Ruby Tech Switch FGS 2824 User Guide

R
RUB  
TECH  
Gigabit Switch  
Networking & Communications  
L2 Managed Switch  
FGS-2824  
FGS-2824:  
8-Port TP+16-Port SFP GbE L2 Managed Switch  
Benefits  
QoS support layer 4 classification  
Key Features  
Standard compliance  
---IEEE 802.3x Flow Control capability  
---IEEE 802.1q VLAN  
The switch supports not only Layer 2 802.1p Priority Queue control, but also  
supports programmable higher layer classification and prioritization to enable  
enhanced Quality of Service (QoS) support for real time applications base on  
information taken from Layer 2 to Layer 4, such as VoIP.  
---IEEE 802.1p  
RoHS Compliance  
Performance  
Port Mirroring Helps Supervisor Monitoring Network  
Port mirroring copies traffic from a specific port to a target port. This  
mechanism helps track network errors or abnormal packet transmission  
without interrupting the flow of data.  
Switching capacity:  
---24 Gigabit Ethernet ports with non-  
blocking wise speed performance.  
---8 K MAC addresses  
---400KB on-chip frame buffer.  
---Supports Jumbo frame support, up to  
9K  
Q-in-Q VLAN for performance & security  
The VLAN feature in the switch offers the benefits of both security and  
performance. VLAN is used to isolate traffic between different users and thus  
provides better security. Limiting the broadcast traffic to within the same VLAN  
broadcast domain also enhances performance. VLAN support enabling  
advanced techniques such as "802.1Q-in-1Q" to be deployed.  
---Broadcast/Multicast Storm  
Suppression  
---Port Mirroring  
VLAN  
---Port-base VLAN  
---IEEE802.1q tag-base VLAN, up to 256  
active VLANs  
802.3ad LACP for Bandwidth Aggregation  
The Gigabit ports can be combined together to create a multi-link load-sharing  
trunk. Up to 12 Gigabit ports can be set up per trunk for bandwidth up to  
24Gbps, all traffic is aggregated based on MAC addresses, thus balancing the  
traffic load. The switch supports up to 8 trunking groups. Port trunks are useful  
for switch-to-switch cascading, providing very high full-duplex speeds.  
---Q-in-Q is an efficient method for  
enabling Subscriber Aggregation.  
VSM(Virtual Stacking Management)  
---Support 16 devices stacking  
---Multiple switches can be managed via  
one IP address, just like software  
stacking  
802.1x Access Control Improve Network Security  
802.1x features enable user authentication for each network access attempt.  
Port security features allow you to limit the number of MAC addresses per  
port in order to control the number of stations for each port. Static MAC  
addresses can be defined for each port to ensure only registered machines  
are allowed to access. By enabling both of these features, you can establish  
an access mechanism based on user and machine identities, as well as  
control the number of access stations.  
---Low cost and easily to establish  
network environment, not extra  
hardware require.  
---Not center on the physical location of  
wiring closets  
Qos  
---Supports Layer 4 TCP/UDP Port and  
ToS Classification  
802.1d Compatible & 802.1w Rapid Spanning Tree  
---Supports 802.1p QoS with two level  
priority queue  
For mission critical environments with multiple switches supporting STP, you  
can configure the switches with a redundant backup bridge path, so  
transmission and reception of packets can be guaranteed in event of any  
fail-over switch on the network.  
---Supports priority in a Q-in-Q tag  
Bandwidth Control  
---Supports Ingress, Non-unicast and  
Egress Bandwidth rating management  
with a resolution of 1Mbps  
Protocol  
Broadcast/Multicast Storm Control  
To limit too many broadcast/multicast flooding in the network, broadcast/  
multicast storm control is used to restrict excess traffic. Threshold values are  
available to control the rate limit for each port. Packets are discarded if the  
count exceeds the configured upper threshold.  
LACP  
---Port trunking with 8 trunking group  
---Up to 12 ports for each group.  
 
R
RUB  
TECH  
Gigabit Switch  
Networking & Communications  
L2 Managed Switch  
SFP.BL5.S20  
SFP.BL3.S20  
1000Base-LX GE SFPBiDi_LC 20Km ModuleSingle Fiber 1550nm, Type 1  
1000Base-LX GE SFPBiDi_LC 20Km ModuleSingle Fiber 1310nm, Type 2  
Note: FGS-2824 only supports the SFPtransceiver from the following vendors.  
1. Ruby Tech Corporation  
2. Agilient Technologies  
3. AVAGOTechnologies  
4. Finisar Corporation  
Ruby Tech Corp.  
3F, No.1, Lane 50, Nan Kang Road, Sec.3, Taipei, Taiwan  
TEL:886-2-2785-3961 FAX:886-2-2786-3012  
 
Technical information listed is subject to change without prior notice. All brand names and trademarks are property of their respective owners.  
Copyright c 2008 Ruby Tech Corp. All rights reserved.  
2008-07.30-Version A  

Redring Outdoor Shower TMV3 User Guide
Renesas Network Card M3062PT3 RPD E User Guide
Roadmaster GPS Receiver VRBT200V User Guide
Rockford Fosgate Stereo Amplifier 240X4 User Guide
Rosewill Computer Drive RX82 UJBOD User Guide
Rover Lawn Mower ProCut 50 User Guide
Samsung Cell Phone GH68 03117A User Guide
Samsung MP3 Player MCD MP65 User Guide
Samsung Telephone iDCS 500 User Guide
SanDisk Computer Drive 80 11 01491 User Guide