INSTALLATION INSTRUCTIONS
PSD-S
Ceiling Mount Adapter
AUSTRALIA, NEW ZEALAND, OCEANIA
EUROPE
Swallow House,
NORTH AMERICA
3130 East Miraloma Avenue
Anaheim, CA 92806 USA
USA and Canada –
(DISTRIBUTOR)
P.O. Box 295
Shilton Industrial Estate,
Shilton, Coventry, England CV79JY
Phone: +44 (0) 2476 614700
Fax: +44 (0) 2476 614710
Mordialloc Victoria 3195
Australia
Phone: 039586 6330
Phone: 800-368-9700
Fax: 800-832-4888
Other Locations – Phone: (001)-714-632-7100; Fax: (001)-714-632-1044
©Premier Mounts 2008
9533-025-001-00
PSD-S
Parts List
This ceiling mount is shipped with all proper installation hardware and components. Make sure that none of these parts
are missing and/or damaged before beginning installation. If there are parts missing and/or damaged, please stop the
installation and contact Premier Mounts (800-368-9700).
M10 Nut (Qty 4)
M10 Hex Head Bolt
(Qty 4)
Ceiling Adapter
(Qty 1)
M10 Flat Washer
(Qty 8)
Installation Tools
Phillips Head Screwdriver
Soft Material/Blanket
Pencil
Ladder
Installation Instructions
Page 3
PSD-S
Attaching the Ceiling Adapter
Before the following steps are begun, the appropriate suspension device must be installed. Premier mounts offers the
AST-1321, AST-2446 or a standard 1-1/2” NPT extension pipe. Please see the installation instructions that are included
with these respective mounting configurations.
Step 1. To attach the ceiling adapter to the suspension device (not included), rotate the ceiling adapter clockwise onto the suspension
device a minimum of five (5) complete turns.
Page 4
Installation Instructions
PSD-S
A Phillips head screwdriver is required to perform the following step.
Step 2. Once the ceiling adapter has been attached, tighten the M6 x 12mm Phillips head set screw using a Phillips screwdriver.
Installation Instructions
Page 5
PSD-S
Attaching the Mounting Plate
Step 1. Use four (4) M10 hex head bolts, eight (8) M10 flat washers, and four (4) M10 nuts to attach the mounting plate to the ceiling
adapter.
At this time, finger tighten all hardware.
Page 6
Installation Instructions
PSD-S
A 17mm open-end wrench and a 17mm socket wrench will be required to perform the following step.
Step 2. Once the both units have been attached together, use a 17mm socket wrench and a 17mm wrench to tighten the
M10 hardware.
Installation Instructions
Page 7
PSD-S
Technical Specifications
All measurements are in inches (mm).
Page 8
Installation Instructions
PSD-S
Warranty
PREMIER MOUNTS
LIMITED LIFETIME WARRANTY
What and Who is Covered by this Limited Warranty and for How Long
Premier Mounts warrants this product to be free from defects in material and workmanship for the lifetime of
the original owner of this product. The limited warranty is valid only for the original purchaser of the product.
What Premier Mounts Will Do
At the sole option of Premier Mounts, Premier Mounts will repair or replace any product or product part that is
defective. If Premier Mounts chooses to replace a defective product or part, a replacement product or part will
be shipped to you at no charge, but you must pay any labor costs.
What is Not Covered; Limitations
PREMIER MOUNTS DISCLAIMS ANY LIABILITY FOR DAMAGE TO MOUNTS, ADAPTERS, DIS-
PLAYS, PROJECTORS, OTHER PROPERTY, OR PERSONAL INJURY RESULTING, IN WHOLE OR IN
PART, FROM IMPROPER INSTALLATION, MODIFICATION, USE OR MISUSE OF ITS PRODUCTS.
PREMIER MOUNTS DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. PREMIER
MOUNTS IS NOT RESPONSIBLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUD-
ING BUT NOT LIMITED TO, INABILITY TO USE ITS PRODUCTS OR LABOR COSTS FOR REMOV-
ING AND REPLACING DEFECTIVE PRODUCTS OR PARTS. SOME STATES DO NOT ALLOW THE
EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE
LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU.
What Customers Must Do for Limited Warranty Service
If you discover a problem that you think may be covered by the warranty you MUST REPORT it in writing to
the address below within thirty (30) days. Proof of purchase (an original sales receipt) from the original con-
sumer purchaser must accompany all warranty claims. Warranty claims must also include a description of the
problem, the purchaser’s name, address, and telephone number. General inquiries can be addressed to Premier
Mounts Customer Service at 1-800-368-9700. Warranty claims will not be accepted over the phone or by fax.
Premier Mounts
Attn: Warranty Claim
3130 E. Miraloma Avenue
Anaheim, CA 92806
How State Law Applies
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER
RIGHTS WHICH VARY FROM STATE TO STATE.
Installation Instructions
Page 9
|