|
4/16-ch H.264 Digital Video Recorder
DVR-471 / DVR-1671
Version: 1.0
Quick Installation Guide
1. Overview
This quick installation guide describes the objectives, organization and basic
installation of the PLANET DVR-471 / DVR-1671 surveillance system, and offers
standalone system to build a distributed surveillance system, which can be
monitored via network, and equipped with hard disc drive that records the video
directly. Also, this guide shows you how to find additional information on related
products and services.
ꢀ
2. Package Contents
ó 1 x DVR-471 / DVR-1671
ó 1 x Power adapter
ó 1 x Power cord
ó 1 x Quick installation guide
ó 1 x User’s manual CD
ó 2 x SATA cable
ó 1 x SATA power cable
ó 4 x HDD rack
ó 8 x HDD screw
ó 1 x Remote controller
ó 2 x Battery
If any of above items are missed or damaged, please contact your
local dealer for support.
Note
ꢁ
3. Rear Panel Description
Item
Description
1
2
3
4
5
6
7
8
VIDEO IN
SPOT
BNC input ports for cameras
BNC output port for spot monitor
BNC output port for the main monitor
RCA input port for an audio signal
RCA output port for an audio signal
Output port for the VGA monitor
PS/2 mouse connection port
VIDEO OUT
AUDIO IN
AUDIO OUT
VGA
PS/2
ETHERNET
Port for 10/100Mbps Ethernet
Input terminal blocks for alarm signals/
Terminal blocks of RS-485 / Relay
output terminal blocks
9
SENSOR / RS-485 / RELAY OUT
10
11
POWER IN
Socket for DC 12V power adapter
Switch to turn the power on/off
POWER SWITCH
ꢂ
4. HDD Installation
Step 1:
Lock HDD holder symmetrically in the two sides of HDD with racks and
screws.
Make sure the position between HDD and racks.
The HDD must be installed before the DVR is turned on.
Note
Step 2:
Insert the SATA cable and power cable into SATA HDD.
ꢃ
Step 3:
Lock the HDD onto DVR machine.
Step 4:
Insert the SATA cables into the sockets on the main board. Make sure the
HDD1, 2 cables insert into HDD1, 2 sockets.
Now, the installation was finished
ꢄ
5. Hardware Installation
1. Connect your cameras to the Video Inputs.
2. Connect your main monitor to “Video Output” or “VGA” connector.
3. Connect the “Ethernet” port to your switch / hub via RJ-45 cable.
4. Connect the bundled power adapter (DC 12V) to the “Power In”
5. Switch the “Power Switch” to turn on your DVR.
Further configuration and information can be found in the user’s manual CD. Please
check the user’s manual for more understanding.
ꢅ
|