Thank you for purchasing the Rocketfish SuperSpeed 7-port USB 3.0
Hub.
Installing your hub
FCC Part 15
Note: Make sure that the driver for your existing USB 3.0 controller
has been installed on the computer. When you connect your hub
to a computer, the computer detects your hub and automatically
installs it.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measure:
Features
• Adds seven USB 3.0 ports to your USB 3.0 enabled computer.
1 Slide open the cable compartment cover on the back side of
your hub, pull out the USB cable, then plug the cable into any
available USB 3.0 port of the computer.
Note: You can purchase a USB 3.0 cable (A male to A female) to
extend the length of cable.
• Supports ultra-fast data transfer rates of up to 5 Gb/s (10 times
faster than USB 2.0).
• Is backward compatible with USB 2.0 and USB 1.1 devices.
• Supports Microsoft® Windows® 7, Windows Vista®, and Windows®
XP operating systems .
• Supports MAC OS X version 10.4 or higher operating system (USB
2.0 only).
• Works with high-bandwidth SuperSpeed USB 3.0 devices, such as
external hard disks, high resolution webcams, camcorders, video
surveillance cameras, digital video cameras, multi-channel audio,
and more.
SuperSpeed 7-port USB 3.0 Hub
RF-30HUB7
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
USB 3.0
cable
• Has hot swappable and Plug & Play capability.
– Consult the dealer or an experienced radio/TV technician for
help.
• Has over-current protection built into each port to protect both
connected devices and your hub from power surges.
• Complies with Universal Serial Bus 3.0 Specification, Revision 1.0.
2 Plug the AC power adapter into your hub’s DC jack and into a
power outlet. The driver installs automatically and the power
LED lights. Your hub is ready for use.
Caution: Only use the AC power adapter specified by the
manufacturer.
SAFETY: General Power Safety
Caution:
Package contents
• SuperSpeed 7-port USB 3.0 HUB
• AC power adapter
• Check the voltage rating before you connect the equipment to
an electrical outlet to ensure that the required voltage and
frequency match the available power source.
• Place the AC adapter in a ventilated area, such as a desk top or
on the floor. Do not cover the AC adapter with papers or other
items that will reduce cooling.
• AC adapters can become very hot and could cause burns or fire
hazards. Make sure to use them properly.
• Do not use an AC adapter with frayed or exposed wires.
• AC adapter can cause a fire or chemical hazard if not used
properly. Do not disassemble.
• Quick Setup Guide
Specifications
Interface
1 upstream USB port:
Components
USB 3.0 A plug (with cable)
7 downstream USB ports:
USB 3.0 A receptacle
DC jack
Dimension (W × H × D)
4.35 × 4.17 × 1.42 in.
(11.05 × 10.6 × 3.6 cm)
• If you use an extension cord, ensure that the total ampere rating
of the products plugged in to the extension cord does not
exceed the ampere rating of the extension cord.
Weight
140 g
Interface to PC
Interface to Device
Data transfer rate
USB 3.0
USB 3.0
FCC Part 15
USB 3.0 : 5.0 Gb/sec
USB 2.0 : 480 Mb/sec
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
Indicator
Power LED indicator
AC Power Adapter 12V/3A
DC+5V
USB 3.0
ports
USB 3.0
ports
Power source
Output voltage per-port
Output current per-port
System support
One-year limited warranty
900mA (Max)
Windows XP
Windows Vista
Windows 7
MAC OS X version 10.4 or higher
Contact Rocketfish:
For customer service, call 1-800-620-2790
Operating temperature
Operating humidity
Certification
32° ~ 104°F (0° ~ 40°C)
20 % ~ 80 % RH
USB 3.0 ports
© 2011 BBY Solutions, Inc., All Rights Reserved.
FCC Class B, ICES-003, CE
Distributed by Best Buy Purchasing, LLC
7601 Penn Avenue South, Richfield, MN USA 55423-3645
ROCKETFISH is a trademark of BBY Solutions, Inc. All other products and
brand names are trademarks of their respective owners.
System requirements
• PC or Macintosh computer with an available USB 3.0 port. (You
can connect to a USB 2.0 port, but your hub will only run at USB
2.0 speeds.)
QUICK SETUP GUIDE
ENGLISH 11-0325
|