R9993
3 Band Portable Radio
Please read this manual before use
Controls
(Left side)
(Rightside)
7
6
8
5. DC input socket
6. Headphone socket
7. Volume control
5
8. Battery compartment
If you need any further advice, please call our Technical Helpline on :-
2
020 8758 0338 (Mon-Fri)
Battery operation
1. Remove the Battery cover on the rear of the unit by pushing the
catch in the direction of the arrow.
2. Insert four LR6 (AA size) batteries into the spaces in the compart-
ment. Take care to ensure all batteries are inserted with the correct
polarity as shown inside the battery compartment. Replace the
battery cover.
1
3. Reduced power, distortion, and a ‘stuttering’ sound are all signs that
the batteries may need replacing.
4. If the radio is not to be used for any extended period of time it is
recommended that the batteries are removed from the radio.
Operation via an AC adaptor (not included)
The AC adaptor for use with the R9993 should provide 6 volts DC output
at 300mA centre pin negative (Roberts type PU6-B).
1. Place your radio on a flat surface.
2. Plug the adaptor lead into the DC input socket located on the left
hand side end of your radio ensuring that the plug is pushed fully into
the socket. The batteries will be automatically disconnected.
3. Plug the adaptor into a wall socket and switch on.
•
The unit remains connected to the mains even when it is switched
off. The unit is only fully isolated from the mains if the AC adaptor
is removed from the wall socket.
3
Operating your radio
1. Switch on your radio by rotating the Volume control anti-
clockwise until a click is heard. The Power LED will light up
2. Set the Waveband selector to the required waveband.
3. Adjust the Volume control until a hissing sound is heard.
4. Rotate the Tuning knob to select the desired station. On MW and
LW the Tuning scaleis marked in kilohertz (kHz). On FM the Tuning
scale is marked in Megahertz (MHz).
1
5. For MW and LW reception rotate your radio to the position giving best
reception.
6. For FM reception fully extend the Telescopic aerial and then angle
and rotate for best reception.
6
7. Adjust the Volume control to the required sound level.
2
4
8. To switch off your radio rotate the Volume control fully clockwise
until a click is heard.
Note : The telescopic aerial is inoperative on MW and LW.
If you need any further advice, please call our Technical Helpline on :-
4
020 8758 0338 (Mon-Fri)
Headphones
1. A Headphone Socket (3.5mm) located on the right hand end of
your radio is provided for use with either headphones or an
earpiece. Inserting the headphone plug automatically mutes the
internal loudspeaker.
Volume
General
Do not allow this unit to be exposed to water, steam or sand. Do not leave
your radio where excessive heat could cause damage such as in a
parked car where the heat from the sun can build up even though the
outside temperature may not seem too high. It is recommended that the
FM band be used wherever possible as better results in terms of quality
and freedom from interference will usually be obtained than on the MW
or LW bands.
The name plate is located on the bottom of the unit.
5
Specifications
Circuit Features
Loudspeaker
Output Power
Headphone socket
Aerial System FM
MW
77mm
Power Requirements
Batteries
External
4 x LR6 (AA size)
DC 6 Volts @ 300mA
400 mW into 8ohms
3.5mmdia
centre pin negative (-).
Battery Life
Telescopic aerial
Built-in Ferrite aerial
Built-in Ferrite aerial
Approx. 80hrs of listening for 4 hours a day at
normal volume using alkaline cells.
LW
Frequency Coverage
FM
87.5-108MHz
522- 1620kHz
144- 281kHz
MW
LW
The Company reserves the right to amend the specification without notice.
If you need any further advice, please call our Technical Helpline on :-
6
020 8758 0338 (Mon-Fri)
Guarantee
This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component
breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced
free of charge.
The guarantee does not cover:
1. Damage resulting from incorrect use.
2. Consequential damage.
3. Receivers with removed or defaced serial numbers.
N.B. Damaged or broken telescopic aerials will not be replaced under guarantee.
Procedure:
Any claim under this guarantee should be made through the dealer from whom the instrument was purchased. It is likely that your Roberts' dealer
will be able to attend to any defect quickly and efficiently, but should it be necessary the dealer will return the instrument to the company’s service
department for attention. In the event that it is not possible to return the instrument to the Roberts' dealer from whom it was purchased, please
contact Roberts Radio Technical Services at the address shown below.
ROBERTSRADIOTECHNICALSERVICES
97-99 Worton Road
Isleworth Middlesex
TW76EG
Technical Helpline :- 020 8758 0338 (Mon-Fri during office hours)
Issue1
|