Assembly Instructions for Television TurntablesTM TV13, TV20, TV27, TV32
Congratulations on your purchase! Sanus Systems Television TurntablesTM are functional, attractive, and inexpensive. They
are finished with a black powder that is both durable and beautiful. Please check carefully to make sure there are no miss-
ing or defective parts. Never use defective parts. Improper assembly may cause damage or injury. If you do not understand
can quickly assist you with installation questions and missing or damaged parts.
Supplied Parts: (1) Television Turntable
Supplied Parts: (1) Self Adhesive Protective Feet (pad of 4)
Diagram 1
Step 1:
Adhesive
Foot
Bottom of
Position the Turntable so the black nylon swivel is facing
up. Locate the circles at the end of each spoke. Next, place a
Adhesive Foot inside each circle, as shown in Diagram 1.
NOTE: If you are going to use the optional TV-VCR Kit,
page, otherwise, proceed to Step 2.
Diagram 2
Top of Turntable
Step 2:
Flip the Turntable over and place it in the desired position
on a shelf or cabinet so the Adhesive Feet are facing down
and are in direct contact with the shelf or cabinet as shown
in Diagram 2.
Assembly Instructions for Optional TV-VCR Kit
TV Turntable (sold separate)
Contents: (1) Base
Contents: (2) Support Pillars
Contents: (4) Plastic Dowels
Contents: (4) Allen bolts
Support
Pillar
Support
Pillar
Contents: (1) Allen Wrench
Sanus Systems 2221 Highway 36 W. St. Paul, MN 55113
|