PhotoFrame Firmware Upgrade Instructions
Applicable models 7FF3FPB, 7FF3FPW
Firmware version
Release date
123
December 12, 2008
Release notes
- Preloaded baby photo is deletable
Important notice before updating
The firmware upgrade process will remove all photos currently stored on PhotoFrame.
Please make sure all photos on PhotoFrame are properly backed up before updating.
!
!
Please follow the steps below to upgrade the PhotoFrame firmware.
1
2
Format SD (Secure Digital) card
Copy all files from the ‘Firmware’ folder into the root folder of the SD card
(The root folder is the ‘highest’ folder in hierarchy, for example F:\)
3
4
5
6
Make sure PhotoFrame is powered Off
Insert SD into PhotoFrame with the new firmware into the PhotoFrame
Push the Power button to power on the PhotoFrame
The firmware upgrade will start automatically
Warning: Upgrade takes about 1 minute.
During the upgrade do not disconnect power, remove the memory or make new
connections. Otherwise this may harm your PhotoFrame.
!
!
7
8
9
When "Please reboot system!" shows, firmware upgrade has finished
Remove the memory from the PhotoFrame
Power Off the PhotoFrame and Power On afterwards by pushing the Power button
The upgrade has completed
10
You can check the new firmware version via Setup → Status → Firmware.
|