CV8010
CV8020
CV8030
030180/52-03
VITAL
3
4
2
C
Vital
Speeds/temperatures
5
5 bis
6
6 bis
7
8
9
10
Please read the safety instructions before use
GB
1 - DESCRIPTION (drawing n°1)
A - Concentrator
F – Position indicator
B - Cold air shot
C - "Vital" switch
G - Removable grid
H – Hanging loop
D - Temperature control
E - Fan power control
2 - SAFETY
• Ensure that the voltage of your electrical installation
corresponds to that of your appliance. Incorrect connection
may cause irreversible damage which will not be covered
by the guarantee.
• Don’t use your appliance and contact a service Centre if:
- your appliance is dropped
- if it doesn’t work normally
• Never use the dryer with wet hands or near water in a
bath, washbasin or any other recipient.
• If the hair dryer is used in a bathroom, disconnect after
use since water can present a danger even when the hair
dryer is not being used.
•The dryer must be disconnected:
- before cleaning and maintenance.
- in the event of a malfunction
- as soon as you have finished using it
- if you have to leave it unattended, even for a few
moments.
•To ensure additional protection, we recommend that you
have a differential residual circuit breaker installed, with an
operating differential of no more than 30 mA. Contact your
installer for advice.
• If the power cable is damaged, it must be replaced by the
manufacturer, its after-sales service or a person with simi-
lar qualifications to avoid any danger.
•Your appliance can only be repaired using special tools.
•The dryer is equipped with a heat-sensitive safety device.
In the event of overheating (for example if the rear grill is
blocked), the dryer will stop automatically: contact the
After-Sales Service.
GUARANTEE
This appliance has been designed for a domestic use only.
It can not be used in any professional apllication.
The guarantee becomes null and void in case
of incorrect use.
3 - USE
GB
This hairdryer gives you professional results while
maintaining the vitality of your hair:
• “Vital” Function: the central slide automatically
programmes a temperature of 59°C combined with an air
speed of 15 m/s.This ideal combination allows rapid drying
while preventing the appearance of cracks and ensuring
that the scales on the hair’s surface remain smooth.
• What’s more, you have a large choice of temperatures and
air speeds for drying and styling that are perfectly adapted
to your needs.
1)“VITAL” SETTING (figure n° 2):
• Switch on the appliance (speed control in position 1)
• Slide the central switch C to the upper position:
- the pictogram is displayed in the window and you have
selected the automatic position: the temperature of 59°C is
moderate so as to protect your hair, and the air speed of
15 m/s is fast for effective drying.
- the side slides (temperature, speed) are not operational.
2) SEPARATE SPEED ANDTEMPERATURE SETTINGS
(FIGURE N°3):
When the central slide C is in the lower position, you have
a choice of 6 temperature / air speed settings for your
hairdryer:
- For drying:
Hair is at its most vulnerable when it is wet.
A gentle temperature is advisable:
• Ultra-gentle drying
•• Drying for normal hair
A strong blast of air is recommended (speed 2).
- For styling:
On hair that is already dry, it is possible to use a higher
heat setting (temperature •••) for easier styling and hold.
Pressing the Cold air button every so often helps to fix
your style.
An average blast of air is recommended so as not to ruin
your hairstyle (speed 1).
4 - ACCESSORIES:
CAUTION: BAYONET FITTING: ROTATETHE ACCESSORIES
TO ATTACH OR REMOVE FROMTHE HAIRDRYER.
Concentrator: (A)
To blow dry or to dry a specific area of hair, use the
concentrator nozzle, which will direct the hot air flow
onto the required spot.
“Moving Massager” diffuser (drawing n° 5)
•To add volume to your hair, without damaging it, use
GB
the mobile finger diffuser.The round-tipped fingers gently
grasp your hair at the roots and lift it.The massaging
action provides bouncy, long-lasting volume from the very
root of your hair. (7/8)
• Use your diffuser after shampooing and thoroughly
towel-drying your hair.
• On shoulder-length or long hair, it is preferable to pre-dry
lengths and tips.
• Short and shoulder-length hair provides the best results.
“Classic Volume” diffuser (drawing n°6)
• Curled effect (naturally curly or permed hair), (drawing
n°9)
Hold your head down and pass the diffuser through the
lengths and tips.
• Natural volume effect (short or shoulder-length hair)
(drawing n°10)
Apply the diffuser to the root and make circular move-
ments.
5 - CLEANING:
CAUTION: always unplug your appliance before cleaning.
•Your hair dryer requires very little attention.
You can clean it, together with its accesso-
ries, using a slightly damp cloth to remove
hair or impurities trapped in the rear grid.
• Never clean your appliance with alcohol.
• Never immerse your appliance or its
accessories in water.
• Carefully dry all parts you have just cleaned.
6 - PROTECTION OFTHE ENVIRONMENT
At the end of the life of your product, it should go to a
specially-adapted waste recycling centre.
7 -TROUBLESHOOTING
-Your appliance does not work in the VITAL position:
check that the air speed control is not at 0.
-Your hairdryer stops automatically:
check that the rear grille is not blocked with hair; if this is
the case, take off the removable rear grille and remove the
hair.
WIRING INSTRUCTIONS - FOR U.K. ONLY.SAFETY NOTES - FOR REWIREABLE OR
MOULDED PLUG
The mains lead of this appliance may be already fitted with a BS 1363 13 A plug. Should
the fuse need to be replaced, a 13 A ASTA approved BS 1362 fuse must be used.
If your socket outlet is not suitable for the plug, then the plug must be removed (cut off
if it is a moulded on plug) and an appropriate one fitted.Warning : dispose of a plug that
has been cut from the power supply cord, as such a plug is hazardous if inserted in a
live 13 A socket outlet elsewhere in the house.
Always replace the fuse cover after fitting a fuse.The plug must NOT be used if the cover
is omitted or lost until a replacement is obtained - make certain that only the correct fuse
cover is used and fitted.
For plugs with a detachable fuse cover the replacement must be the same as the
colour insert in the base of the plug, or as directly by the embossed wording on the
base of the plug.
Brown
or red
If the detachable fuse cover is lost, a replacement may be
L
purchased from an approved Rowenta Service Centre (see
Fit correct
fuse
Blue or
black
enclosed Service Information leaflet). Information for supply
may also be obtained from the plug manufacturer.
N
Use cable
gripper
U.K ONLY - FITTING A PLUG
Important : the wires in this lead are coloured in accordance with the following codes Blue,
Neutral, Brown, live. Please read the instructions given below before connecting the cord
to a plug. If in doubt, please consult a qualified electrician.
As the colours of the wires in the mains lead of this appliance may not correspond with
the coloured markings identifying the terminals in your plug, proceed as follows :
• the wire which is coloured BLUE must be connected to the terminal which is marked with
the letter " N " or coloured BLACK.
• the wire which is coloured BROWN must be connected to the terminal which is marked
with the letter " L " or coloured RED.
Neither core is to be connected to the earth terminal of a three-pin plug.
This appliance requires a 13 fuse ASTA approved to BS 1362.
|