Model 596LB User Guide
DYNAMIC HAND-HELD COMMUNICATIONS MICROPHONE
MOUNTING
The 596LB is provided with a rear-case hang-up button for
use with a mounting bracket on or near associated equip-
ment. The bracket has mounting holes with clearance for
No. 6 or No. 8 screws (not supplied).
CONNECTIONS
The internal switch connections of the 596LB are shown in
Figure 1. The 596LB has a four-conductor, coiled-cord cable
(two conductors shielded) and a double-pole, double-throw,
push-button switch to control the microphone circuit and an
external relay or switching circuit. The RED and BLACK un-
shielded leads control the relay or switching circuit.
Refer to the following tables and to the wiring diagram below.
INPUT TYPE
WIRE
COLOR
FUNCTION
XLR
CONNECTOR
1/4 IN.
PHONE
PLUG
WHITE
GREEN
SHIELD
AUDIO
PIN 2
PIN 3
PIN 1
TIP
UNBALANCED
BALANCED
AUDIO GROUND
CHASSIS GROUND
SLEEVE
SLEEVE
WHITE
GREEN
SHIELD
AUDIO +
AUDIO –
PIN 2
PIN 3
PIN 1
TIP
GENERAL
RING
The Shure Model 596LB is a compact, hand-held dynam-
ic, low-impedance communications microphone with a 200
to 5,000 Hz frequency response. Designed especially for
voice communications use, it is an economical unit for ap-
plications in budget-restricted paging and other installa-
tions. The microphone is compatible with many popular pag-
ing amplifier inputs. Its tailored frequency response provides
CHASSIS GROUND
SLEEVE
BLACK
W6
W1
SWITCH
CLOSURE
RED
SWITCH
CLOSURE
clear, intelligible operation. The ARMO-DUR case is small,
light and sturdy, and fits comfortably in the palm of the hand.
It has a long-life push-to-talk switch, and a durable coiled
cable for years of reliable performance. The 596LB has a
low-impedance output.
The 596LB is furnished with a sturdy mounting bracket for
permanent installation.
N.C.
S1
WHITE
W2
W3
AUDIO +
AUDIO –
C4
.001
GREEN
MK1
Features
SHIELD
• Omnidirectional pickup pattern for optimum off-axis op-
eration
• Frequency response from 200 to 5,000 Hz, tailored for
WIRING DIAGRAM
FIGURE 1
voice communications
• Economical—the perfect choice for modest paging instal-
The 596LB can be wired for balanced-line operation and is
recommended for use where long cable lengths are re-
quired, or conditions where severe hum pickup may exist.
The 596LB can be fed directly into a standard low-imped-
ance amplifier input, or a Shure A95 Series Line Matching
Transformer (at the equipment end of the cable) can be used
for coupling the 596LB to the input of a high-impedance am-
plifier. A two-conductor shielded cable can be used for ex-
tending only the microphone circuit. If both the microphone
and the remote circuit are to be extended, a four-conductor
with two shielded conductors should be used.
lations
• Rugged and dependable under most operating conditions
• Silver-plated switch contacts for long-term low contact re-
sistance and reliable performance
• Long-life vinyl-jacketed coil-cord for years of trouble-free
operation
• Output impedance matches most paging amplifier inputs
• Virtually indestructible ARMO-DUR case
• Sturdy, convenient mounting button for attaching to equip-
The microphone circuit of the 596LB is normally open
when the microphone switch button is not depressed.
ment or nearby surface using supplied mounting bracket
2002, Shure Incorporated
27B2756 (BK)
Printed in U.S.A.
|