LiL’ KiCK SCooter
OWNER’S MANUAL
read and understand this entire manual before riding!
do not retUrn to Store!
note: manual illustrations are for demonstration purposes only.
illustrations may not reflect exact appearance of actual product.
Specifications subject to change without notice.
please have your 22 character product i.d. code ready before
contacting razor for warranty assistance and/or replacement parts.
product i.d. Code: _____________ - ____________ - ____________
Item Numbers:
Blue 13014940
Pink 13014961
US_131104
Before You BegiN
Remove contents from box. Inspect the contents of the box for scratches in the paint and/or dents that may have
occurred during shipping. Because your scooter was partially assembled and packed at the factory, there should not be
any problems, even if the box has a few scars or dents.
Warning: DO NOT
USE NON-RAZOR PARTS
WITH YOUR SCOOTER.
Razor scooters have been built to
certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on
the basis of its compatibility with
the frame, fork and all other parts.
Certain aftermarket products may
not be compatible. Use of any non-
Razor product parts will void your
warranty.
q Estimated Assembly and Set-Up Time
Adult assembly required.
Allow up to 10–15 minutes for assembly.
Handlebar Pad
Handlebar
Grips
T-bar
Collar Clamp and Cover
PRODUCT I.D. CODE
1. Underneath the deck
Front Fork
2. UPC Side of Box (not shown)
Front Wheel
Deck
Barcode
Location
Rear Wheels
q Required Tools
Two (2)10 mm and 13 mm
wrenches
(Included)
Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time. Please have the
product I.D. code available for better assistance.
2
Set-Up and USage
q Assembling the Handlebars
Tools Needed: 10 mm wrench
Note: For further assistance, please
refer to page 5 for parts breakdown.
1 Align the holes on the handlebars and the T-bar. Insert handlebar bolts
into the top of the handlebar and through the T-bar. Install the washers and
nuts onto the bottom of the handlebar bolts. Tighten securely into place
using a 10 mm wrench.
2 Place the handlebar pad over the
handlebars and secure tightly with
the velcro cover.
q Assembling the Rear Wheels
Tools Needed: Two (2) 10 mm wrenches
Rear wheel hardware sequence
3-1
3-3
3-1 - Locknut
3-2 - Spring washer
3-3 - Washer (small)
3-4 - Axle bolt
3-2
3-5
Wheel
Frame
3-5
3-5 - Washer (large)
3-2
3-4
3-3
3-1
1 Remove the locknut, spring washer and washers (x3) from one side of the axle bolt. Insert the axle bolt through
the rear wheel. Insert the large washer (3-5) onto the axle bolt between the frame and rear wheel and slide the axle
bolt through the frame. Slide the other large washer and wheel onto the axle bolt. Note: Wheels are interchangeable.
2 Insert the small washer (3-3), spring washer (3-2) and locknut (3-1) onto
3 Make sure the locknut, spring
washer and small washer are securely
tightened against the wheel.
the axle bolt and tighten securely using two (2) 10 mm wrenches.
3
Set-Up and USage
q Assembling the Front Fork
Tools Needed: 13 mm wrench
B
a
B
A
C
1 Remove the black protective cover from the
top of the fork. Using a 13 mm wrench, loosen
collar clamp bolt and slide collar clamp (B) up
the fork and remove. Remove washer (A) from
fork. Insert the front fork into the steering tube.
Slide washer (A) back onto the front fork. Slide
collar clamp (B) back down onto the fork until it
is sitting directly on top of washer (A).
q Attaching the T-bar
Tools Needed: 13 mm wrench
C
1 Slide collar clamp cover (C) up
to the middle of the T-bar. Insert
the T-bar all the way down into the
front fork.
2 Align the handlebars with the
front wheel and using a 13 mm
wrench, tighten the collar clamp
bolt until the handlebars are
locked securely into place. Slide
the collar clamp cover down over
the collar clamp.
Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time. Please have the
product I.D. code available for better assistance.
4
LiL’ KiCK partS
Keep your Lil’ Kick scooter working for years with genuine Razor parts. Visit our web site to purchase replacement parts.
(Specifications subject to change without notice.)
1
2
3
Handlebar Grips
Handlebar Pad
Handlebar
5
6
Collar Clamp Cover
Collar Clamp
9
Front Wheel
11 Rear Wheel (x2)
9-1 Fixed Cap (x2)
9-2 C Clip (x2)
9-3 Front Axle
11-1 Short Bushing / Spacer (x4)
12 Rear Axle Bolt
6-1 Bolt
3-1 Bolt (x2)
3-2 Spring Washer (x2)
3-3 Nut (x2)
T-bar
6-2 Spring Washer
6-3 Lock Nut
Washer
12-1 Rear Tube Cover (x2)
12-2 Washer (Large) (x2)
12-3 Washer (x2)
9-4 Front Wheel Bushing /
Spacer (x2)
7
8
10 Front Fork
10-1 Fork Cover (x2)
4
Plastic Headset
(upper/lower)
12-4 Spring Washer (x2)
12-5 Locknut (x2)
1
2
3-1
3
1
3-2
3-3
4
5
6
6-3
6-2
6-1
7
8
11
11-1
9-1
9-2
9-3
11-1
9
12-5
12-4
12-3
11-1
9-2
9-1
11
11-1
12-2
10
12-1
10-1
11-2
9-4
12
12-3
12-4
12-5
5
Safety reminderS
PRE-RIDE CHECKLIST
Loose Parts
Safety Gear
q
q
Check and secure all fasteners before every ride. Make sure the T-bar
and wheels are tight. There should not be any unusual rattles or
sounds from loose parts or broken components.
Always wear proper protective equipment, such as an approved safety
helmet, elbow pads and kneepads. Always wear close toe shoes (lace-
up shoes with rubber soles), never ride barefooted or in sandals and
keep shoelaces tied and out of the way of the wheels.
Frame, Fork and Handlebars
q
Check for cracks or broken connections. Although broken frames are
rare, it is possible for an aggressive rider to run into a curb or a wall
and wreck, bend or break a frame. Get in the habit of inspecting yours
regularly.
Warranty
Razor Limited Warranty
Razor does not offer an extended warranty. If you have purchased an
extended warranty, it must be honored by the store at which it was
purchased.
The manufacturer warranties this product to be free of manufacturing defects
for a period of 6 months from date of purchase. This Limited Warranty does
not cover normal wear and tear or any damage, failure or loss caused by
improper assembly, maintenance, or storage or use of the Lil’ Kick scooter.
For your records, save your original sales receipt with this manual and write
the barcode number below.
This Limited Warranty will be void if the product is ever:
• used in a manner other than for recreation;
• modified in any way;
__________________________________________
Item Number:
• rented.
Blue 13014940
Pink 13014961
The manufacturer is not liable for incidental or consequential loss or damage
due directly or indirectly to the use of this product.
need Help? Visit our web site for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time. Please have the
product I.D. code available for better assistance.
Printed in China for:
Razor USA LLC
PO Box 3610
Cerritos, CA 90703
Copyright © 2003 - 2013 Razor USA, LLC. All rights reserved. RAZOR and the Razor Logo
Design are among the registered trademarks of Razor USA LLC in the United States and/or
select foreign countries.
US_131104
7
|