To u se t h e re m o t e co n t ro l
The lever marked with =-^-+ is the
jog lever. When you press or slide the lever,
operation starts.
zOt h e r Op e ra t io n s
3-867-190-21 (1)
Pla yin g t ra cks in ra n d o m
o rd e r (Sh u ffle Pla y)
Usin g o t h e r fu n ct io n s
Pla yin g t ra cks re p e a t e d ly
(Re p e a t Pla y)
To m in im ize skip p in g (ESP2)
Playing a CD right
away!
The ESP (Electronic Shock Protection)
function minimize skipping by using a buffer
memory that stores music data and plays it
back in the event of a shock.
You can play the tracks in a CD in random
order.
You can play tracks repeatedly in normal,
INTRO PGM, shuffle or RMS (Random Music
Sensor) play modes. Repeat all the tracks or
only one track.
The new ESP2 (ESP Squared) system uses a
new DSP (Digital Signal Processor) which can
read and store music data more efficiently,
providing a level of continuous skip
protection not found in traditional buffer
memory units. This decreases the frequency
of sound skipping and the need to utilize the
buffer memory. Use this function when
listening in a car or while walking.*
Slide
Slide
^
If you want to play a CD right now, choose to use your player on house
current. Other choices are the following three: rechargeable batteries,
dry batteries (see “Power Sources” on the reverse side) and car battery.
Press
+
=
Co m p a ct Disc
Co m p a ct Pla ye r
P MODE
To
Do this
During play, press P MODE repeatedly until
“SHUF” appears.
The tracks play in random order.
Pause
Press the jog lever
* Although ESP2 provides excellent protection
against skipping, it will not prevent skipping
while jogging or running.
toward ^.
Resume play after
pause
Press the jog lever
toward ^.
1
P MODE RPT/ENT
Connect
Operating Instructions
To re p e a t a ll t h e t ra cks
Press RPT/ ENT (REPEAT/ ENTER on the
player) during play.
Find the beginning
of the current track
(AMS*)
Slide the jog lever
toward =
once.**
to a wall
Ab o u t a re a co d e
outlet
The area code of the player you purchased is shown on upper left of the bar
code label on the package.
For accessories supplied with your player, check the area code of your model
and refer to “Supplied accessories” toward the end of this manual.
The “
” indication appears.
To cancel shuffle play, press P MODE
repeatedly until the play mode indication
disappears from the display.
When using
earphones
Find the beginning
of previous tracks
(AMS)
Slide the jog lever
ESP
toward
=
Press ESP.
The ESP indication appears.
repeatedly.**
Note
• During shuffle play, you cannot return to
previous tracks by sliding the jog lever toward
= .
Find the beginning
of the next track
(AMS)
Slide the jog lever
toward +
once.**
AC power adaptor
To cancel repeat play, press RPT/ ENT again.
To re p e a t a sin g le t ra ck
1 Press RPT/ ENT while the track you want
to repeat is playing.
Find the beginning
of succeeding
tracks (AMS)
Slide the jog lever
toward
repeatedly.**
+
Pla yin g t ra cks in t h e o rd e r
yo u w a n t (RMS p la y)
To release the ESP function, press ESP again.
Earphones
The “
” indication appears.
Notes
Slide and hold the
jog lever toward
+.**
Go forward
quickly
• Playing may stop when the player gets a strong
shock even with the ESP function on.
• You may hear a noise or sound skip when:
— listening to a dirty or scratched CD,
— listening to an audio test CD or,
— the player receives continuous shock.
• Sound may drop for a while if you press ESP
during play.
You can program up to 22 tracks to play in
any order you choose.
^
Slide and hold the
jog lever toward
=.**
Go backwards
quickly
2 Press P (play) MODE (PLAY MODE on the
player) repeatedly until “1” appears.
+
=
p
DC IN 4.5 V
*AMS = Automatic Music Sensor
**These operations are possible during both
play and pause.
• When you use an optical digital connecting
cord, the ESP function will be disabled.
2/REMOTE
D-E525
Sony Corporation ©1999 Printed in Malaysia
To e n jo y m o re p o w e rfu l b a ss so u n d
(So u n d fu n ct io n )
You can enjoy a powerful bass-boosted sound.
If you press RPT/ ENT (REPEAT/ ENTER on
To repeat another track, slide the jog lever
toward = or + .
For models supplied w ith the AC plug adaptor
If the AC power adaptor does not fit the wall outlet, use the AC plug adaptor.
P MODE
RPT/ENT
the player) to display “
”, you can locate the
tracks continuously in the following order:
• When using +: next track n next track
...... last track n first track n second track
......
• When using =: previous track n previous
track ...... first track n last track ......
1
2
During play, press P MODE repeatedly
until “RMS*” flashes.
To cancel repeat play, press RPT/ ENT again.
For models supplied w ith the remote control
• Connect the plug of the earphones to the remote control.
• Connect the earphones to the remote control firmly. A loose connection may cause noise
during playback.
Flashing
Fo r t h e cu st o m e rs in t h e USA
We lco m e !
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
Pla yin g o n ly t h e t ra cks
yo u w a n t (INTRO PGM Pla y)
You can do the operations shown in the above
table using the buttons with the same marks
on the player.
SOUND
Thank you for purchasing the Sony
Compact Disc Compact Player.
Before operating your player, please
read this manual and retain it for
future reference.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/ TV
technician for help.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
Press SOUND to select “MB (Mega Bass)” or
“GRV (Groove).” “GRV” is more effective.
2
*RMS = Random Music Sensor
You can choose and play your favorite tracks
by scanning through the beginning of each
Place a CD
To re m o ve t h e CD
Remove the CD while
pressing the pivot.
Slide the jog lever toward = or + to
choose a track.
The track number and the playing order
appear.
Note
track in a CD.
^
• If the sound is distorted when emphasizing
bass, turn down the volume.
+
=
Ow n e r’s Re co rd
p
The model and the serial numbers are located at
the bottom. Record the serial number in the
space provided below. Refer to these whenever
you call upon your Sony dealer regarding this
product.
To lo ck t h e b u t t o n s
You can lock your player against any
accidental operations.
You can still operate the player with the
remote control.
Track number
Flashing
Notes on controlling the volume w ith the
remote control
Set the VOL (volume) control on the remote
control to the maximum. Then adjust the
volume on the player to the level that you
want to be the maximum volume of the remote
control.
D-E525
Serial No.________________________
RPT/ENT
P MODE
Playing order
1
During play, press P MODE repeatedly
until “INTRO PGM” flashes.
WARNING
3
4
Press RPT/ ENT to program the track.
Flashing
To p re ve n t fire o r sh o ck
h a za rd , d o n o t e xp o se
t h e u n it t o ra in o r
m o ist u re .
Repeat steps 2 and 3 to program the
remaining tracks.
Label side up
OPEN
Notes on display
• When you press ^ (when RESUME is set to
OFF), the total number of tracks in the CD
and the total playing time appear for about 2
seconds.
• During play, the track number and the
elapsed playing time of the current track
appear.
• During pause, the elapsed playing time
flashes in the display.
• Between tracks, the time to the beginning of
the next track will appear with the “–”
indication.
1Slide OPEN to open the lid.
2Fit the CD to the pivot.
5
Press the jog lever toward ^ .
“RMS” stops flashing and the tracks you
have chosen play in the order you
specified.
3Close the lid.
2
3
Press the jog lever toward ^ to start
scanning.
The player plays about the first 15
seconds of each track and “INTRO PGM”
flashes faster.
To a vo id e le ct rica l
sh o ck, d o n o t o p e n t h e
ca b in e t . Re fe r se rvicin g
t o q u a lifie d p e rso n n e l
o n ly.
Slide HOLD in the direction of the arrow.
When you press any button, “Hold” appears in
the display and you cannot operate the player.
If you press p, the program will be erased. To
prevent accidental erasure, set the RESUME
switch at the rear of the player to ON.
Fo r t h e cu st o m e rs in Au st ra lia
The supply cord of the AC power adaptor cannot
be replaced; if the cord is damaged, the AC
power adaptor should be discarded.
3
Play
Press RPT/ ENT while the track you want
is playing. To skip the track, slide the jog
lever toward + or just wait for the next
track.
To unlock, slide HOLD back.
To cancel RMS play, press P MODE until
“RMS” disappears from the display.
2 Adjust the volume.
Fo r t h e cu st o m e rs n o t in Eu ro p e
The CE mark on the unit is valid
only for products marketed in the
European Union.
To u se t h e p la ye r
Notes on handling CDs
• To keep the CD clean, handle it by its edge.
Do not touch the surface.
• Do not stick paper or tape onto the CD.
• Do not expose the CD to direct sunlight or
heat sources such as hot air ducts. Do not
leave the CD in a car parked under direct
sunlight.
CAUTION
To ch e ck t h e p ro g ra m
During programming:
Press RPT/ ENT before step 5.
During RMS play:
Press P MODE repeatedly until “RMS”
flashes, then press RPT/ ENT.
Each time you press RPT/ ENT, the track
number and the playing order appear in the
order you specified.
The use of optical instruments with this product
will increase eye hazard.
After you have gone through the CD,
“INTRO PGM” stops flashing and the tracks
you have chosen play automatically.
Continue to the reverse side m
1 Press ^.
To finish programming before going through
the whole CD, press the jog lever toward ^.
The selected tracks will be played.
1 Press the jog
lever toward
^.
If you press p, the program will be erased.
To prevent accidental erasure, set the
RESUME switch at the rear of the player to
ON.
2 Adjust the volume.
Note
• If you program another track after the 22nd
track, the first track programed is cleared and
the new track is programed instead.
Not these ways
To cancel INTRO PGM play, press P MODE
repeatedly until the play mode indication
disappears from the display.
To stop play, press p.
|