN  
5
 
 
4
Slide the OFF/ON switch on the wireless  
microphone to the ON position.  
» The Bluetooth® indicator on the  
receiver flashes blue.  
4 Play  
» The wireless microphone starts to pair  
with the receiver automatically.  
Sing along through the  
wireless microphone  
» After successful pairing and connection,  
the Bluetooth® indicator turns solid  
blue.  
Note  
The effective operation range between the wireless  
microphone and receiver is approximately 10 meters  
(30 feet).  
1
Connect your iPad to the receiver.  
» A prompt pops up on the iPad screen,  
asking you to install the relevant app.  
5
Find and download a tutorial from The  
Voice: On Stage, then tap Sing->RECORD  
for how to sing along through the wireless  
microphone and iPad.  
2
3
Tap YES on the prompt to install the app  
(TheVoice: On Stage) from Apple App  
Store.  
After successful installation, run TheVoice:  
On Stage on the iPad.  
6
Select a song from TheVoice: On Stage  
and sing along through the wireless  
microphone.  
6
EN  
 
2
Power on the existing Hi-Fi system and  
select the 3.5mm audio input source (see  
the user manual of the Hi-Fi system for  
detailed operation).  
Tip  
If the wireless microphone remains disconnected from  
the receiver for more than 15 minutes, it switches to  
standby mode automatically.To switch it on again, you  
need to slide the OFF/ON switch on the microphone  
to the OFF position and then back to the ON position.  
You can use controls available on the app to adjust  
sound effects.  
If you experience howling or echo, try to increase the  
distance between the microphone and iPad or adjust  
the angle of the microphone towards the iPad.  
Optional: Enjoy music from  
an existing Hi-Fi system  
For optimal sound effect, you can connect the  
receiver to an existing Hi-Fi system.  
MP3 LINK  
LINE-OUT  
1
Connect a 3.5mm audio cable to:  
the LINE-OUT socket on the receiver.  
the 3.5mm audio input socket on your  
existing Hi-Fi system.  
EN  
7
 
Weight  
5 Product  
information  
0.02kg  
0.33kg  
Receiver  
Microphone  
Note  
Product information is subject to change without prior  
notice.  
Specifications  
Microphone  
Power Supply  
Directivity  
Sensitivity  
3 x AAA batteries  
Unidirectional  
-32 ± 3dB  
Receiver  
Audio Line Out  
1000mV ± 100mV  
RMS 20kohm  
Frequency Response  
100Hz - 16kHz, ±  
3dB  
Signal to Noise Ratio  
Crosstalk  
> 85dB  
> 40dB  
Bluetooth®  
Bluetooth® version V2.1 + EDR  
Frequency band  
2.402-2.480 GHzISM  
Band  
Range  
10m (free space)  
General information  
Dimensions (W x H  
x D)  
Receiver  
41.5 x 45.5 x 10.5mm  
162 x 333 x 162mm  
Microphone  
8
EN  
 
Failed to set up connection between the  
microphone and receiver  
6 Troubleshooting  
Check whether both the wireless  
microphone and receiver are switched  
on.The receiver is switched on  
automatically when it is connected to  
an iPad.  
Warning  
Never remove the casing of this device.  
Make sure that the wireless  
To keep the warranty valid, never try to repair  
the system yourself.  
microphone and receiver are within  
the the effective operation range, that  
is, approximately 10 meters (30 feet).  
If you encounter problems when using this  
device, check the following points before  
requesting service. If the problem remains  
unsolved, go to the Philips Web page (www.  
philips.com/support).When you contact Philips,  
make sure that the device is nearby and the  
model number and serial number are available.  
Howling or echo from the wireless  
microphone  
Adjust volume on the iPad.  
Adjust volume on the existing Hi-Fi  
system connected to the receiver.  
No power to the wireless microphone  
Increase the distance between the  
microphone and iPad (Hi-Fi system)  
or adjust the angle of the microphone  
towards the iPad (Hi-Fi system).  
The batteries may be installed incorrectly  
As a power-saving feature, the microphone  
switches to standby mode automatically  
after staying disconnected from the  
receiver for more than 15 minutes.To  
switch it on again, you need to slide the  
OFF/ON switch on the microphone to the  
OFF position and then back to the ON  
position.  
No sound or poor sound  
Adjust volume on the iPad.  
Adjust volume on the Hi-Fi system  
connected to the receiver.  
Make sure that you have selected the  
correct source on the connected Hi-Fi  
system.  
Make sure that you have connected the  
receiver to the Hi-Fi system securely.  
Check whether you have connected the  
iPad securely.  
Check whether you have started music  
play on the iPad.  
EN  
9
 
Specifications are subject to change without notice  
© 2012 Koninklijke Philips Electronics N.V.  
All rights reserved.  
AEA3000_UM_00_V1.0  
 

Pelco Home Security System C490M D 1 96 User Manual
Pelco Security Camera C2924M A 5 05 User Manual
Philips Car Satellite TV System 32PFK5709 User Manual
Philips Stereo Amplifier SWV2116 User Manual
Polaris Offroad Vehicle 120 User Manual
Poulan Snow Blower 425353 User Manual
Poulan Tiller 184877 User Manual
Precisionaire Air Cleaner PB1403 User Manual
ProForm Treadmill PFTL72582 User Manual
PYLE Audio Car Speaker PSS8 User Manual