Sony Speaker System SS B1000 User Manual

English  
Connections  
Specifications  
Speaker System  
• Before connecting, turn off the amplifier or receiver to  
avoid damaging the speaker system.  
• This speaker system is driven best by an amplifier or  
receiver rated as per the wattage indicated in the  
specification section.  
A low-powered amplifier or receiver could result in  
signal clipping, which could result in tweeter burn-out.  
Therefore, it is recommended to use an amplifier or  
receiver with sufficient power rating.  
SS-B3000  
Speaker system  
Speaker units  
3-way, magnetically shielded  
Woofer: 20 cm (8 in.) , cone type  
Midrange: 8 cm (3 1/4 in.), cone type  
Tweeter: 2.5 cm (1 in.) , balanced dome  
type  
Bass reflex  
8 ohms  
SS-B3000/B1000  
2-899-024-11(2)  
Enclosure type  
Rated impedance  
Power handling capacity  
Maximum input power: 120 watts  
Note  
Avoid driving the speaker system continuously with a  
wattage exceeding the maximum input power of each  
speaker.  
Sensitivity level  
Frequency range  
Dimensions (w/h/d) Approx. 240 × 530 × 263 mm  
(9 1/2 × 20 7/8 × 10 3/8 in.) including  
front grille  
88 dB (1 W, 1 m)  
50 Hz - 50,000 Hz  
(2)  
Owner’s Record  
The model and serial numbers are located on the rear of the unit. Record the  
serial number in the space provided below. Refer to them whenever you call  
upon your Sony dealer regarding this product.  
Precautions  
Mass  
Supplied accessory  
Approx. 6.5 kg (14 lb 6 oz)  
Speaker cord (2)  
• Do not attempt to open the enclosure or remove  
speaker units. There are no user-serviceable parts  
inside.  
• Keep recorded tapes, watches, and personal credit  
cards using magnetic coding away from the speaker  
system.  
• Periodically wipe the cabinet with a soft cloth. Do not  
use any type of scouring powder, abrasive pad or  
solvent.  
Model No.  
Serial No.  
SS-B1000  
Speaker system  
Speaker units  
2-way, magnetically shielded  
Woofer: 13 cm (5 1/8 in.) , cone type  
Tweeter: 2.5 cm (1 in.) , balanced dome  
type  
Bass reflex  
8 ohms  
Standard Connection  
Enclosure type  
Rated impedance  
• Be sure to install the grill net in the correct direction.  
Power handling capacity  
Maximum input power: 120 watts  
Speaker Placement  
Sensitivity level  
Frequency range  
87 dB (1 W, 1 m)  
80 Hz - 50,000 Hz  
Please note that room acoustics can often produce large  
difference in the sound for small changes in speaker  
placement.  
Dimensions (w/h/d) Approx. 170 × 255 × 186 mm  
(6 3/4 × 10 × 7 3/8 in.) including front  
grille  
• Set up your speaker system on a hard, flat place.  
• Place the speaker system against a hard wall with its  
back about 10 cm (4 in.) away from a wall. The  
proportion of bass increases as you move a speaker  
close to intersecting room surfaces (wall and wall, etc.).  
• Place the right and left speakers in a similar acoustic  
environment.  
+
Mass  
Supplied accessory  
Approx. 2.9 kg (6 lb 7 oz)  
Speaker cord (2)  
Design and specifications are subject to change without  
notice.  
Right  
Left  
• It is recommended that the speaker/listener  
relationship be an equilateral triangle.  
Amplifier  
SPEAKER  
2007 Sony Corporation Printed in Malaysia  
 

Shark Vacuum Cleaner V1917 User Manual
Sharp Microwave Oven R 90GC User Manual
Sharp Typewriter PW E550 User Manual
Soleus Air Air Conditioner PH 3 12R 03 User Manual
Sony Cassette Player M 729V User Manual
Sony Cell Phone Accessories C6833 User Manual
Sony Digital Photo Frame 4 262 215 12 1 User Manual
Sony Outboard Motor GDM C250K User Manual
Spirit Elliptical Trainer XE400 User Manual
Tanita Scale 2000 User Manual