REFRIGERATOR
OWNER’S INSTRUCTIONS
Model RA18VH/RA18FH
RA20VH/RA20FH
Before operating the appliance, please read
this manual thoroughly, and retain for future
reference.
Operating Instructions
Part features
Installing the appliance
Safety warning
Setting up the refrigerator
Ice making
Temperature control
Defrosting
Using the water dispenser
•
•
•
•
•
•
•
•
Food storage guide
Cleaning accessories
Trouble shooting
•
•
•
Specification
Model
RA18FH
540x599x1,246(Stand)
540x599x1,156(No-Stand) 540x599x1,250(No-Stand)
RA18VH
RA20FH
540x599x1,340(Stand)
RA20VH
WARNING
Dimension(WxDxH) mm
- Keep ventilation openings in the appliance enclosure
or in the built-in structure,clear obstruction
- Do not use mechanical devices or other means
to accelerate the defrosting process,other then
those recommended by the manufacturer.
- Do not damage the refrigerant circuit (applicable only
for appliances with refrigeration circuits which
are accessible to the user)
- Do not use electrical appliances inside the food
storage compartments, unless they are of the type
recommended by the manufacturer.
- Damaged supply cords must be replaced by
the manufacturer,service agent or similarly
Gross Capacity
Net Capacity
Rated Voltage
Reted Frequency
180 liter
175 liter
200 liter
194 liter
127V ~
60 Hz
220V~ 230-240V~ 127V ~
220V~ 230-240V~
50/60 Hz 50 Hz
75
50/60 Hz 50 Hz
60 Hz
100
100 W
75 W
110W
W
W
110W
0.5A
Rated Input
Rated Current
Defrosting Input
1.1A
0.5A
-
0.5A
1.1A
0.5A
-
Climatic Class
of The Appliance
T
Reted Maximum
Input of Lamp
Refrigerance
15 W
15 W
HFC - 134a (120g)
36.8kg 37.2kg
0.917 m
HFC - 134a (120g)
38.0kg 38.5kg
0.917m2
Mass
Rated Shelf Area
Power Consumption
Percentage Running Time
Quantity of Ice Making
Freezing Capacity
0.48 kWh / 24
38 %
0.54kWh / 24 h
42 %
qualified person to avoid hazard.
- Keep the key out of reach of children and not in the vicinity
of the refrigerator.
2.97Kg / 24 h
-
2.64Kg / 24 h
-
MADE IN THAILAND
DA68-01338F REV(0.0)
INSTALLING THE APPLIANCE
SAFETY WARNINGS
Selecting the location for appliance.
• Install the appliance properly on the flat and
firm surface.
Specification of electric power.
• The electric power specification of the
appliance is attached inside at the top of
the door or outside at the back.
Do not use any extension cords or
double adaptors.
• Do not plug several appliances into the
same multiple power board. This could
cause over heating and the risk of fire.
Install appliance in the available space.
• Allow 1 foot(30cm)from the ceiling, and 2
inches( 5cm ) from the wall.
About 30cm
About 5cm
About 5cm
Earthing the appliance.
• If the socket is the 2-legged type, the
appliance must be earthed.
Install appliance in the appropriate location.
• Place the appliance away from sunlight or heat.
• Do not connect the earthing wire to the gas
pipes or telephone lines.
Replacing the lamp.
Install appliance in a damp place.
• There is a risk of eletric shock or
malfunctions.
1. Unplug the power cord from the socket.
2. Remove Chilled tray.
3. Unscrew by plus-type driver then take out
lamp cover. (optional model only)
4. Turn the lamp counter clockwise.
5. Replace new lamp same specification as
original one.
Warning ! : Disconnect power supply before
replacing the lamp.
SETTING UP THE REFRIGERATOR
ICE MAKING
Fill the ice tray with
1)
Step 1
water at about 80% of
its capacity, or at its
“water level” indicator.
Clean up inside of the refrigerator with a
clean cloth.
2) Carefully place the ice tray on the freezer
shelf otherwise the splashed water will be
frozen and cause the ice tray is stuck hard.
Step 2
Insert the power plug into the socket
while keep the door open for checking
the interior light, Then turn the
temperature control button to “MAX”.
For making quick ice
cubes, the temperature
control button must be
set to “MAX”
Temp. Control
3)
Step 3
Close the door and let the refrigerator
operate for 2-3 hours.
4) The water will become the ice cubes with in
3-4 hours. Please remove the ice tray by
pulling it out. Never use any kind of
instrument. This may cause damage on the
freezer.
Step 4
Check the refrigerator temperature by
touching inside the freezer.
To take the ice cubes of the
the ice cube tray, you should
gently twist the ice tray (As
shown), Do not bend it over.
5)
Step 5
The appropriate temperature should be
controlled by turing the temperature
control button to “4”, or the desired
temperature can be adjust. Now your
refrigerator is ready to work.
Wait 5
minutes
NOTE : After unplug the appliance, wait for about 5minutes before
restarting.
TEMPERATURE CONTROL
DEFROSTING
Defrosting should be often operated, as the
thick frost (1/4inch) may cause low
efficiency of the refrigerator.
The temperature control is level “2”
• The temperature at low level “2” is used
if extreme cool is no used.
• It is used when there is not much food in
the refrigerator.
1) If the thick frost is over the red level,
should push the defrosting button.
Temp. Control
Check level
The temperature control level “4”
• The temperature at level “4” is suitable for
storing food.
• It is appropriate for operating the
refrigerator.
2) As soon as the “Push Defrosting” is
pushed, the frost is gradually defrosting.
Temp. Control
3) Do not use a knife or other metal
instruments to remove ice/frost. It may
cause damage on the freezer.
The temperature control level “MAX”
• “MAX” is properly used if the power cool
is in need.
• It is used when there are a lot of food.
Temp. Control
4) After defrosting, the button will pop up
and the refrigerator working properly.
NOTE : To save energy consumption, Do not set the refrigerator temperature
lower than necessary
USING THE WATER DISPENSER (MODEL WITH WATER DISPENSER ONLY)
If dringking water is needed, push the
water dispenser lever with a glass.
To refill the water tank, remove the cap
and fill it up with drinking water, then
keep the cap into place.
When you want to clean water tank, let water out of the tank. Remove x away from ➁
then remove the water tank from the locking device by lifting it up. Remove the lid ➂ by
pulling outward straightly. Wash it with detergent and warm water, then wash with clean
water.
After drying it with a clean cloth, place it correctly.
Steps to Operate the water dispenser
1. The water tank should be cleaned up firstly before use, as the dust and bad smell can
be removed.
2. The water tank should be filled up with pure drinking water. The water dispenser
devices might be damaged by the syrup, soft drink, and hot water.
3. If the appliance has just been installed, please let 3 or 4 glasses of water away to
remove the dust and plastic smell of the water tank.
4. To prevent soaking on the floor, you should softly push the water dispenser lever with a
glass, then pull it backward slowly and wait until the last drop of water.
5.The accessories should be removed for cleaning up at least 1-2 times a month.
FOOD STORAGE GUIDE
Allow warm food and beverages to cool
down before storing them in the appliance.
Do not let the refrigerator door open for a
long while. This will cause it lost the cool
power.
Liquid or nasty smell food should be covered
or well-wrapped before it is stored.
Do not spray water directly on the
refrigerator. This is a risk of electronic shock
or leak.
Never store any bottles of beverages in the
freezer. There is a risk of bottle explosion.
Do not put the gas container near the
appliance. As the compressor starts
working, it may catch a fire on the electric
circuit.
Please keep the space between shelves for
air circulation.
Do not store volatile and inflamable
substances in the refrigerator. The storage
of benzene, thinner, alcohle, ether LP gas
or other such substances may cause an
explosion.
CLEANING A CCESSORIES
.
Before using, the appliance should be cleaned up.
The appliance should be cleaned regularly.
.
Cleaning the r ubber door seals
Cleaning the e xterior
Clean the exterior with a mild detergent and
cloth. Dry it with a clean cloth.
If the rubber door seals are dirty, the door
will not does properly and the refrigerator
and freezer will be unable to function
efficiently. Clean the rubber door seals
with a mild detergent. Then wipe again
with a clean cloth. (But inside the rubber
doesn Õt have to be cleaned)
Cleaning the inter ior and other
accessor ies .
After removing all the stored foods, clean the
interior and other accessories with a mild
detergent and damp cloth. Then wipe again
with a clean cloth.
Warning:
.
Remove the power plug before cleaning.
.
Do not clean the appliance with bezene, thinner, or strong detergent. This will ruin the
coated materials and become rusty.
When disposing the refrigerators : Should be followed the disposal law of your country.
.
TR OUBLE SHOO TING
If there are the following problems with your appliance, please check them by yourself before
contacting the service center, If you can Õt find the solution, note down the appliance model
and running number, then contact the service center.
The appliance is not oper ating at all or the temper ature is too high
1. Check that the power plug is properly connected.
2. Check that the power plug fuse has not blown.
3. Is the temperature control on the front panel set to the correct temperature?
4. Is there too much stored food? Space of food out as much as possible to improve
ventilation.
The side of the appliance are nor mally warm
The w arm sides of the appliance is not abnormal. Because the heat
installed in the front corners of the appliance to prevent condensation from
exchanger pipes are
defrosting. In very
humid weater, condensation may form on the outer surface of the appliance when moisture
in the air comes into contact with the cool surface of the appliance. Thus, do not cover the
refrigerator with cloth or other materials.
|