VMPL2
(6901-100135 <01>)
Thank you for choosing the Sanus Systems Vision Mount wall mount. The Sanus Systems
VMPL2 wall mount is designed to support a monitor weighing up to 79 kg (175 lbs)
to a vertical wall either flat or at a fixed 5 degree tilt. Hardware for multiple mounting
configurations is included.
WARNING
This product contains small items that could be a choking hazard if swallowed.
Keep these items away from young children!
CAUTION
This product is not designed for use in steel stud walls or old cinder block walls. The
wall must be capable of supporting up to five times the weight of the monitor and
mount combined. If you are uncertain about the nature of your wall or its ability
to support the monitor, contact Sanus Systems Customer Service, or a qualified
contractor.
CAUTION
Do not use this product for any purpose not explicitly specified by Sanus Systems.
Improper installation or use may cause personal injury and/or property damage. If
you do not understand these instructions, or if you have doubts about the safety of
the installation, contact Sanus Systems Customer Service. Sanus Systems is not liable
for injury or damage caused by incorrect installation or use.
Hardware and procedures for multiple mounting configurations are included.
When you see this symbol, choose the correct configuration to suit your
needs. Not all hardware included will be used.
OPT
Sanus Systems 2221 Hwy 36 West, St Paul, MN 55113 USA •
1: Mount Monitor Brackets
Television, Flat Back
[05, 06,
07, 08]
[19, 20]
[13, 14,
15, 16]
[03]
Television, Curved Back or Obstruction
[13, 14,
15, 16]
[19]
[17, 18]
[03]
[09, 10,
11, 12]
[20, 21]
6901-100135 <01>
2: Mount the Wall Plate
Wood Stud
3/16 in.
CAUTION
Do not overtighten the Lag Bolts. Tighten Lag Bolts [21] only until the Lag Bolt
Washer [22] is pulled firmly against the Wall Plate [01].
12”- 24”
12”- 24”
64 mm (2-1/2 in.)
4x
[21]
[01]
[22]
6901-100135 <01>
Brick, Solid concrete and Concrete Block Mounting
1/2 in.
CAUTION
To prevent property damage or personal injury, never drill into mortar between
blocks and make sure Concrete Anchor [23] is seated flush with concrete surface.
The drywall or other covering may not exceed 16 mm (5/8 in.) in thickness.
[23]
64 mm (2-1/2 in.)
>
”
6
=
>
6”
=
[22]
[21]
3: Choose Mounting Position
5o
OPT
2x
[25]
[24]
[04]
6901-100135 <01>
4: Hang TV Onto Wall Plate
Insert Safety Bar
OPT
[02]
CSAV, Inc. and its affiliated corporations and subsidiaries (collectively, “CSAV”), intend to make this manual accurate and complete. However, CSAV makes no claim that the information contained herein
covers all details, conditions, or variations. Nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to
change without notice or obligation of any kind. CSAV makes no representation of warranty, expressed or implied, regarding the information contained herein. CSAV assumes no responsibility for accuracy,
completeness or sufficiency of the information contained in this document.
6901-100135 <01>
|