|
Instructions for Gameplay recording using the
Pioneer DVR-550H-K DVD Recorder.
Note: Consult diagram on last page for the button layout of the remote control.
1. Turn on the video game console.
2. Make sure the correct time is set on the DVD Recorder by looking at the front
panel.
If necessary, to set the date/time:
2.1 Turn on the DVD Recorder and Press HOME MENU on the remote control
and select ‘Initial Setup,’ then press ENTER
2.2 Select ‘Basic’ and then select ‘Clock Setting.’
2.3 Select ‘Manual’
2.4 Select the correct time zone (Canada Mountain) and press ENTER.
2.5 Set the current date and time and then press ENTER.
2.6 Press HOME MENU to exit.
3. Turn the DVD Recorder (Pioneer CVR-550H-K) on.
To Start Recording
NOTE:
To maintain data redundancy, it is best to record gameplay footage to the unit’s
internal hard drive (HDD) and then copy the footage to DVD-Rs.
You are advised to make multiple recordings (rather than one long recording). For
example, record a single mission or level, then press STOP REC during an inactive
sequence or pause-screen, and then begin recording again when you start a new
level.
1. Press HDD/DVD (on the remote or the unit) until ‘HDD’ appears on the screen.
2. Press REC MODE (on the remote or the unit)* so that ‘SP 2h00m/DVD…’ appears
on screen.
3. Press INPUT SELECT (on the remote or the unit)* and select the appropriate
source. (for example, L1 for the Xbox, L3 for the PS2).
4. To start recording gameplay footage, press REC (on the remote or the unit).
5. When finished a mission or level, press STOP REC (on the remote or the unit) to
end recording.
*Note: The REC MODE and INPUT SELECT buttons are hidden behind a panel on
both the remote and the unit.
Diagram 1. Remote Control
for Pioneer DVR-550H-K DVD
Recorder.
|