Owner’s Manual For:
QP-7TM
QP-9TM
QP-15TM
Ó 2007 PINNACLE LOUDSPEAKERS
We appreciate your choosing a Pinnacle Quantum Plasma speaker for use in your
Home Theater & audio system. This unique speaker will provide you with surprisingly
powerful and satisfying sound from an ultra stylish & compact package. Please read
this manual completely to ensure the best possible performance from your system.
SPEAKER PROTECTION:
One special feature of the Quantum Plasma speakers is an overload protection circuit
designed to help protect the speaker from accidental overload. This protection circuit
will automatically attenuate the overall output of a speaker when it senses excessive
volume level. If you hear this protection circuit engaging, (and it will be obvious when
this occurs), please turn down your receiver’s volume. Your speaker will quickly return
to its normal operation.
CONNECTIONS:
Complete all wire connections in your Home Theater / audio system before powering
up your receiver. Be sure to observe proper polarity for all speaker wire connections:
receiver PLUS (red terminal) to speaker PLUS, receiver MINUS (black terminal) to
speaker minus. For the best results, we recommend 12, 14 or 16 gauge wire; consult
your dealer for options.
To connect your speaker wire to your speaker's binding posts, twist the bare wire
strands together tightly, then insert through the hole which becomes visible when the
knurled knob is screwed counterclockwise. The wire must then be secured by
screwing the knob back clockwise until snug. Remember, loose strands of wire may
cause short circuits. Upon completion, gently tug at all connections to ensure they are
fastened securely and re-check for correct polarity.
WIRING:
·
·
·
Connect your receiver’s left channel speaker output to the left-most (from the front)
terminal cup on your Quantum Plasma speaker.
Connect your receiver’s center channel speaker output to the center terminal cup
on your Quantum Plasma speaker.
Connect your receiver’s right channel speaker output to the right-most (from the
front) terminal cup on your Quantum Plasma speaker.
VERY IMPORTANT!
Be sure your receiver’s main & center channel modes are set to SMALL (NORMAL).
This will allow for the greatest bass impact from your system.
RECOMMENDED SPEAKER PLACEMENT:
·
We recommend you wall-mount your Quantum Plasma speaker horizontally,
above, or just below, your TV. The location that places the speaker at the height
closest to ‘ear level’ is best.
GRILLES:
The silver Quantum Plasma speakers come with two grilles. One silver, one black. If
you would like to change grilles please read the following instructions.
·
Using an awl or similar tool, carefully pry the grill off of one side of the speaker by
catching it by one of its holes near the edge. Slowly pull the grill completely out of
it’s groove on that side of the cabinet. Remove grill from speaker.
·
Slide the bottom side of the other grill into the groove on the bottom side of the
cabinet. Bend the grill slightly until it’s top side pops into the top groove.
ON-WALL MOUNTING INSTRUCTIONS:
INSTALLATION NOTES:
The hanging methodology employed with this product is intended for mounting on
walls of standard construction (sheetrock on wood or metal studs), which includes
most residential environments. In installations with concrete, brick, cinder block or
stone walls we recommend the use of 1.5” to 2" concrete nails.
TOOLS REQUIRED:
·
·
#2 Philips head screwdriver bit or hand screwdriver.
Drill - electric or cordless, with 3/16” bit.
MOUNTING INSTRUCTIONS:
1) Determine where you want to mount your speaker.
2) Place the speaker on the wall. Make a small mark on the wall at the top center of
the speaker. Remove the speaker from the wall and place the wall mount bracket
so that the mark on the wall lines up with the top center of the bracket.
3) Orient the bracket so that it is level. Mark on the wall the locations for the bracket’s
mounting screws. Remove the mounting bracket from the wall.
4) Using a drill with a 3/16" bit, drill a 2" deep pilot hole at each of the mounting
screwhole marks on the wall. Insert a wall anchor into each hole.
5) Place the bracket back on the wall lining up the screw holes of the bracket with the
holes on the wall. Screw the included mounting screws fully into the wall
anchors. The bracket should now be securely attached to the wall.
6) Center the speaker carefully above the bracket and lower it slowly until the bracket
is fully inserted into the groove on the back of the cabinet.
After completing all connections, turn the system on, then GRADUALLY increase the
volume level. If there is no sound, distorted sound, or if the amplifier shuts itself down
after a few seconds, IMMEDIATELY TURN THE VOLUME DOWN and turn the system
off. Then re-check your wiring for accuracy and for possible shorts at the connecting
terminals (adjacent bare wires touching each other). When everything sounds fine,
keep the volume reasonably low while you familiarize yourself with your system's
various controls and operating modes.
LIMITED TRANSFERABLE WARRANTY
WHAT IS COVERED: All Pinnacle Quantum Plasma speakers are covered by this
warranty for a period of ten (10) years from the date of the original purchase. The
warranty covers all necessary parts and labor to return the speaker to proper working
order. Cabinet surfaces, grille assembly, and other exterior parts subject to normal
wear and tear are not covered except where an inherent structural defect becomes
evident. Parts replacement and labor will be performed at the discretion of the
company (Pinnacle Loudspeakers) and will be provided free of charge unless (in the
opinion of our service department, service representatives, or engineering
department) the speaker system has failed due to abuse or negligent operation. Any
latent defect attributable to error in manufacture will always be covered by this
warranty.
WHAT IS NOT COVERED: This warranty will be void and no free services performed if
we or any party acting as our agent determines that the speaker system in question
has had any of its loudspeaker elements (woofer, midrange, tweeter, etc.) or internal
circuitry removed or tampered with in any way whatsoever without express prior
authorization from Pinnacle. Furthermore, if the speaker system is not found to be
defective a service charge will be levied. In either case the minimum charge will be
$30.00. An additional charge will be applicable for same day service if requested
(subject to feasibility). This charge will always be in effect even if the actual parts and
labor are covered by this warranty. Any damage caused to the speaker system from
improper use is not covered by warranty. Pinnacle Loudspeakers reserves the right to
make the final determination of whether or not a particular speaker system has been
damaged by abuse or excessive overload.
TO OBTAIN SERVICE: To obtain service under this warranty, either contact your
Pinnacle dealer or us directly at (516) 576-9052 or [email protected].
You may also write us at 1 Fairchild Court, Suite 140, Plainview, NY 11803. If you ship
your speakers you are responsible for packing and shipping insurance. The freight
must be prepaid. We will, however, pay return freight charges on any returned
speaker that qualifies for in-warranty service. Sorry, we cannot accept any collect
freight charges. You must include a note, attached to the unit, with your name, phone
number or email address, and return shipping address (no Post Office boxes),
indicating the nature of the problem you are experiencing. For warranty service you
must also include a copy of your sales receipt. If the speaker returned to us or our
agents for service proves not eligible for warranty repairs or is not found to be
defective, then you will have to pay return freight charges. Please be sure to pack any
items you ship us carefully since we cannot be held responsible for damages
incurred during shipping. This warranty may be transferred to a subsequent owner,
but will not be in effect for a period greater than ten (10) years from the date of the
original purchase. SAVE THIS CERTIFICATE AND YOUR SALES RECEIPT. YOU MAY
NEED THEM TO OBTAIN SERVICE UNDER THE PROVISIONS OF THIS LIMITED
WARRANTY.
1 Fairchild Court Suite 140
Plainview, NY 11803
Tel. (516) 576 9052, Fax. (516) 576 0826
E-mail: [email protected]
PR MAN TRICHANNEL REV0807
|