Silvercrest Electric Heater SOR 2600 A1 User Manual

6
Oil-Filled Radiator SOR 2600 A1  
Oil-Filled Radiator  
Operating instructions  
KOMPERNASS GMBH  
BURGSTRASSE 21 · D-44867 BOCHUM  
ID-Nr.: SOR2600A1-04/10-V2  
 
INDEX  
PAGE  
Intended Use  
2
2
3
3
3
3
4
4
4
5
5
5
6
Safety instructions  
Items supplied  
Technical data  
Description of the appliance  
Assembly  
Commissioning  
Frost protection function  
Cleaning and care  
Storage  
Disposal  
Warranty and Service  
Importer  
Read these operating instructions carefully before using the appliance for the first time and preserve this  
booklet for later reference. Pass this booklet on to whoever might acquire the appliance at a future date.  
- 1 -  
 
OIL-FILLED RADIATOR  
• In event of operating malfunctions and before  
cleaning the appliance, remove the power plug  
from the wall socket.  
Intended Use  
• Arrange for defective power plugs and/or cables  
to be replaced at once by qualified technicians  
or our Customer Service Department.  
• This heating appliance has been filled with a  
specific volume of a special oil. Should the  
appliance become damaged or leak oil then  
it may no longer be taken into use. Arrange for  
the appliance to be checked and/or repaired by  
qualified technicians.  
This appliance in intended exclusively for heating in  
domestic households. It is not suitable for commercial  
or industrial applications.  
Safety instructions  
• Do not open the housing or attempt to repair the  
appliance yourself. Should you do so, the safety  
concept of the device may be compromised and  
the warranty becomes void. Permit only authorised  
technicians to repair a defective appliance.  
• Never place the appliance in the close vicinity  
of sources of heat and protect the power cable  
from potential damage.  
Risk of electrocution!  
• Connect the oil radiator only to correctly installed  
and earthed mains sockets. Ensure that the voltage  
supplied through the mains socket tallies completely  
with the details given on the appliance rating  
plate.  
• Do not fold or crush the power cable.  
• To disconnect, always pull the plug itself out of  
the power socket, do not pull on the power cable.  
• Never touch the oil radiator, the power cable or  
the plug with wet hands.  
• Do not place water-filled receptacles, e.g. flower  
vases, on the appliance.  
Risk of fire!  
• Do not use extension cables.  
• Never place the appliance close to inflammable  
materials, liquids or gases. Ensure there is at  
least one meter of space to all sides and above  
the appliance.  
• Under no circumstances may the appliance be  
submersed in fluids or fluids be allowed to per-  
meate the housing. Do not expose the appliance  
to humidity and do not use it outdoors. There is  
the danger of electrocution. Should liquids enter  
the housing, unplug the appliance from the power  
socket immediately and arrange for it to be  
repaired by a qualified technician.  
• Under no circumstances should the oil radiator  
be used in the vicinity of water, for example in  
a bath, shower, washbasin or in humid cellar  
rooms. The proximity of moisture presents a danger,  
even when the appliance is switched off.  
• Never leave a switched-on oil radiator unsuper-  
vised.  
• This appliance is not intended for use by indivi-  
duals (including children) with restricted physical,  
physiological or intellectual abilities or deficiences  
in experience and/or knowledge unless they  
are supervised by a person responsible for their  
safety or receive from this person instruction in  
how the appliance is to be used.  
• Children should be supervised to ensure that  
they do not play with the appliance.  
• ALWAYS position the appliance on a level and  
heat resistant surface.  
- 2 -  
 
• Do not place open fire sources, e.g. candles,  
on the appliance.  
Description of the appliance  
1 Control lamp “Power”  
2 Heat level switch  
3 Thermostat  
Warning: To avoid an overheating of the  
oil radiator it may not be covered!  
4 Warm air switch with integrated  
warm air control lamp  
5 Warm air outlet  
6 Cold air intake  
7 Power cable retainer  
8 Mounting bracket  
9 Roller rails  
• Clean the appliance at regular intervals.  
• Do not use an external timing switch or a separate  
remote control system to operate the appliance.  
• Do not position the appliance underneath a  
mains power socket.  
Injury hazard  
• Lay the power cable in such a way that no one  
0 Wing nuts  
can tread on or trip over it.  
• Do not use extension cables. In an emergency  
the power plug must be quickly accessible.  
Assembly  
Use the fold-out page of these instructions to assist  
you with the assembly.  
Items supplied  
1. Take the oil radiator and all components from  
the package and remove all packaging materials.  
2. Place the oil radiator, with the base uppermost,  
on a soft surface, for example a carpet.  
3. Place a mounting bracket 8 under the heater  
element so that the parts with a screw thread  
project upwards.  
Oil Radiator  
2 Roller rails  
2 Mounting bracket  
4 Wing nuts  
Operating instructions  
4. Lay a roller railer 9 over it, such that the screw  
threads protrude through the holes. Check to  
ensure that the recesses on the roller railers 9  
face outwards. The screw ends projecting from  
the appliance must reach into the recesses.  
5. Screw one wing nut 0 onto each of the threaded  
ends of the mounting bracket 8 until it is hand  
tight.  
Technical data  
Rated voltage:  
Heat output:  
Heat level:  
220–240 V 50 Hz  
~
2300 - 2600 W  
I = 800 W  
II = 1200 W  
III = 2000 W  
Infinitely variable  
9
Thermostat:  
Heating gills:  
6. Proceed in the same manner with the other side.  
7. Turn the appliance over and place it on the rollers.  
- 3 -  
 
Commissioning  
5. If you wish to switch the appliance off, first place  
the warm air switch 4 at the position OFF. Next,  
turn the heat level switch 2 to “0” and then the  
thermostat 3 to MIN.  
1. Unwind all of the power cable from the power  
cable retainer 7.  
6. Remove the plug from the wall power socket.  
Note:  
Ensure that the thermostat 3 and the heat level  
switch 2 are standing at MIN resp. 0.  
Frost protection function  
2. Insert the power plug into a wall power socket.  
3. Place the heat level switch 2 at “III” and the  
thermostat 3 at MAX. The control lamp “Power”  
1 glows.  
You can programme this oil radiator so that, if the  
room temperature falls near to 0°C, it switches itself  
on and begins to radiate heat automatically:  
1. Insert the power plug into a wall socket.  
2. Position the heat level switch 2 at “I”, “II” or  
“III”, and the thermostat 3 at MIN.  
Important:  
With the heat level switch 2 you can regulate how  
quickly the appliance warms up. If you wish to heat  
it up particularly quickly, select heat level “III”, if a  
slow warming up is preferred, select heat level “I”.  
Using the thermostat 3 you can set it to the desired  
temperature.  
The oil radiator will now switch itself on if the tempe-  
rature falls near to 0°C. When the temperature rises  
above 0°C, the oil radiator switches itself off automati-  
cally. The oil radiator will switch on and off periodically  
to maintain the room temperature above 0°C.  
4. When the desired room temperature has been  
reached, slowly turn the thermostat 3 back until  
a quiet “click” is heard and the control lamp  
“Power” 1 extinguishes. The momentary room  
temperature will now be retained. It could be  
that every now and then the control lamp  
“Power” 1 switches itself on and then back off.  
This means that the programmed room tempera-  
ture had fallen below this level for a short period  
and the appliance had warmed itself back up.  
Cleaning and care  
Injury hazard  
Allow the appliance to cool down before cleaning  
it! Risk of Burns!  
Remove the power plug from the wall socket.  
There is a risk of electric shock!  
Clean the appliance with a lightly moist cloth. For  
stubborn soiling use a mild detergent on the cloth.  
Note:  
If you want to heat a room up particularly quickly,  
activate additionally the warm air switch 4.  
When the warm air switch 4 is positioned at ON,  
the warm air control lamp 4 glows and warm air is  
blown through the warm air outlet 5 into the room.  
Attention!  
Do not use any aggressive, abrasive or chemical  
cleaning agents. These could damage the surfaces.  
- 4 -  
 
Storage  
Warranty and Service  
If you do not intend to use the appliance for a long  
period, clean it as described in the section “Cleaning  
and care”.  
The warranty for this appliance is for 3 years from  
the date of purchase. The appliance has been ma-  
nufactured with care and meticulously examined be-  
fore delivery. Please retain your receipt as proof of  
purchase. In the event of a warranty claim, please  
make contact by telephone with our Service Depart-  
ment. Only in this way can a post-free despatch for  
your goods be assured.  
Wrap the power cable around the power cable  
retainer 7.  
Store the appliance at a clean and dry location.  
The warranty covers only claims for material and  
maufacturing defects, but not for transport damage,  
for wearing parts or for damage to fragile compo-  
nents, e.g. buttons or batteries. This product is for  
private use only and is not intended for commercial  
use. The warranty is void in the case of abusive and  
improper handling, use of force and internal tampe-  
ring not carried out by our authorized service  
branch. Your statutory rights are not restricted in  
any way by this warranty.  
The warranty period will not be extended by repairs  
made under warranty. This applies also to replaced  
and repaired parts. Any damage and defects extant  
on purchase must be reported immediately after un-  
packing the appliance, at the latest, two days after  
the purchase date. Repairs made after the expira-  
tion of the warranty period are subject to payment.  
Disposal  
Do not dispose of the appliance in your  
normal domestic waste. This product is  
subject to the European guideline  
2002/96/EC.  
Dispose of the appliance through an approved  
disposal centre or at your community waste facility.  
Observe the currently applicable regulations for  
waste oil disposal.  
In case of doubt, please contact your waste disposal  
centre.  
Note:  
The guidelines regarding the scrapping of the appli-  
ance must be strictly followed! Enquire at your local  
waste disposal facility.  
DES UK LTD  
Tel.: 0871 5000 700 (£ 0.10 / minute)  
Dispose of all packaging materials in an  
environmentally friendly manner.  
Kompernass Service Ireland  
Tel: 1850 930 412 (0,082 EUR/Min.)  
Standard call rates apply. Mobile operators may vary.  
- 5 -  
 
Importer  
KOMPERNASS GMBH  
BURGSTRASSE 21  
44867 BOCHUM, GERMANY  
- 6 -  
 

Sharp All in One Printer MX M232D User Manual
Sony Camcorder BMC 110 User Manual
Sony Computer Monitor CPD 520GS User Manual
Sony Ericsson Cell Phone Z320 User Manual
Sony MP3 Player D 193 User Manual
Sony Network Card FA ST1AM User Manual
Speed Queen Washer 801529 User Manual
Sterling Plumbing Outdoor Shower 71090116 User Manual
Swann DVR DVR4 2500 User Manual
T+A Elektroakustik Stereo Receiver K1 AV User Manual